ページ1に含まれる内容の要旨
D00697100A
»
Introduction 2
DV-D6500
DVD Player
6
Getting started
12
Basic operations
VIDEO
Advanced
22
operations
MP3 disc
39
playback
JPEG disc
42
playback
Changing the
OWNER’S MANUAL
47
initial settings
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
Ü Additional
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
56
information
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to
ページ2に含まれる内容の要旨
Important Safety Precautions For U.S.A IMPORTANT (for U.K. Customers) TO THE USER This equipment has been tested and found to comply with DO NOT cut off the mains plug from this equipment. the limits for a Class A digital device, pursuant to Part 15 If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an of the FCC Rules. These limits are designed to provide appropriate safet
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: …Read all of these Instructions. This reminder is provided to call the CATV system installer’s attention to …Save these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding …Follow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to the
ページ4に含まれる内容の要旨
Introduction Table of Contents To playback in random order [Random playback] ..............26 Introduction Page 2 Repeat playback............................................................... 27 To repeat the current selection or all tracks Supplied accessories..........................................................2 [Repeat playback]................................................................27 Notes on handling.......
ページ5に含まれる内容の要旨
Introduction English Supplied accessories • Audio/video cable (Yellow/White/Red) (x 1) • R6P(SUM-3)/AA(15F) battery (x 2) • Instruction manual (x 1) • Component video cable (Red/Green/Blue) (x 1) • Remote Control Unit (x 1) • AC power cord (x 1) 2 Introduction
ページ6に含まれる内容の要旨
Introduction Notes on handling Safety precautions Important cautions Avoid moisture, water and dust Installation of the unit Do not place the unit in moist or dusty places. • Select a place which is level, dry and neither too hot o o o o nor too cold (between 5 C and 35 C, 41 F and 95 F). Avoid high temperatures • Leave sufficient distance between the unit and the TV. Do not expose the unit to direct sunlight or place it near • Do not use the unit in a
ページ7に含まれる内容の要旨
Introduction English About discs Playable disc types Audio formats There are some audio formats recorded on discs as Playable and non-playable disc types are as follows: shown below. DVD VIDEO SVCD Video CD Audio CD • Linear PCM VIDEO Uncompressed digital audio, the same format used The DVD Logo is a trademark. on CDs and most studio masters. DVD VIDEO supports 2 channels at sampling rates of • CD-R and CD-RW discs recorded with the Audio CD, 48/96 kHz and quantization o
ページ8に含まれる内容の要旨
Introduction Disc structure Care and handling of discs (For DVD VIDEO) How to handle discs A DVD VIDEO disc is comprised of "titles" and each title When handling a disc, do not touch the surface of the may be divided into some "chapters". For example, if a disc. Since discs are made of plastic, they are easily DVD VIDEO disc contains some movies, each movie may damaged. If a disc gets dirty, dusty, scratched or warped, have its own title number, and each movie may b
ページ9に含まれる内容の要旨
Getting started English Connections *Before using the unit, you have to connect the unit to a TV and/or amplifier. Before making any connections • Do not connect the AC power cord until all other connections have been made. • Connect VIDEO OUT of the unit directly to the video input of your TV. Connecting VIDEO OUT of the unit to a TV via a VCR may cause a monitor problem when playing back a copy-protected disc. You may also have a monitor problem when connecting the unit to an
ページ10に含まれる内容の要旨
Getting started Connection to a TV equipped with component jacks You can enjoy high picture quality by connecting the unit's COMPONENT VIDEO OUT jacks to the COMPONENT VIDEO IN jacks of your TV with the video cables. Blue Component video cable (supplied) Green Red The unit Blue Green Red TV IN YPB PR S-VIDEO Scan mode selector Red White VIDEO COMPONENT IN White Audio cable (not supplied) LEFT AUDIO RIGHT Red • Connect "Y" to "Y", "PB" to "PB"(CB), "PR" to "PR"(CR
ページ11に含まれる内容の要旨
Getting started To make the Progressive scan mode selection active from the remote control unit English The unit supports the Progressive scan system as well as the conventional Interlace scan system. If your television or monitor supports the progressive video input, you can enjoy a high quality picture by making the Progressive scan mode active. If you want to select the scan mode between the interlace and progressive modes depending on the source condition or when connecti
