ページ1に含まれる内容の要旨
EXCELLENCE
by
H-CMD4000
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 3 TFT DISPLAY
Instruction manual
DVD/CD/MP3 3 TFT
ページ2に含まれる内容の要旨
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Tabl of contents ...............................................................................................................................................2 Importansafeguards.........................................................................
ページ3に含まれる内容の要旨
Important safeguards · Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! · Read carefully through this manual to familiarize yourself with this high-quality sound system. · Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. · When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage ra
ページ4に含まれる内容の要旨
Installation/ connection First complete the electrical connections, and then check them for correctness. Installation opening This unit can be installed in any dashboard having an opening as shown on the picture. The dashboard should be 4.75 5.56 mm thick in order to be able to support the unit. 1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver. Make sure that lock lever is flush with the mounting collar (not projecting outward). 2. Secure the r
ページ5に含まれる内容の要旨
Detachable control panel Detaching the control panel · Turn the Power off. · Press button to flip down the panel. · Gently press the right side of the panel. · Pull the panel out (see the picture 1). Pic. 1 Attaching the control panel · Insert the right side of the control panel into the main unit. · Press the control panel left side until the click sound is heard. Caution: DO NOT insert the control panel from the left side. It can damage the control panel. The control panel can easily be damage
ページ6に含まれる内容の要旨
Electrical connection (Green/White) (Pink) 6
ページ7に含まれる内容の要旨
Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut
ページ8に含まれる内容の要旨
Panel controls Front panel 1. RELEASE button ( ) Press it to flip down the front panel. 2. DISP button Use this button to switch the display or to adjust the clock. 3. AF/TA button Press it to select AF (alternative frequency) function ON or OFF. Press and hold for 2 seconds to turn TA (traffic announcement) function ON or OFF. 8
ページ9に含まれる内容の要旨
4. PTY button Press it to activate the PTY function. Press PTY button for 2 seconds to choose LOCAL, press it again for 2 seconds to switch to DX. 5. PRESET STATION [1-6] buttons 6. RPT button Use this button to play current track repeatedly. 7. INT button Press it to start intro playing (10 seconds). 8. PLAY/PAUSE button Use this button to start playback. Press it to pause playback. 9. VOL knob/ SEL button Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease
ページ10に含まれる内容の要旨
14. SRC button Press to select the source: Radio, Disc play, USB, SD Card, Aux-in. 15. BAND button Press it repeatedly to select your desired radio band during RADIO mode. 16. IR sensor 17. TFT display 18. PREVIOUS (9)/ NEXT (:) buttons Use these buttons to enter the manual tuning mode/ seek tuning mode. Use this button to search for the beginning of the previous/ next track, for backward/ forward track scanning. 19. PWR/ MUTE button Press PWR button to turn the power on, press and hold for 2 se
ページ11に含まれる内容の要旨
Remote control 1. ZOOM button (for DVD/VCD only) 2. TITLE button (for DVD only) 3. PWR button 4. SETUP button 5. Directional buttons for menu selection 6. ENTER button 7. PROG button 8. Digit area 9. SEL button: press it to select basic sound setting options 10. VOL +/- button 11. MUTE button 12. SEEK +/- buttons: use these buttons to enter the manual tuning mode/ seek tuning mode. Use this button to search for the beginning of the previous/ next track, for backward/ forward track scanning. 13.
ページ12に含まれる内容の要旨
22. AUDIO button 23. DISP button 24. ANGLE button (for DVD discs only) 25. BAND / P/N button: press it repeatedly to select your desired radio band during RADIO mode. Press it repeatedly in VIDEO mode to select video system: PAL/NTSC/AUTO. Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the batt
ページ13に含まれる内容の要旨
Back of the front panel Press the button on the front panel to flip it down. 1 2 3 4 5 1. Disc slot 2. EJECT button 3. Panel status indicator 4. RESET button 5. SD/MMC card socket Note: Pressing the RESET button will erase the clock setting and stored stations. Panel status indicator lights up when you slide the panel down; flashes when you remove the panel. 13
ページ14に含まれる内容の要旨
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press button on the panel to open the panel and press the RESET button to restore the unit to the original factory settings. Power button Press PWR button to turn the unit on. Press and hold it for 2 seconds to switch the unit off. Note: After the unit is off, the volume level and radio current settings will be memorized, and when you turn the unit on it will resume
ページ15に含まれる内容の要旨
· If you don t adjust VOL knob within 3 seconds after selecting the desired setting, the unit will automatically return to the current mode being displayed. Setting other characteristics During FM mode, keep pressing SEL button for 2 seconds to enter another mode. Shortly and repeatedly press the SEL button to select the setting: EQ MODE => LOUD => BEEP => CAMERA => 12/24 MODE => TA MODE => RETUNE => PARKING MODE => MIRROR IMAGE => TA-VOL => VOL-MODE => A-VOL => SUBWOOFER => SUBW-LOL. Press the
ページ16に含まれる内容の要旨
- TA ALARM During searching the radio does not retune but the double beep sound (alarm) is output. 7. RETUNE: To determine the initial time of automatic TA (Traffic Announcement) search. There are 2 modes: RETUNE L and RETUNE L. - RETUNE L: 180 seconds. - RETUNE S: 45 seconds. Note: Retune mode is active for TA SEEK mode only. 8. PARKING MODE: rotate the VOL knob to turn rear parking attention ON or OFF. While unit is in parking ON mode, during playback the screen will show Do not watch video w
ページ17に含まれる内容の要旨
Display operations Press the DISP button to show the following current tuning information and time in any play mode: PS (Default) => PTY => Radio frequency => CT. For DVD mode 1. When the DVD disc is loaded press the SRC button repeatedly to select DVD mode. 2. Press the DISP button. The display will show: For AUX mode 1. When the DVD disc is loaded press the SRC button repeatedly to select AUX mode. 2. Press the DISP button. The display will show: Setting the time 1. Press the DISP button and h
ページ18に含まれる内容の要旨
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press PWR to power on, then press the SRC button to select RADIO. Press BAND once or more to select: FM1, FM2, FM3, FM (OIRT), MW1, MW2. Display will show the wave band, frequency and preset station number if already stored, see the following picture: Manual/ automatic tuning · Manual tuni
ページ19に含まれる内容の要旨
Programming tuner stations You can store up to a total of 30 radio stations in the memory (24 FM, 12 MW), manually or automatically. · To store a station: - Select a band (if needed) - Select a station by9/: buttons - Hold a Preset button (1-6) which you want store the station for at least 2 seconds. · To recall a station: - Select a band (if needed) - Press a Preset button (1-6) briefly to recall the stored station OR: During radio mode press the9/: buttons to select downward or upward stored s
ページ20に含まれる内容の要旨
1. Press AF/TA button shortly to turn ON or turn OFF the AF function. AF indicator on display will flash until RDS information is received. 2. If RDS service is not available in your area, turn off the AF mode. Default setting is ON. TA (Traffic Alarm) function Press the AF/TA button and hold for 2 seconds to turn ON or turn OFF the TA function. In TA mode traffic program will be automatically searched, until the program is received. When traffic announcement is received, the TA indicator will d
