ページ1に含まれる内容の要旨
Owner's Guide
Model LE40H405
40” Class (40.00” Diagonal)
Thank you for purchasing this Hitachi product. Please read these instructions carefully.
For additional assistance please call 1-888-333-1899(U.S.A. or Puerto Rico), or 01-800-700-4321(Mexico)
or visit our website at www.hitachi.us/tv.
Keep this owner’s guide for future reference.
Record the model number and serial number of your LCD Television for future reference.
This information is located on the back of the television.
MODEL NUMBER
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
This product contains lead. Dispose of this product in accordance with applicable environmental laws. For product recycling and disposal information, contact your local government agency or www.eRecycle.org (in California), the Electronic Industries Alliance at www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada). For more information, call 1-888-333-1899.
ページ5に含まれる内容の要旨
ページ6に含まれる内容の要旨
SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space around the entire unit. 4 inches 4 inches Notes when mounting the LCD TV on a wall If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV for advice, and have the equipment pr
ページ7に含まれる内容の要旨
The figure below is just for reference,please see the real set. Type A Insert the bracket to the base,and fix them with 6 screws. Put the TV set on the level table on which there is a pad cloth or other soft material. Lay down the TV set and make sure the LCD screen is downward. Then fix the base to the set with 4 screws. Type B pedestal 4 screws WARNING: The length of Base Screws must be between 10mm and 12mm,otherwise the TV would be damaged. When you transport this product, remove the stand a
ページ8に含まれる内容の要旨
40
ページ9に含まれる内容の要旨
Limited Warranty End User License Agreement
ページ10に含まれる内容の要旨
MENU INPUT VOL VOL CH CH POWER RGB RGB/DVI SERVICE HDMI 2/DVI HDMI 4 HDMI 3 RGB AUDIO AV COMPONENT DIGITAL AIR/CABLE AUDIO OUT HDMI 1 VIDEO L R Y PB PR L R COAXIAL
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable) Connect the 75 ohm cable from the combination VHF/UHF antenna to the antenna jack. Antenna Jack 75 ohm Coaxial Cable Cable TV connections This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. S
ページ13に含まれる内容の要旨
Starting setup TO SELECT DIGITAL CHANNELS – button followed by the remaining number. will assist you to specify the Air/Cable setting and program Example, to select channel 15-1, press 1, 5, –, 1, then press your channels automatically. SELECT. • If a channel is selected with only audio content, “Audio IMPORTANT: Make sure that the antenna or cable TV system only” will be displayed on the screen. connection is made. • If a channel is selected with a weak digital signal, “Weak Signal or No
ページ14に含まれる内容の要旨
EXIT EXIT EXIT EXIT
ページ15に含まれる内容の要旨
Aspect Ratio EXIT EXIT EXIT EXIT
ページ16に含まれる内容の要旨
RGB ( "PC Standby" being only available in RGB input.)
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
To connect a HDMI or a DVI device to the unit The HDMI/DVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI device. When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are required. Back of the unit To DVI output RGB/DVI AUDIO Input Audio cord (not supplied) DVI device HDMI - to - DVI adapter cable (HDMI type A connector) (not supplied) To HDMI/DVI IN HDM
