ページ1に含まれる内容の要旨
M
Installation Manual
QIP7000 (P2) Series
Hybrid QAM/IP HD Set-top Terminal
ページ2に含まれる内容の要旨
© 2009 Motorola, Inc. All rights reserved. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from Motorola, Inc. Motorola reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Motorola to provide notification of such revision or change. Motorola provides this guide without wa
ページ3に含まれる内容の要旨
B Safety and Compliance i IMPORTANT SAFETY INSTRUCTIONS • Read these instructions. • Keep these instructions. • Heed all warnings. • Follow all instructions. • Do not use this apparatus near water. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. • Clean only with dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturers instructions. • Do not inst
ページ4に含まれる内容の要旨
B During Installation • Do not place the cable terminal in an enclosed area where the cooling vents are blocked or impede the flow of air through the ventilation openings. • Install the terminal so that its position does not interfere with its proper ventilation. For example, do not place the terminal on a bed, sofa, rug, or similar surface that could block the ventilation openings. • Install the terminal away from heat sources such as radiators, heat registers and stoves. Installati
ページ5に含まれる内容の要旨
B This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Declaration of Conformity Motorola Inc., Connected Home Solutions, 101 Tournament Drive, Horsham, PA 19044, 1-215-323-1000, declares that the QIP7000 series set-tops comply with 47 CFR Parts 2 and 15 of the FCC
ページ6に含まれる内容の要旨
B Contents Safety and Compliance .................................................................................................................. i Introduction.................................................................................................................................... 1 Features........................................................................................................................................... 3 Getting Help..................................
ページ7に含まれる内容の要旨
B Operational Check for the Remote Control ................................................................................... 30 Optimizing the High-Definition Settings ........................................................................................ 30 Graphics Overlaying the Video ...................................................................................................... 33 Diagnostics.....................................................................................
ページ8に含まれる内容の要旨
B Figures Figure 1 – QIP7232 Front and rear views........................................................................................ 2 Figure 2 – QIP7100 Front and rear views........................................................................................ 2 Figure 3 – QIP7232 front panel........................................................................................................ 6 Figure 4 – Rear panel...............................................................
ページ9に含まれる内容の要旨
Introduction B Introduction 1 This manual provides instructions for cable operator personnel to install the Motorola QIP7000 series High-Definition Set-top. This unit includes a high-end processor, expanded memory, and enhanced graphics to support digital, on-demand, and interactive services. It provides a full complement of interconnection options. The QIP7000 series provides advanced capabilities, including: • Authorization and purchase of on-demand programming • High-Definition
ページ10に含まれる内容の要旨
Introduction B Figure 1 – QIP7232 Front and rear views Figure 2 – QIP7100 Front and rear views QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual 2 574702-001 a This document is uncontrolled pending incorporation in a Motorola CMS
ページ11に含まれる内容の要旨
Introduction B Features Tuners • Two 54 to 864 MHz video tuners with digital video processor (Dual tuners available only with the QIP7200) • One dedicated tuner for the out-of-band (OOB) control channel Standard Audio/Video Features • ITU standard 64/256 QAM/FEC/enhanced adaptive equalizer • CSA based encryption/DCII (via inserted CableCARD™) access control • Out-of-band data receiver (70-130 MHz) 2.048 Mbps • Digital video scaling (picture in graphics) ® • Macrovision copy protecti
ページ12に含まれる内容の要旨
