Metra Electronics 99-7953の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS FOR PART 99-7953
APPLICATIONS
Suzuki Grand Vitara 2006-up
99-7953
KIT FEATURES
• DIN head unit provision with pocket
• ISO DIN head unit provision with pocket
KIT COMPONENTS
• A) Radio Housing • B) ISO Brackets • C) Trim Plate
A B C
WIRING & ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-1721 - Honda harness 1998-up
Antenna Adapter:
• Not Required
TOOLS REQUIRED
Small Flat Blade Screwdriver • Phillips Screwdriver • Socket Wrench
METRA. THE WORLD’S B

ページ2に含まれる内容の要旨

99-7953 Table of Contents Dash Disassembly – Suzuki Grand Vitara 2006-up 3 Kit Assembly – DIN head unit provision 4 – ISO DIN head unit provision 5 Caution Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhan

ページ3に含まれる内容の要旨

99-7953 Dash Disassembly 1. Unclip and remove the (2) outside trim panels. (Figure A) 2. Remove (6) Phillips screws securing the radio and climate controls to the sub dash. (Figure B) 3. Remove the (2) Phillips screws securing the factory radio bracket to the radio/ climate control assembly. (Figure C) 4. Separate the bracket and factory radio from the climate control. (Figure D) (Figure B) Continued on next page (Figure C) (Figure A) (Figure D) 3

ページ4に含まれる内容の要旨

Kit Assembly 99-7953 DIN head unit provision 1. Locate the factory wiring harness and antenna plug in the dash. Metra recommends using the proper mating adapters from Metra and/or AXXESS. 2. Slide the DIN cage into the radio housing and secure by bending the metal locking tabs down. (Figure A) 3. Slide the aftermarket head unit into the cage until secure. (Figure B) 4. Reassemble dash in reverse order of disassembly. (Figure A) (Figure B) 4

ページ5に含まれる内容の要旨

Kit Assembly 99-7953 ISO DIN head unit provision 1. Locate the factory wiring harness and antenna plug in the dash. Metra recommends using the proper mating adapters from Metra and/or AXXESS. 2. Mount the ISO brackets to the head unit with the screws supplied with the unit. (Figure A) 3. Slide the head unit into the radio opening until the side clips engage. (Figure B) 4. Snap the trim plate into the radio (Figure A) housing. (Figure B) 5. Reassemble dash in reverse order of dis

ページ6に含まれる内容の要旨

Notes

ページ7に含まれる内容の要旨

Notes

ページ8に含まれる内容の要旨

INSTALLATION INSTRUCTIONS FOR PART 99-7953 METRA. THE WORLD’S BEST KITS.™ metraonline.com 1-800-221-0932 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION REV. 5/18/11