ページ1に含まれる内容の要旨
owner's
manual
12 GALLON
MODEL NO.
113.177650
OR
16 GALLON
MODEL NO.
113.177611
Serial
Number
Model and serial
numbers may be
found underneath
the handle.
CRRFTSMRH°
You should record
both model and serial
numbers in a safe
place for future use.
12 GALLON OR
16 GALLON
AWARNING:
FOR YOUR
WET/DRY VAC
SAFETY,
• safety
READ ALL
INSTRUCTIONS
• assembly
CAREFULLY
• operation
SAVE THIS
• maintenance
MANUAL
• repair parts
FOR FUTURE
REFERENCE
• Espahol - pagina 15
J
Sears, Roebuck and Co., Hoffman Estat
ページ2に含まれる内容の要旨
Warranty Craftsman One Year Full Warranty If this Craftsman product fails due to a defect in material or workmanship within one year from the date of purchase, return it to any Sears store, Sears Service Center, or other Craftsman outlet in the United States for free repair (or replacement if repair proves impossible). This warranty applies for only 90 days from the date of purchase if this product is ever used for commercial or rental purposes. This warranty does not include bags or filters, wh
ページ3に含まれる内容の要旨
• Turn offVacbefore unplugging. This Vac isdouble-insulated, eliminating theneed foraseparate grounding • Toreduce theriskofinjury from system. Useonly identical replacement accidental starting, unplug power cord parts. Read theinstructions forServicing before changing orcleaning filter. Double-Insulated Wet/Dry Vacs. • Donotunplug bypulling oncord. Useonly extension cords that arerated Tounplug, grasp theplug, notthecord. foroutdoor use. Extension cords inpoor • Donotuse withdamaged cord,plug o
ページ4に含まれる内容の要旨
Introduction Read this owner's manual to familiarize This Wet/Dry Vac is intended for house- hold use. It may be used for vacuuming of yourself with the product features and to wet or dry media and may be used as a understand the specific usage of your new blower. Wet/Dry Vac. Table of Contents Section Page Section Page Warranty ........................ 2 Emptying the Drum .............. 8 Important Safety Instructions ......... 2 Blowing Feature ................. 9 Introduction ................
ページ5に含まれる内容の要旨
Assembly (continued) Caster/Caster Foot Assembly Vac Assembly 1. Remove the power assembly from the 1. Line up front (label and switch side) of dust drum and set aside. power assembly with drain cap and Vac port located on the front of the 2. Turn the dust drum upside down on the drum. floor. 3. Insert the caster feet into the bottom of Note: Power assembly must be aligned drum, as shown (4 places). with drum for proper attachment. 4. Push on the caster foot until the foot is 2. Place power asse
ページ6に含まれる内容の要旨
Assembly (continued) Insert Hose Insert the hose locking end of the "Pos-I- Lock®'`hose into the inlet of the Vac. The hose should snap into place. To remove the hose from the Vac, press the release button in the hose assembly and pull the hose out of the Vac inlet, as shown. Press ; and y Pull Storage Location E:::::> Hose Power Assembly Accessory Storage Your accessories may be stored in the caster feet or in the storage locations on the lid. The hose may be stored by wrap- ping it around the
ページ7に含まれる内容の要旨
Operation WARNING: To reduce the risk of fire, explosion, or damage to Vac: • Do not leave Vac running while unattended - you may fail to notice important signs indicating abnormal operation such as loss of suction, debris/liquid exiting exhaust, or abnormal motor noises. Immediately stop using Vac if you notice these signs. • Do not leave Vac plugged-in when not in use. • Do not continue running when float has cut off suction. • Do not operate Vac in areas with flammable gases, vapors or explos
ページ8に含まれる内容の要旨
Operation (continued) Vacuuming Liquids Emptying the Drum 1. Remove the power assembly. Push down and pull out the flexible locking filter cage and float, as they prevent tabs to release from drum. liquid from entering the impeller and _ WARNING: Do not operate without damaging the motor. 2. While holding the locking tabs out, lift the power assembly up and away from 1. When picking up small amounts of the drum. liquid the filter may be left in place. 3. Lay power assembly upside down on a 2. Wh
ページ9に含まれる内容の要旨
Operation (continued) Craftsman recommended accessories are Blowing Feature available at Sears retail stores and Your Vac features a blowing port. It can sears.com. The Sears 2-1/2" Blower blow sawdust and other debris. Follow Nozzle Stock No. 16933 is recommended the steps below to use your Vac as a for blowing debris. blower. ,_k WARNING: Always wear safety Push/PullHandle eyewear complying with ANSI Z87.1 \ Hose End \ (or in Canada, CSA Z94.3) before Blowing using as a blower. Port WARNING: T
ページ10に含まれる内容の要旨
