ページ1に含まれる内容の要旨
L32BD304
LCD HDTV with Built-in BD Player
1-800-289-0981
®
00_54L0621A.indb 1 00_54L0621A.indb 1 10.4.27 3:14:29 PM 10.4.27 3:14:29 PM
ESPAÑOL ENGLISH
ページ2に含まれる内容の要旨
ENGLISH The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. C AUTION: TO REDUCE THE RISK OF ELECTRIC The exclamation point within an equilateral triangle is intended SHOCK, DO NOT REMOVE COVER to alert the user to the presence of important operating (OR BACK). NO USER-SERVICEABLE and
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the po
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS (continued) 25) Do not allow the product to output distorted sound for an extended period of time. It may cause speaker overheating. 26) When you use the headphones, keep the volume at a moderate level. If you use the headphones continuously with high volume sound, it may cause hearing damage. 27) Do not look into the opening of the disc slot or ventilation opening of the product to see the source of the laser beam. It may cause eye damage. 28) Do not use a cracke
ページ5に含まれる内容の要旨
CHILD SAFETY NOTICE 5 00_54L0621A.indb 5 00_54L0621A.indb 5 1 10.4.27 3:14:46 PM 0.4.27 3:14:46 PM ENGLISH
ページ6に含まれる内容の要旨
SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space around the entire unit. 4 inches 4 inches Notes when mounting the LCD TV/BD on a wall If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV/BD for advice, and have the equip
ページ7に含まれる内容の要旨
Disc Playable discs CAUTION: • Only the left types of discs can be played on this unit. DVD- Disc type and logo mark content ROM, DVD-RAM, DVD-Audio, SACD, CD-ROM, SVCD, CVD, Audio VCD, etc. cannot be played. Blu-ray Video + • 8cm discs can be played directly. If an 8cm disc adapter is used Video it will cause errors. • If you insert an irregular shaped disc, it may get stuck and cause a malfunction. Audio • The use of a ring protector or other disc accessories will cause DVD Video + errors.
ページ8に含まれる内容の要旨
Features LCD color TV With BD/DVD/CD player Unique space saving design combines a 32” class LCD color TV and a BD/DVD/CD player. A BD has much more capacity, but is the same size as a DVD. The Picture/Audio quality of a BD is very good. The audio quality is higher than an audio CD. The BD/DVD also has special options; audio language selection, subtitle language selection, or multi-angle, etc. The BD/DVD PLAYER can play back both audio CDs and MP3/WMA/JPEG CDs. Personalized Radio You’ll Love W
ページ9に含まれる内容の要旨
Contents Before using your unit BD operation Using the Blu-ray Disc player ...........................................23 IMPORTANT SAFETY INSTRUCTIONS ............................3 Status display of disc .......................................................24 CHILD SAFETY NOTICE ...................................................5 Repeat playback ................................................................. 24 SAFETY PRECAUTIONS ..................................................6 Changing
ページ10に含まれる内容の要旨
How to attach the stand 4 Secure the bottom plate with the four provided silver screws Installing the stand (M6×10mm) Tips • Unplug the AC cord from the AC INPUT jack. • Before beginning this process, make sure that you lay the unit on a clean, safe, and cushioned surface to avoid any damage to the unit. • Do not touch or press the TV screen. The glass might break under pressure. To install the stand: 1 Place the unit face down on table, aligning the bottom of the unit with the edge of the
ページ11に含まれる内容の要旨
Location of controls Front Left Side EJECT button VOLUME +/– buttons DISC slot CHANNEL /1 (PLAY) button CHANNEL /3 (STOP) button MENU button INPUT/ENTER button POWER button Remote sensor To display the menu screen. POWER indicator Press the MENU button to display the menu screen. Red : Standby CHANNEL / buttons, VOLUME +/– buttons and Blue : On INPUT/ENTER button can be used to select the Rear desired setting during the menu screen operations. USB jack ETHERNET jack PC MONITOR IN jack AC INP
ページ12に含まれる内容の要旨