ページ12に含まれる内容の要旨
Getting started To connect to digital audio device You can enhance the sound quality by connecting either of the unit's DIGITAL OUT jacks to the digital input of an amplifier, etc. by using an optical or a coaxal digital cable (optional). The digital audio signal from a disc is directly transferred. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder by using an optional digital cable, you can enjoy high-quality surround sound. For digita
ページ13に含まれる内容の要旨
Getting started English Using the remote control unit Using the remote control, you can operate not only all the functions of the unit but also basic functions of your TV and amplifier/receiver. Remote sensor To install batteries in the remote control unit • Operate the remote control unit while pointing it toward the remote sensor on the unit. The battery compartment is located on the back of the • The remote control unit can be used within a range of remote control un
ページ14に含まれる内容の要旨
Getting started 5 Release TV/VIDEO - CANCEL. To use the remote control unit for TV 6 Try to operate the TV by pressing TV STANDBY/ON operation . If your TV turns on or off, you have successfully set You can operate your TV from the remote control unit. the control signal. Setting the remote control signal for The following buttons can be used for operating the operating your TV TV. To use §/¶ (CH–, CH+), Ó/Á(VOL–, VOL+), TV/ VIDEO- CANCEL and numeric but
ページ15に含まれる内容の要旨
Basic operations In the following description, we assume that the buttons on the remote control unit are mainly used, however, you may English use the corresponding buttons on the front panel if available. NOTE Make sure that the TV - DVD switch on the remote control unit is set to "DVD" when using the §/¶/Ó/Á TV DVD and numeric buttons for controlling the unit. Before operation Turning on/off the unit Press DVD STANDBY/ON on the remote control unit or press STAND
ページ16に含まれる内容の要旨
Basic operations The initial setup before using the unit We recommend you to set the display language, TV monitor type and digital output before using the unit, depending on circumstances, by following the procedure below. See "Changing the initial settings" on and after page 47 for details about each setting item. ENTER CHOICE 1 Press CHOICE for a few seconds to bring up 5 Press ENTER. the first page of the DVD PLAYER SET UP The third (final) page is show
ページ17に含まれる内容の要旨
Basic operations English Basic playback This section describes basic operations for playback of DVD VIDEO, Audio CD, Video CD and SVCD discs. For MP3 and JPEG disc playback, see the separate chapter on and after pages 39 and 42. OPEN/CLOSE Disc tray Á ª π OPEN/CLOSE Inserting and removing discs 1 Press OPEN/CLOSE to open the disc tray. With the label side up 2 Place a disc in the tray. 3 Press OPEN/CLOSE to close the disc tray. The unit reads the disc informat
ページ18に含まれる内容の要旨
Basic operations To start playback Available : Press Á. The unit starts playback from the beginning. About screen saver function •A television monitor screen may be burned out if a static While the screen saver While the screen saver picture is displayed for a long time. To prevent this, the unit function is not activated function is activated automatically activates the screen saver function if a static picture, such as an on-screen display or menu,
ページ19に含まれる内容の要旨
Basic operations English Resuming playback The unit can memorizes the position on a disc where you interrupt playback, and resume playback from that position later. There are two resume modes (DISC RESUME and ON) you can set on the preference display. See page 52 for details about how to set the resume mode. • When purchasing the unit, the resume mode is initially set to "ON". •You can deactivate the resume mode by setting "RESUME" on the "OTHERS" preferenc
ページ20に含まれる内容の要旨
Basic operations To resume playback Available : When the resume mode is set to "DISC RESUME" ≠ While stopped, or no disc is inserted 1 Press OPEN/CLOSE to insert a disc whose interrupted position is memorized. After loading the disc, the display window on the front panel shows "----RESUME." If a disc for which you want to resume playback is already set in the disc tray, you need not to follow the step 1. 2 Press Á. The display window shows "RESUME