Introduction B Simultaneously record programs from two channels while watching a different pre-recorded program, with the ability to switch viewing between any of the three programs Motorola cannot guarantee the exact amount of programming that each subscriber will be able to record. The approximate time depends on the programming type and the drive size: Table 1 – DVR Recording Time Guidelines Estimated Recording Hours For: Internal Drive Size Standard Digital Channels HDTV Channel
ページ13に含まれる内容の要旨
Introduction B Getting Help If you need assistance with your Motorola product, contact the Motorola Technical Support Call Center (TSCC): • Toll-free: 1 888 944 HELP (1 888 944 4357) • Direct: 1 847 725 4011 • Motorola Online: http://businessonline.motorola.com The TSCC is available 24 hours a day, 7 days a week, in addition, Motorola Online offers a technical documentation, repair status, shipping information and low priority issue creation/tracking. For specific Toll Free numbers wh
ページ14に含まれる内容の要旨
Overview B Overview 2 Front Panel The front panel controls provide functional navigation if the remote control is lost or is temporarily out of service. Certain functions, such as those requiring a numeric entry, require a remote control. Some connectors are not enabled and require the support of application software. Figure 3 – QIP7232 front panel Table 2 – Front panel Label Description 1 USB connector 2 Cursor — 4-way menu navigation 3 Display Panel — 4 Power — Turns the s
ページ15に含まれる内容の要旨
Overview B Figure 4 – Rear panel Table 3 – Rear panel connections Lable Description 1 FiOS TV In — Connects to FiOS signal from your service provider 2 RF Out — Ch 3/4 modulated audio/video (SDTV) to TV or VCR 3 IEEE-1394 — Audio and video device connection 4 YPbPr — Component video output (HDTV) 5 Audio — Composite Audio L/R outputs 6 Video — Composite Video (SDTV) output ® 7 Digital Audio (RCA)* — Provides Dolby Digital 5.1 audio or PCM output ® 8 Optical Audio (S/PDIF)* — Provi
ページ16に含まれる内容の要旨
Overview B System Overview This section introduces key concepts relevant to installing the Motorola Whole Home IP Video Network CPE. It describes: • The passive optical network (PON) connecting the customer premises to the headend • The Motorola Whole Home IP Video Network that you install at the customer premises • Multimedia Over Coax Alliance (MoCA) technology • Multi-room DVR The Motorola Whole Home IP Video Network connects to the fiber-to-the-premises (FTTP) passive optical ne
ページ17に含まれる内容の要旨
Overview B The FTTP PON carries the following services: Service Description Two-way Video services include enhanced interactive services such as video on demand (VoD). Video video service is carried over the PON to the ONT and then over the in-home coaxial network. Digital and out-of-band (OOB) carriers are supported on the 50 to 862 MHz spectrum. Video traffic on the PON consists of: • Downstream digital standard- and high-definition television (HDTV) video services; for ® ® example,
ページ18に含まれる内容の要旨
Overview B Figure 6 – Whole Home IP Video CPE overview The components include: • Motorola or similar optical network • Broadband Home Router (BHR) with embedded MoCA • Motorola QAM/IP set-tops containing embedded MoCA technology: • QIP7200 advanced digital set-top supporting HDTV and digital video recording (DVR) • QIP7100 advanced digital set-top supporting HDTV • QIP2500 core digital set-top supporting standard definition TV You must connect the BHR to an RF coaxial splitter con
ページ19に含まれる内容の要旨
Overview B MoCA MoCA technology bridges Ethernet traffic onto the coaxial cable network. MoCA operates from 975 to 1025 MHz on the MoCA WAN channel and 1125 to 1525 MHz, above the standard RF spectrum of 5 to 862 MHz. Video MoCA WAN LAN 11 136 12345678 OOB 6 50 860 050 975 1125 1525 1025 (MHz) Figure 7 – MoCA RF spectrum Each MoCA set-top requires an IP address for configuration and management, but do not require any other IP services. To minimize network IP address requirements, the
ページ20に含まれる内容の要旨
Overview B Multi-Room DVR Multi-room DVR enables the customer to simultaneously play back programs recorded on a QIP7232 media hub (server) on up to two connected QIP7100 or QIP3100 media terminals (clients). Service providers can enable multi-room DVR for all customers or provide multi-room DVR as an extra-cost option. One QIP7232 media hub is required. QIP7232 QIP7100 QIP3100 media hub media terminal media terminal (outlet A) Figure 8 – Multi room DVR network Viewers in the home ca
