ページ1に含まれる内容の要旨
HD DIGITAL VIDEOCASSETTE RECORDER
HDW-F500
PARALLEL INTERFACE KIT
BKDW-509
HD-SD CONVERTER BOARD
HKDV-501A
HD LINE CONVERTER BOARD
HKDV-502
HD DIGITAL VIDEO CONTROLLER
HKDV-503
SDTI BOARD
HKDV-506A
HD PULL DOWN BOARD
HKDV-507/507D
[ English ]
OPERATION MANUAL
1st Edition (Revised 3)
Serial No. 10101 and Higher
ページ2に含まれる内容の要旨
For the customers in Europe WARNING This product with the CE marking complies with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European To prevent fire or shock hazard, do not Community. expose the unit to rain or moisture. Compliance with these directives implies conformity to the following European standards: • EN60065: Product Safety To avoid electrical shock, do not open the • EN55103-1: Electromagnetic Interference (Emissio
ページ3に含まれる内容の要旨
VORSICHT Um Feuergefahr und die Gefahr eines elektrischen Schlages zu vermeiden, darf das Gerät weder Regen noch Feuchtigkeit ausgesetzt werden. Um einen elektrischen Schlag zu vermeiden, darf das Gehäuse nicht geöffnet werden. Überlassen Sie Wartungsarbeiten stets nur qualifiziertem Fachpersonal. DIESES GERÄT MUSS GEERDET WERDEN. Für Kunden in Europa Dieses Produkt besitzt die CE-Kennzeichnung und erfüllt sowohl die EMV-Direktive (89/336/EEC) als auch die Directive Niederspannung (73/23/EEC) d
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
Table of Contents Table of Contents 1-1 Features ............................................................................................ 1-1 Chapter 1 1-1-1 Features of the HDW-F500 .................................................... 1-1 Overview 1-1-2 Features of the Control Panel ................................................. 1-3 1-2 Optional Accessories ....................................................................... 1-5 2-1 Control Panel .....................................
ページ6に含まれる内容の要旨
Table of Contents Table of Contents 4-3 TC Menu ........................................................................................ 4-20 Chapter 4 4-3-1 Setting the Time Data (TIMER SEL/RESET/SET/HOLD) 4-21 Menu Settings 4-3-2 Setting the Time Code Reader (TCR SEL) .......................... 4-24 4-3-3 Setting the Time Code Generator (TCG SOURCE/MODE) 4-25 4-3-4 Selecting the Time Code Running Mode (RUN MODE)..... 4-25 4-3-5 Selecting the Drop Frame Mode (DF/NDF) .........................
ページ7に含まれる内容の要旨
Table of Contents 5-1 Preparing for Recording................................................................. 5-1 Chapter 5 5-1-1 Setting Switches and Menus ................................................... 5-1 Recording/Playback 5-1-2 Selecting Audio Signals.......................................................... 5-2 5-1-3 Adjusting the Audio Recording Level .................................... 5-3 5-1-4 Simultaneously Monitoring Playback of Video and Audio Signals Being Recorded ........
ページ8に含まれる内容の要旨
Table of Contents Table of Contents Maintenance .......................................................................................... A-1 Appendix Head Cleaning ................................................................................. A-1 Moisture Condensation ................................................................... A-1 Specifications......................................................................................... A-2 Operation Information Display ...............
