Garmin 140の取扱説明書

ページ1に含まれる内容の要旨

FISHFINDER 140 FLUSH MOUNT INSTRUCTIONS
Flush Mount Pocket: Mounting Hardware:
Mounts to the bulkhead and A—Foam rubber pads (4)
A
retains the unit.
B—M4 x 40 mm hex head screws (4)
C—M4 hex nuts (4)
E
B
D—Reusable cable tie (1)
E—Metal retaining brackets (2)
C
D
Tool List (Not Included):
• Jig saw • Drill and 3/8" (10 mm) drill bit
• 7 mm wrench or socket • Thread locking compound
• Masking tape • Safety glasses and dust mask
• Phillips screwdriver
Read these instructions thoroughly, and make s

ページ2に含まれる内容の要旨

Installing or Removing the Fishfinder 1. Connect the wiring harness to the back of the Fishfinder. Make sure the locking ring is fully tightened. 2. Slide the Fishfinder into the pocket (Figure 3). It might be necessary to apply some pressure when inserting the assembly into the pocket to compress the foam rubber pads. When the Fishfinder is fully inserted, the lock tabs click into place (Figure 4). 3. To remove the unit from the pocket, press the lock tabs toward the unit while sliding the uni

ページ3に含まれる内容の要旨

Fishfinder 140 Flush Mount Template ����������������������� � � ������������������� � �� ���� �� ������������ ��� ������������������������� ��������������������������������� ������������������ � ��� ��������������� ���������������� ���������� ������ �� ������� ���������� ������ ����������������������� � � � ������������������������ � Garmin Ltd. or its subsidiaries Part Number 190-00583-02 Rev. A. Printed in Taiwan