ページ1に含まれる内容の要旨
PLASMA TV
OWNER’S MANUAL
Please read this manual carefully before operating your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the back cover and quote this infor-
mation to your dealer when you require service.
Model number :
Serial number :
P/NO : 3828VA0565M (MF056B, 141K TX)
ページ2に含まれる内容の要旨
Safety Warnings Safety Instructions Safety Instructions W WARNING Do not place the set in direct sunlight or near heat Do not use water while cleaning the set. sources such as heat registers, stove and so on. - This may cause damaged the set or could give an electric shock. - This may cause a fire. In case of smoke or strange smell from the set, switch Do not use the set in damp place such as a bathroom it off ,unplug it from the wall outlet and contact your or any place where it is likely to ge
ページ3に含まれる内容の要旨
Safety Warnings Safety instructions have two kinds of information, and each meaning of it is as below. * The violation of this instruction may cause serious injuries and even death. WARNING The violation of this instruction may cause light injuries or damage of the NOTES product. Take care of danger that may happen under specific condition. NOTES Never touch the power plug with a wet hand. Ensure the power cord doesn’t trail across any hot - This may cause an electric shock. objects like a heate
ページ4に含まれる内容の要旨
Contents Contents Contents Setting the On/Off Timer . . . . . . . . . . . . . . . . . . .18 Safety Warnings Auto Sleep . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . .2~3 Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18 Introduction Special Menu Options Remote Control Key Functions . . . . . . . . . . . . . . . .5 Child Lock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 Location
ページ5に含まれる内容の要旨
PIP PR - EXIT VCR STB PIP PR + MARK Introduction Remote Control Key Functions Remote Control Key Functions - When using the remote control aim it at the remote control sensor of the set. - There maybe a defect in consecutive operation of remote control in a specified brightness according to this set. INPUT POWER Selects the TV, AV1, AV2, S-Video, AV3, AV4, switches the set on from standby or off to AV5, Component, RGB or HDMI modes. standby. switches the set on from standby. MULTIMEDIA INPUT MUL
ページ6に含まれる内容の要旨
Introduction Location and Function of Controls Location and Function of Controls - Shown is a simplified representation of the set. - Here shown may be somewhat different from your set. 10 7 8 9 INPUT MENU OK VOL PR 2 3 4 5 6 1 1. Remote Control Sensor 6. D D / E E (Programme Up/Down) Selects a programme or a menu item. 2. Power Button Switches the set on from standby. Switches the set on from standby or off to standby. F F / G G (Volume Up/Down) Adjusts the volume. 3. INP
ページ7に含まれる内容の要旨
Introduction Location and Function of Controls Location and Function of Controls A AV V5 5 S-VIDEO 9 V VIID DE EO O A AU UD DIIO O AC INPUT A AV V1 1 L R HDMI/ A AU UD DIIO O Antenna C CO OM MP PO ON NE EN NT T AUDIO INPUT RGB INPUT DVI(VIDEO) L R A AV V2 2 V VA AR RIIA AB BL LE E A AU UD DIIO O O OU UT T REMOTE RS-232C INPUT CONTROL (CONTROL/SERVICE) A AV V4 4 A AV V3 3 L R ( (M MO ON NO O) ) S S- -V VIID DE EO O V VIID DE EO O A AU UD DIIO O 2 3 4 5 6 7 8 1 1. HDM
ページ8に含まれる内容の要旨
Installation External Equipment Viewing Setups External Equipment Viewing Setups V VIID DE EO O A AU UD DIIO O A AV V1 1 L R Antenna HDMI/ C CO OM MP PO ON NE EN NT T A AU UD DIIO O AUDIO INPUT RGB INPUT DVI(VIDEO) L R A AV V2 2 V VA AR RIIA AB BL LE E A AU UD DIIO O O OU UT T REMOTE RS-232C INPUT CONTROL (CONTROL/SERVICE) A AV V4 4 A AV V3 3 L R ( (M MO ON NO O) ) S S- -V VIID DE EO O V VIID DE EO O A AU UD DIIO O A AV V1 1 Connection to PC Connection to AV equipm
ページ9に含まれる内容の要旨
Installation Displayable Monitor Specification Displayable Monitor Specification RGB / HDMI mode 42PX4R / 42PX5R Series 50PX4R / 50PX5R Series Horizontal Vertical Horizontal Vertical Resolution Resolution Frequency(KHz) Frequency(Hz) Frequency(KHz) Frequency(Hz) 31.468 70.09 31.468 70.09 640x350 640x350 37.861 85.08 37.861 85.08 31.469 70.08 31.469 70.08 720x400 720x400 37.927 85.03 37.927 85.03 31.469 59.94 31.469 59.94 35.000 66.66 35.000 66.66 640x480 640x480 37.861 72.80 37.861 72.80 37.500
ページ10に含まれる内容の要旨
Installation TM - HDMI , the HDMI logo and High-Definition Multimedia - In this case, use another cable for audio. When PC (or Interface are trademarks or registered trademarks of HDMI sound card of PC) have Analog Audio Output Connector, Licensing. RGB/DVI Audio Input of the set connect to Analog Audio - This set can receive the High-Definition Multimedia Interface Cable (not supplied with the product). And then you can lis- (HDMI) or Input of Digital Visual Interface(DVI). ten to normal Audio.