ページ9に含まれる内容の要旨
Chapter 1 Overview Chapter 1 Overview 1-1 Features Bit rate reduction encoder 1-1-1 Features of the HDW-F500 The component video signal data is compressed by a factor of about four by a process in which it is The HDW-F500 is a HD digital videocassette recorder subjected to frame shuffling, blocking, DCT (discrete 1) using the HDCAM format. Comparable to a cosine transform), quantizing adjustment, and variable conventional digital Betacam in size, weight, and ease- length word encoding. This
ページ10に含まれる内容の要旨
Chapter 1 Overview 1-1 Features Capstan override function Advanced Recording and Playback You can adjust the playback speed by ±15% to ensure Functions synchronization between, for example, two VTRs playing back the same program. High-quality digital recording The HDCAM system uses a component system to Independent level controls record video signals. An AES/EBU format with a wide The recording and playback levels of each of the four dynamic range is used for 4-channel audio recording. audio cha
ページ11に含まれる内容の要旨
Chapter 1 Overview Self-diagnosis PF1/PF2 (Personal Function) menus This function allows the VTR to perform self Use these menus to register up to 40 of the most diagnostics when a malfunction occurs. An error frequently used items from the other menus (up to ten message is displayed and a history of all errors that items each can be registered to PF1, ALT+PF1, PF2 have occurred is recorded. and ALT+PF2). Menu items that may be registered can be displayed by pressing the [F4] (PF1&2 ASSIGN) Eas
ページ12に含まれる内容の要旨
Chapter 1 Overview 1-1 Features Title function Display of duration between edit points This function allows you to add titles when storing The duration between any two of IN, OUT, AUDIO IN, data to the VTR memory bank or memory card, thus or AUDIO OUT points can be displayed by facilitating data retrieval and management. simultaneously pressing two buttons corresponding to those edit points. Write protect function Setting pages stored in VTR memory banks or Digital time counter memory cards can
ページ13に含まれる内容の要旨
Chapter 1 Overview 1-2 Optional Accessories HKDV-507/507D HD Pull Down Board The following accessories can be used with the HDW- F500. This board allows the output of 2-3 pull down HD signal of 59.94i or 60i mode when this unit is operated BKDW-509 Parallel (50-pin) Interface Kit with the frame frequency of 23.98 or 24 Hz. The 2-3 A 50-pin parallel interfaces makes the HDW-F500 pull down sequence is as follows. compatible with different broadcast station systems. HKDV-501A HD-SD Converter Board
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls Chapter 2 Locations and Functions of Parts and Controls 2-1 Control Panel The control panel consists of the following sections: memory card insertion slot, editing operations section, tape transport operations section and search • Upper control panel operations section • Lower control panel: menu operations section, Upper control panel DIGITAL VIDEO CASSETTE RECORDER HDW-F500 Lower control panel Menu operations section Memory card Searc
ページ16に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls 2-1 Control Panel 2-1-1 Upper Control Panel 1DISPLAY FULL/FINE button 2PHONES jack 3POWER switch 4PHONES level control 5 PB level 6REC level controls 7Audio level meters 8MONITOR SELECT button controls DIGITAL VIDEO CASSETTE RECORDER HDW-F500 9Indicator window !ºINPUT SELECT button !¡AUDIO INPUT/MONITOR SELECT buttons !™REFERENCE signal indicators !£REMOTE buttons and RS-232C indicator Upper control panel 1 DISPLAY FULL/FINE button 2 PHON
ページ17に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls 4 PHONES level control 9 Indicator window Adjusts the output level to the PHONES jack. The following indicators light up to indicate the VTR’s You can enable this control to simultaneously adjust status. the output level to the MONITOR OUTPUT Indicators and corresponding VTR status connectors on the connector panel. Indicator Status CHANNEL Indicates the playback signal condition. For details, see Section 5-1-2, “Selecting Audio Signals” o
ページ18に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls 2-1 Control Panel !º INPUT SELECT button !™ REF SYNC (reference signal) indicators Selects the type and channel for the audio input signal. These indicate the signal selected as the reference Press to light the button up, then press one of the signal. If there is no reference signal input to the AUDIO INPUT/MONITOR SELECT buttons to select selected connector, the STOP button flashes. the type and the channel of the audio signal. EXT SD: I
ページ19に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls 2-1-2 Lower Control Panel (Menu Operations Section) 1Menu display 3MEMORY CARD indicator 2Menu buttons 4ACCESS button DIGITAL VIDEO CASSETTE RECORDER HDW-F500 5Memory card insertion slot 6Function buttons 7ALT button 8MAINTENANCE switch 9ALARM indicator Lower control panel (menu operations section) Chapter 2 Locations and Functions of Parts and Controls 2-5
ページ20に含まれる内容の要旨
Chapter 2 Locations and Functions of Parts and Controls 2-1 Control Panel 1 Menu display 5 Memory card insertion slot Menus selected by pressing the menu buttons appear Insert memory cards here. VTR settings can be stored here. on cards and used to configure the VTR and control Each menu shows the functions assigned to each panel at a later date, thus reducing the time required function button ([F1] to [F10]) and information for set up. necessary for making settings, such as time codes. Press
