ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
LAT-NR221
LED Tail Lights for 1958 Chevy Bel Air/Biscayne
and 1961-1967 Corvette
MAN#650209
Kit Includes:
Installation:
1. Remove the two screws and tail light lens.
2. Remove the light bulb.
3. Push and twist to remove the plastic wire socket from the back side of the housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the nut and round metal spacer from the back
ページ2に含まれる内容の要旨
7. Feed the wires through the round metal spacer, with one wire going through each outer hole in the aluminum spacer. Use caution when feeding wires through to avoid damaging the wire insulation. The larger diameter ring should be away from the tail light housing. 8. Secure the metal spacer with the supplied #6 nut. 9. Make sure the original lens gasket is in place and replace the tail light lens. Tighten the screws down carefully. MAN#650209
ページ3に含まれる内容の要旨
10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length, once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the
