ページ1に含まれる内容の要旨
MODEL
UX-S10
FACSIMILE
OPERATION MANUAL
1. Installation
2. SMS Text Messaging
3. Using the Answering Machine
4. Sending Faxes
5. Receiving Faxes
6. Making Copies
7. Special Functions
8. Printing Lists
9. Maintenance
10. Troubleshooting
ページ2に含まれる内容の要旨
CAUTION: For a complete electrical disconnection pull out the mains plug. VORSICHT: Zur vollständigen elektrischen Trennung vom Netz den Netzstecker ziehen. ATTENTION: Pour obtenir une mise hors-circuit totale, débrancher la prise de courant secteur. AVISO: Para una desconexión eléctrica completa, desenchufar el enchufe del tomacorriente. VARNING: För att helt koppla från strömmen, dra ut stickproppen. ATTENZIONE: Per un totale scollegamento elettrico rimuovere la spina di corrente.
ページ3に含まれる内容の要旨
Introduction Welcome, and thank you for choosing a Sharp fax machine! The features and specifications of your new Sharp fax are shown below. This Sharp fax supports SMS messaging. To use this feature, see page 27. Automatic dialling 60 numbers Imaging film Initial starter roll (included with machine): 10 m (approx. 30 A4 pages) Replacement roll (not included): UX-6CR 50 m (one roll yields approx. 150 A4 pages) Memory size* 448 KB (approx. 24 average pages with no voice messages recorde
ページ4に含まれる内容の要旨
Display LCD display, 16 digits x 2 lines Intended use Analog public switched telephone network (CTR21) / PBX Compatibility ITU-T (CCITT) G3 mode Input document size Automatic feeding: Width: 148 to 210 mm Length: 140 to 297 mm Manual feeding: Width: 148 to 210 mm Length: 140 to 600 mm Effective scanning width 210 mm max. Effective printing width 204 mm max. Contrast control Automatic/Dark selectable Reception modes TEL/FAX,TEL, FAX, A.M. Copy function Single / Multi (99 copies/page) Tel
ページ5に含まれる内容の要旨
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Important safety information Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. D
ページ6に含まれる内容の要旨
Table of Contents A Look at the Operation Panel 6 1. Installation 9 Unpacking Checklist. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Loading the Imaging Film . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Loading Printing Paper. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Entering Your Name and Fax Number . .
ページ7に含まれる内容の要旨
Table of Contents 5. Receiving Faxes 75 Using TEL/FAX Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Using A.M. Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76 Using FAX Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77 Using TEL Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78 Auto-Cordless Fax Control (answering with an extension phone in TE
ページ8に含まれる内容の要旨
A Look at the Operation Panel 1 2 3 4 5 6 7 8 9 ABC DEF AUFLÖS./ EMPFANG 1 2 3 GHI JKL MNO STOP R ! TEL FAX TEL/FAX 4 5 6 AUFN. PQRS TUV WXYZ KOPIE/HILFE/ABRUF WDG. 7 8 9 ZA START/SPEICHER SMS FUNKTION 0 LÖSCHEN ZURÜCK VOR 10 11 12 13 14 15 16 17 18 1 key Press this key to listen to the line and fax tones through the speaker when faxing a document. This key also functions as a delete key when composing an SMS message. RESOLUTION / RECEPTION MODE key 2 When a document is in the feeder,
ページ9に含まれる内容の要旨
UP and DOWN arrow keys 7 Enlarge/reduce setting: When making a copy of a document, press these keys to select an enlarge/reduce setting. Volume setting: When a document is not in the feeder, press these keys to change the speaker volume when the key has been pressed, or the ringer volume at any other time. FUNCTION key settings: Press these keys after pressing the FUNCTION key to scroll through the FUNCTION MODE settings. 8 Number keys Use these keys to dial numbers, and enter numbe
ページ10に含まれる内容の要旨
FUNCTION key 15 Press this key followed by the arrow keys to select special functions and settings. REPEAT key 16 Press this key while listening to a message to play it again. SKIP key 17 Press this key while listening to a message to skip to the next message. DELETE key 18 Press this key to erase recorded messages. Envelope symbol: 01-AUG 12:00 This lights during reception of an TEL SMS message. Exclamation point: 01-AUG 12:00 This lights when the inbox is full. TEL When checking t
ページ11に含まれる内容の要旨
1. Installation Unpacking Checklist Before setting up, make sure you have all of the following items. ♦ If any are missing, contact your dealer or retailer. Operation Gears (2) Paper tray Paper tray manual extension Telephone Imaging film Handset Handset cord line cord (initial starter roll) Points to keep in mind when setting up Do not place the Do not place the Keep dust away from Keep the area machine in direct machine near the machine. around the sunlight. heaters or air machine c
ページ12に含まれる内容の要旨
Connections Connections Connecting the handset Connect the handset as shown and place it on the handset rest. ♦ The ends of the handset cord are identical, so they will go into either socket. Make sure the handset cord goes into the socket marked with a handset symbol on the side of the machine! Use the handset to make ordinary phone calls, or to transmit and receive faxes manually. Connecting the power cord Plug the power cord into a 220 - 230 V, 50 Hz, earthed (2-prong) AC outlet.