Maintenance Filter Installation: Filter 1. Carefully slide the Qwik Lock TM filter WARNING: To reduce the risk of over the filter cage and press down on injury from accidental starting, unplug the outside edge of the filter until the power cord before changing or clean- rubber gasket on the bottom of the filter ing filter. seats securely around the base of the filter cage and against the lid. NOTE: This filter is made of high quality 2. Align the small center hole in the top of paper designed to
ページ11に含まれる内容の要旨
Maintenance (continued) To disinfect the drum: Cleaning A Dry Filter 1. Pour 1 gallon of water and 1 teaspoon Some removal of dry debris can be chlorine bleach into the drum. accomplished without removing the filter from the Vac. Slap your hand on top of 2. Let solution stand for 20 minutes, the power assembly while the Vac is carefully swishing every few minutes, turned off. making sure to wet all inside surfaces of the drum. For best cleaning results due to accumulated dust, clean the filter i
ページ12に含まれる内容の要旨
Repair Parts 12 Gallon Wet/Dry Vac OR 16 Gallon Wet/Dry Vac Model No. 113.177650 Model No. 113.177611 Always order by Part Number - Not by Key Number WARNING SERVICING OF DOUBLE-INSULATED WET/DRY VAC In a double-insulated Wet/Dry Vac, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added. Servicing a double-insulated Wet/Dry Vac requires extreme care and knowledge of the system, and s
ページ13に含まれる内容の要旨
Repair Parts OR 12 Gallon Wet/Dry Vac 16 Gallon Wet/Dry Vac Model No. 113.177650 Model No. 113.177611 28 12_ 14 20, 21 J 25 13
ページ14に含まれる内容の要旨
Notes 14
ページ15に含まれる内容の要旨
f manual del usuario 12 GALONES NO. DE MODELO 113.177650 0 16 GALONES NO. DEMODEL0 113.177611 N_mero de serie Los n_meros de modelo y de serie se pueden encontrar debajo del asa. T ° Usted debe anotar los n_meros tanto de modelo como de serie en un lugar seguro para usofuturo. ASPIRADORA PARA MOJADO/SECO _ADVERTENCIA: DE 12 GALONES PARA SU SEGURIDAD 0 DE 16 GALONES LEADETENIDAMENTE TODASLAS • seguridad INSTRUCCIONES • ensamblaje GUARDEESTE • funcionamiento MANUAL • mantenimiento PARAREFERENCIA F
ページ16に含まれる内容の要旨
Garantia r GarantiacompletaCraftsmande un afio Si este productoCraftsmanfalla debido a un defectode material o defabricaciOndentrodel plazo de un afio a partir de la fechade compra,devuOlvaloa cualquiertienda Sears, Centrode Servicio Searsu otropuntode venta Craftsmanpara quesea reparado gratuitamente(o reemplazadosi la reparaciOnresulta imposible). Estagarantiase aplica solamente durante90 dias a partir de la fechade compra,si este producto se utiliza algunavez para finescomercialeso de alquile
ページ17に含まれる内容の要旨
• Apague laaspiradora antes de desenchufarla.• Esta aspiradora tiene aislamiento doble, Iocual • Para reducir elriesgo de lesiones debidas aun elimina lanecesidad de un sistema independiente arranque accidental, desenchufe elcordon de de conexiOn atierra. Utilice anicamente piezas de energia antes de cambiar olimpiar elfiltro. repuesto id_nticas. Lea las instrucciones de servicio • No desenchufe laaspiradora tirando del cordon. Para de revision de las aspiradoras para mojado/seco con aislamiento
ページ18に含まれる内容の要旨
Introducci6n Estaaspiradoraparamojado/seco est,.dise_ada Leaestemanualdel operadorparafamiliarizarse solamenteparausodom6stico.Sepuedeutilizar conlascaracteristicasdelproductoy paraentender la utilizaci6nespecificadesu nuevaaspiradorapara pararecogermaterialesmojadoso secosy se puedeusarcomo soplador. mojado/seco. Indice Articulo P;_gina Articulo P;_gina Garantia ............................... 16 Recogidadeliquidosconlaaspiradora.... 22 Vaciadodeltambor .................... 22 Instruccionesdese
ページ19に含まれる内容の要旨
Ensamblaje (continuaci6n) Ensamblajedelas ruedecillas/patas Ensamblajedela aspiradora 1. Alineela partedelantera(lado de laetiquetay para ruedecilla el interruptor) del ensambiajedel motor con ia 1. Quiteel ensamblaje del motor deltamborpara tapadel drenajey el orificio deaspiraci6n polvoy p6ngaloa unlado. ubicadosen ia partedeianteradel tambor. 2. Pongaeltamborparapolvoenposici6n invertidasobreel piso. Nora:Elensamblajedel motor debeestar alineado 3. Introduzca laspataspararuedecilla enla parte
ページ20に含まれる内容の要旨
Ensamblaje (continuaci6n) Introduzcala manguera Introduzcael extremodefijaci6ndela manguera "Pos-I-Lock ®"enla entradadela aspiradora.La mangueradeberiaacoplarsea presi6nensu sitio. Parasacarla mangueradelaaspiradora,oprimael bot6ndeliberaci6nubicadoenelensamblajedela mangueraytire dela manguerahastasacarladela entradadela aspiradora,dela maneraquese muestraenlailustraci6n. dealmacenamiento Oprima el bot6n Botbnde ytire de la de2-1/2 pulgadas liberacibn manguera j Manguera Ensamblaje _)del motor
