ページ1に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 13
INSTRUCTION MANUAL
Catalog Number BB7B
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
BEFORE YOU CALL, HAVE THE CATALOG No, AND DATE CODE
AVAILABLE. IN MOST CASES, A BLACK & DECKER REPRESENTATIVE
CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A
SUGGESTION OR COMMENT, GIVE US A CALL. YOUR FEEDBACK IS
VITAL TO B
ページ2に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 1 GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR • CHECK DAMAGED PARTS. Before further use of the tool, a guard or other ALL APPLIANCES part that is damaged should be carefully checked to determine that it will READ ALL INSTRUCTIONS operate properly and perform its intended function. Check for alignment of WARNING: Read all instructions before operating product. Failure to moving parts, binding of moving parts, breakage of parts, mounting, and follow
ページ3に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 3 CAUTION: Used without the safety alert symbol indicates potentially • Use of an attachment not supplied, recommended or sold by manufacturer hazardous situation which, if not avoided, may result in property damage. specifically for use with this unit may result in a risk of electrical shock and RISK OF UNSAFE OPERATION. When using tools or equipment, basic injury to persons. safety precautions should always be followed to reduce the risk of person
ページ4に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 5 • Never smoke or allow a spark or flame in vicinity of vehicle battery, Controls and Indicators engine or battery booster. • Remove personal metal items such as rings, bracelets, necklaces and VEHICLE CHARGING CORD watches when working with a lead acid battery. A lead acid battery can STORAGE COMPARTMENT produce a short circuit current high enough to weld a ring, or the like of a metal, causing a severe burn. • Read and understand this instruction
ページ5に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 7 5. When the Vehicle Boost LED Indicator stops flashing and lights green USING THE LED AREA LIGHT steadily and the unit beeps continuously, (generally, after approximately The LED Area Light is controlled by the Area Light ON/OFF Push button on the 15 minutes), the vehicle battery has been boosted. Turn the vehicle top panel of the unit (see page 6). Make sure the LED Area Light is turned OFF ignition and crank the engine in 5-6 second bursts until
ページ6に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 9 2. Remove the 12 Volt DC Vehicle Charging Cord from its storage TROUBLESHOOTING GUIDE compartment and plug it into the vehicle’s 12 volt DC accessory outlet. Problem Possible cause Solution 3. Press the Recharge Unit Push button. The unit will beep once again and the UNIT WILL NOT • FUSE IN DC PLUG IS OPEN • REPLACE DC PLUG FUSE. SEE FUSE RECHARGE REPLACEMENT INSTRUCTIONS Battery Status LED Indicator will flash green, indicating the unit is chargi
ページ7に含まれる内容の要旨
BB7B_Manual EN_082406 8/24/06 10:14 AM Page 11 For assistance with your product, visit our website SPECIFICATIONS www.blackanddecker.com for the location of the service center nearest Battery Type: Three sealed, high energy density, AGM, you or call the BLACK & DECKER help line at 1-800-544-6986. lead-acid, rechargeable, maintenance-free DC batteries Accessories Recommended accessories for use with your tool are available from your Area Light: Light Emitting Diode (LED) local dealer or autho