ページ13に含まれる内容の要旨
TEL.SET TEL.LINE N FN Connections Connecting the telephone line cord Insert one end of the line cord into the socket on the back of the machine marked TEL. LINE. Insert the other end into a wall telephone socket. ♦ Note: In Germany, the machine is supplied with a N-coded line cable, enabling you to use an extension (cordless) telephone on the same line. If you don't have the standard NFN-outlet of TELEKOM, you can purchase an NFN- adapter at your retailer. ♦ Note: If your area experie
ページ14に含まれる内容の要旨
Connections Attach the paper tray and paper tray extension Attach the paper tray and paper tray extension. Click! Insert horizontally and rotate up Note: The paper tray extension has a top side and a bottom side. If you cannot insert the tabs into the holes, turn the support over. 12
ページ15に含まれる内容の要旨
Loading the Imaging Film Loading the Imaging Film Your fax uses a roll of imaging film to create printed text and images. The print head in the fax applies heat to the imaging film to transfer ink to the paper. Follow the steps below to load or replace the film. ♦ The initial starter roll of imaging film included with your fax can print about 30 A4-size pages. ♦ When replacing the film, use a roll of Sharp UX-6CR imaging film. One roll can print about 150 A4-size pages. 1 Remove the p
ページ16に含まれる内容の要旨
Loading the Imaging Film 4 Remove the new roll of imaging film from its packaging. • Cut the band that holds the rolls together. 5 Insert the green gears. 1 Schlitz Make sure the gears fit into the slots in the ends of the rolls. 2 Schlitz Fit ends of rolls 6 Insert the film into the print onto hubs compartment. Thick roll to rear 7 Rotate the front gear as shown until the film is taut. 8 Close the operation panel (press down on both sides to make sure it clicks into place). 1
ページ17に含まれる内容の要旨
Loading Printing Paper Loading Printing Paper 2 You can load up to 50 sheets of A4-size, 60 - 80 g/m paper in the paper tray (at room temperature; maximum stack height should not be higher than the line on the tray). 1 Fan the paper, and then tap the edge against a flat surface to even the stack. • Make sure the stack edges are even. 2 Insert the stack of paper into the tray, PRINT SIDE DOWN. • If paper remains in the tray, take it out and combine it into a single stack with the ne
ページ18に含まれる内容の要旨
Loading Printing Paper Print contrast setting Your fax has been set at the factory to print at normal contrast. If desired, you can change the print contrast setting to LIGHT or DARK. FUNKTION 1 Press once and once. Display: OPTION SETTING PRINT CONTRAST 2 Press once and 3 times. 1:NORMAL 3Press once. The display briefly shows your selection, then: 4 Select the print contrast: COPY CUT-OFF NORMAL: LIGHT: DARK: 1 2 3 STOP 5 Press to return to the date and time display. 16
ページ19に含まれる内容の要旨
Entering Your Name and Fax Number Entering Your Name and Fax Number Before you begin sending faxes, enter your name and fax (telephone) number as explained below and set the date and time as explained on page 19. Once you enter this information, it will automatically appear at the top of each fax page you send. STOP 1 2 3 4 5 6 7 8 9 0 FUNKTION START/SPEICHER Display: FUNKTION 1 Press once and 3 times. ENTRY MODE OWN NUMBER SET 2Press once. ENTER TEL/FAX # 3Press once. 4 Enter your
ページ20に含まれる内容の要旨
Entering Your Name and Fax Number START/SPEICHER 5 Press to enter the fax number in memory. 6 Enter your name by pressing number keys for each letter as shown in the chart below. Up to 24 characters can be entered. Example: SHARP = 7777 44 2 777 7 G = SPACE = N = U = A = H = V = O = B = W = I = P = C = Q = X = J = R = K = D = Y = S = L = Z = E = T = F = M = ♦ To enter two letters in succession that require the same key, press after entering the first letter. ♦ To clear a mistake
