ページ1に含まれる内容の要旨
Quick Start Guide
4800dr
™
Document Reader
ページ2に含まれる内容の要旨
Note:Refer to your Barcode Manual for information about cleaning your device. For localized language versions of this document, go to www.handheld.com. Assembling the 4800dr Place arm on tray. Use the 3 screws provided to attach the arm to the underside of the tray. 1
ページ3に含まれる内容の要旨
Place the imager in the stand. Press the cable firmly into the wire run along the back of the arm. (You must use the USB cable that’s supplied with the 4800dr or a compatible 5 volt powered cable.) 2
ページ4に含まれる内容の要旨
Imager Mounting Details If you are planning to mount the imager in a fixed position, the following diagram shows the mounting hole placement and details. All measurements are in inches. Connecting to the Host Turn off computer’s power before connecting the document reader, then power up the computer once the document reader is fully connected. USB Connection 3
ページ5に含まれる内容の要旨
TTL-232 Connection 4
ページ6に含まれる内容の要旨
Interface Scan the barcode that describes the PC or interface you are using. USB Keyboard (PC) USB Keyboard (Mac) USB Japanese Keyboard (PC) USB HID Barcode Reader USB COM Port Emulation TTL-232 Interface Aligning the Document Reader Tray Proper cable placement is important for accurate alignment of the device. Place the cable in the wire channel if the imager will remain in the base most of the time. If you plan to frequently lift out the imager to scan items, then set the cable in the loc
ページ7に含まれる内容の要旨
3. Make sure the serial number on the alignment page (the top number) matches the serial number on your document reader. 4800dr s/n engine s/n 4. Press the button on the imager to display the illuminated aimer crosshairs. You will hear a single beep that indicates you are using the correct page. (If you hear 3 beeps and the aimer turns off, then you have the wrong alignment page for your document reader.) 5. Move the tray until the illuminated aimer crosshairs line up with the printed
ページ8に含まれる内容の要旨
Europe, Middle East, and Africa Telephone: +31 (0) 40 7999 393 Fax: +31 (0) 40 2425 672 E-mail: eurosupport@handheld.com Asia Pacific Telephone - Hong Kong: +852-3188-3485 or 2511-3050 Telephone - China: +86 21 6361 3818 E-mail: aptechsupport@handheld.com Japan Telephone: +813 5770-6312 E-mail: aptechsupport@handheld.com Malaysia Telephone: +603-6201-7020 E-mail: aptechsupport@handheld.com Online Technical Assistance You can also access technical assistance online at www.han
ページ9に含まれる内容の要旨
Europe, Middle East, and Africa Telephone: +31 (0) 40 2901 633 Fax: +31 (0) 40 2901 631 E-mail: euservice@handheld.com Asia Pacific Telephone: +852-2511-3050 Fax: +852-2511-3557 E-mail: apservice@handheld.com Japan Telephone: +813-5770-6312 Fax: +813-5770-6313 E-mail: apservice@handheld.com Online Product Service and Repair Assistance You can also access product service and repair assistance online at www.handheld.com. Limited Warranty Hand Held Products, Inc. ("Hand Held Produ
ページ10に含まれる内容の要旨
HAND HELD PRODUCTS RESPONSIBILITY AND PURCHASER’S EXCLUSIVE REMEDY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT. IN NO EVENT SHALL HAND HELD PRODUCTS BE LIABLE FOR INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, AND, IN NO EVENT, SHALL ANY LIABILITY OF HAND HELD PRODUCTS ARISING IN CONNECTION WITH ANY PRODUCT SOLD HEREUNDER (WHETHER SUCH LIABILITY ARISES FROM A CLAIM BASED ON CONTRACT, WARRANTY, TORT, OR OTHERWISE) EXCEED THE ACTUAL AMOUNT PAID TO
ページ11に含まれる内容の要旨
10
ページ12に含まれる内容の要旨
Hand Held Products, Inc. 700 Visions Drive P.O. Box 208 Skaneateles Falls, NY 13153-0208 4800dr-QS Rev A 12/07