Remote control Power On/Off POWER DISPLAY/– Display TV information Display DVD information Input “–” for digital channels TV/BD Switch between TV/AV and Blu-ray EJECT Eject a disc 0-9 Direct channel selection of TV Input setting Enter a password INPUT Display source selection menu MUTE Switch off the sound CH / Select channel of TV VOL +/– Adjust volume of TV MENU Display menu of TV STREAMING Shortcut for Network applications ▲▼◀▶ Cursor buttons ENTER Enter information in the menu EXIT Exit f
ページ13に含まれる内容の要旨
Remote control (continued) Inserting Batteries Open the battery compartment cover in Install two “AA” batteries, paying Replace the compartment cover. 1 2 3 the direction of the arrow. attention to the polarity diagram in the battery compartment. Operation • Aim the remote control at the remote sensor and press control buttons to operate. Approximately 15 feet • Operate the remote control within a 30° angle on either side of the remote sensor, up to a distance of approximately 15 feet. NOTE:
ページ14に含まれる内容の要旨
Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see page 15 for Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) Connect the 75 ohm cable from the combination VHF/UHF antenna to the antenna jack. Antenna Antenna Jack Jack If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the use of the 300-75 ohm matching
ページ15に含まれる内容の要旨
Cable TV connections This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company. For subscribers to basic Cable TV service For basic Cable TV service not requiring a Converter/Descrambler box, connect the 75 ohm Coaxial Cable d
ページ16に含まれる内容の要旨
TO SELECT ANALOG CHANNELS Starting setup 1-9: Press 1-9 as needed. Example, to select channel 2, press 2, then press ENTER. The Starting Setup menu appears the first time you turn on 10-99: Press the 2 digits in order. Example, to select the TV. It will assist you to specify the Air/Cable setting and channel 12, press 1, 2, then press ENTER. program your channels automatically. 100-135: Press the 3 digits in order. Example, to select channel 120, press 1, 2, 0, then press ENTER. IMPORTANT:
ページ17に含まれる内容の要旨
DISPLAY Quick guide for menu Press DISPLAY to display the current information on the screen. When the TV receives a digital signal, the digital information will operation appear. Example: Select Language. Sleep Timer 62-1 HDTV Moving Picture1 Off CH-1 Digital Air English Press INPUT to select TV mode. 1 No Program Information is available Press MENU. The TV menu screen will appear. 2 Main Menu Video >> Full 1080i Audio Channel Locks • Channel number • Station name Setup • Channel label (
ページ18に含まれる内容の要旨
Convenience functions You can change the default settings to your preferred settings. Icon Selected Items Setup hint Video Picture Brightness / Contrast You can adjust the picture quality to your preference. Setting / Sharpness / Color / Tint Color Temperature Bluish (Cool) / Neutral (Standard) / Reddish (Warm) 3 Backlight * The Backlight feature adjusts the screen brightness for improved picture clarity. Picture Mode Dynamic Bright and dynamic picture (factory-set) Standard Standard picture qu
ページ19に含まれる内容の要旨
Adding Channel Memorizing channels If you find a new unregistered digital channel, you can add the new channel into the channel memory. This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set Tune in the new channel. 1 into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s Select “Channel”, then press ▶ or ENTER. 2 memory. To use this TV with an antenna, set the Source option
ページ20に含まれる内容の要旨
Repeat steps 3-4 for other channel. You can assign a label to Checking the digital-signal 5 each channel. strength When you finish inputting the label name, press EXIT to return 6 to the normal screen. This TV will allow you to view the digital signal meter for To clear a Channel Label digital channels. After step 3 above, press ▲ or ▼ to select “Label Clear”, then press ▶ or ENTER. 1 Select “Channel”, then press ▶ or ENTER. NOTE: Press ▲ or ▼ to select “Signal Meter”. 2 • The channel labe
