ページ1に含まれる内容の要旨
INSTALL INSTRUCTIONS
C-VS-0812-CHGR & C-VS-0812-CHGR-1
20” VEHICLE SPECIFIC LOW PROFILE CONSOLE
2006-2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench Screwdriver set
Sockets - 7/16” T-20 torx bit
Combo wrench set
HARDWARE:
ITEM# QTY DESCRIPTION PART #
1 1 8” console housing CM000672
2 1 Support bracket for stout console CM001595
3 1 12” Low profile console (housing only) C-SM-1200-H
4 1 Frame support bracket CM001593
5 1 YA
ページ2に含まれる内容の要旨
#8 #1 #4 (not shown) #2 #3 #7 #10 & #9 (not shown) #5 #6 #9 Always! Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524-9900. C
ページ3に含まれる内容の要旨
Remove OEM supplied trak. View of trak removed Attach frame support bracket Note: Some hardware is re-used (#4) to vehicle using 10/32 x ½” in installation of console phillips machine screws, washers, and keps nuts Attach frame support bracket Attach support bracket for stout Tighten hardware (#4) to vehicle using 10/32 x ½” console (#2) to vehicle and to frame phillips machine screws, support bracket using OEM hardware washers, and keps nuts and #10 x ½” phillips machine screws and was
ページ4に含まれる内容の要旨
Attach rear floor filler panel (#6) Attach YAW sensor cover panel Attach driver and passenger- to vehicle using OEM hardware (#5) to vehicle using front side wire panels (#7 & 8) to driver side hardware from rear frame support bracket using #10 x ½” phillips machine screws floor filler panel (#6) and washers. View of installed C-VS-0812-CHGR Route wiring and install emergency controls and accessories C-VS-0812-CHGR_INST_12-07 4