ページ11に含まれる内容の要旨
42 50 40 Installation Accessories Accessories T V / A V M U L T I M E D I A P O W E R T V D V D V C R M O D E A U D I O C A B L E S T B Z O O M - Z O O M + M P I P U T E S L E E P L I S T T E X T / * I / I I A R C M E N U E X I T O K P I T P P R - P I P P R + S W A P P I P I N P U V O L S S M P S M P R F A V O U R I T E Q . V I E W S I Z E P O S I T I O N I N D E X H O L D T I M E R E V E A L M I X M O D E ? M Owner’s Manual Remote Control handset 2-Eye Bolts 1.5V Alkaline batteries Power Cord 2
ページ12に含まれる内容の要旨
Installation Installation Options Installation Options • The set can be installed in different ways such as on a wall, or on a desktop etc. • Install this set only in a location where adequate ventilation is available. Wall Mount: Horizontal Installation Desktop Pedestal Installation • The set can be installed on a wall as shown above. • The set can be mounted on a desk as shown above. (For further information, refer to the optional ‘Wall Mounting Bracket Installation and Setup Guide’.) To Mount
ページ13に含まれる内容の要旨
Operation Turning on the Set Turning on the Set - When using the remote control, aim it at its sensor on the set. Turning on the set just after installation 1. Connect power cord correctly, the set is switched to standby mode. 2. Press the r r / I, INPUT or PR button on the set or press the POWER, INPUT, MULTIMEDIA, PR or D D / E E D D / E E NUMBER buttons on the remote control and then the set will switch on. Turning on the set (power cord is still connected) If the set was turned off with the
ページ14に含まれる内容の要旨
Operation On screen menus On screen menus - The dialogue between you and your set takes place on screen with an operator menu. The buttons required for the operating steps are also displayed. Menu selection 1. Press the MENU button and then D D / E E button to display each menu. 2. Press the G G button and then the F F / G G button to select a menu item. 3. Repeatedly press the MENU button to return to normal TV viewing. STATION System STATION Auto programme Auto programme G G BG PSM CSM G G M
ページ15に含まれる内容の要旨
Operation Channel Menu Options Channel Menu Options Auto Programme Tuning 3. Press the G G button to select Storage. Select the desired pro- gramme number with the F F / G G button or NUMBER buttons on - All stations that can be received are stored by this method. It the Storage menu. is recommended that you use auto programme during instal- 4. Press the E E button to select System. Select a TV system with lation of this set. the F F / G G button; 1. Press the MENU button and then use button
ページ16に含まれる内容の要旨
Operation Channel Menu Options Channel Menu Options Moving a programme Assigning a Station Name 1. Select a programme to be moved with the or F F / G G but- D D / E E 1. Repeat the ‘Manual programme tuning’ steps 1 to 2. ton. 2. Press the YELLOW button. 2. Press the G G button and then button to select Name. D D / E E 3. Move the programme to the desired programme number with 3. Press the G G button to display the Name menu. the or F F / G G button. D D / E E STATION Auto programme Storage
ページ17に含まれる内容の要旨
Operation Picture Menu Options Picture Menu Options PSM (Picture Status Memory) Manual Colour Temperature Control - This function adjusts the set to the best picture appearance. - You can adjust red, green, or blue to any colour temperature - When adjusting picture options (contrast, brightness, colour, you prefer. sharpness and tint (NTSC input only)) manually, PSM is automatically changed to User. - You can enjoy the vivid and hi-definition picture with LG’s 1. Press the PSM button Excellent D
ページ18に含まれる内容の要旨
Operation Sound Menu Options Sound Menu Options TV Speaker • DUAL I + II sends a separate language to each loudspeaker. - You can adjust the internal speaker status. NICAM Reception (option) - In COMPONENT RGB[PC] and HDMI[PC] mode, TV speaker - If your Plasma Display is equipped with the PDP Tuner for and/or variable audio can be outputted even though there is NICAM reception, the high quality NICAM (Near no video signal. Instantaneous Companding Audio Multiplex) digital sound - If you want to
ページ19に含まれる内容の要旨
Operation Special Menu Options Special Menu Options Child Lock • White Wash : White Wash removes permanent images from the screen. - The set can be set up so that it can only be used with the Note: An excessive permanent image may be impossible to remote control. clear entirely with White Wash. - This set is programmed to remember which option it was last • Orbiter : set to even if you turn the set off. Orbiter may help prevent ghost images. However, it is best - In Child lock ‘On’, if the se
ページ20に含まれる内容の要旨
Operation Screen Menu Options Screen Menu Options Setting the Picture Format - You can only select Spectacle, Full (Option), 4:3, 16:9 (Wide), 14:9 and Zoom in Component [480i/576i] mode only. - You can watch the screen in various picture formats; Spectacle, - There might be uncomfortable in full mode. Then change into Full (option), Original, 4:3, 16:9 (Wide), 14:9 and Zoom. other mode. • Spectacle When your TV receives the wide screen signal, when select- Picture Size Zoom ed it will adjust th
