ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Important Safety Information GENERAL SAFETY INSTRUCTIONS Important Safety Information 1. Read instructions. Read the safety and operating instructions before operating the Explanation of symbols used in this manual and on the product: appliance. 2. Retain instructions. Retain the safety and operating instructions for future reference. This symbol is intended to alert the user to the presence of uninsulated dangerous voltages within the enclosure of sufficient magnitude to cause 3. Heed warnings.
ページ4に含まれる内容の要旨
12. Power cord protection. Route power cords so that they are not likely to be walked UK USERS PLEASE READ THIS IMPORTANT SAFETY INFORMATION on or pinched by items placed upon or against them, paying particular attention to Fuse replacement cords at plugs, power sockets, and at the point where they exit from the appliance. This appliance is fitted with a non-rewireable 13 Amp mains plug. The plug contains a 5 Amp fuse. If the fuse has blown it can be replaced as follows: 13. Protective attachmen
ページ5に含まれる内容の要旨
Important Safety Information to correct the interference by one or more of the following measures: CE Declaration of Conformity ● Increase the separation between the equipment and receiver. Linn Products Ltd declare that this product is in conformance with the Low Voltage ● Connect the equipment into an outlet on a circuit different from that to which the Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC as amended by receiver is connected. 92/31/EEC and 93/68/EEC. ● Consult the d
ページ6に含まれる内容の要旨
Copyright and Acknowledgements Copyright © 2002 Linn Products Ltd Linn Products Limited, Floors Road, Waterfoot, Glasgow, G76 OEP, Scotland, United Kingdom All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of the publisher. Printed in the United Kingdom. Trademarks used in this publication:“Linn” and the “
ページ7に含まれる内容の要旨
Contents Contents Playing Discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Front panel display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 Discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Basic operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20 Surro
ページ8に含まれる内容の要旨
Contents (continued) CONNECT Feature . . . . . . . . . . . . . . . . . . . . . . . . . . .40 Tuner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30 About CONNECT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40 Tuning functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30 Setting up a CONNECT system . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40 AM and FM band selection . . . . .
ページ9に含まれる内容の要旨
Introduction Surround sound Introduction The Classik Movie System is equipped with circuitry for processing the audio signal on Discs discs marked with the following logos: The following types of disc can be played on the Classik Movie System: Type Contents Size DVD video audio + video (MPEG2) 8cm / 12cm CD audio 8cm / 12cm CD-R CD-RW For details on the surround sound modes, see Surround sound modes in Playing Discs chapter. Important Note: Disc formats Whilst every effort has been made to ensur
ページ10に含まれる内容の要旨
Positioning Connecting You can position your Classik Movie System almost anywhere you find convenient, but This chapter describes how to install your Classik Movie System and how to connect it to please consider the following points: speakers, TV etc. ● Allow at least 10cm of space to the sides, rear and above the Classik Movie System NOTE: for air circulation. In the manual ‘TV’ refers to projection TVs and monitors as well as televisions. ● Never block the ventilation holes on the top and side
ページ11に含まれる内容の要旨
Connecting Back panel European version 1 2 4 5 6 7 8 9 10 11 3 12 - + 14 17 13 15 16 18 1 11 IR OUT 1, 2 Infrared flasher connectors Voltage selector Allow the control via the handset of auxiliary devices that accept infrared signals. 12 MAINS INPUT 2 MAIN RX TX CONNECT LED indicators Indicate signals being transmitted between units in a CONNECT system. 13 Speaker output connectors Amplified output for direct connection to speakers. 3 ACC KNEKT connector For installing unit in a KNEKT syste
ページ12に含まれる内容の要旨
Back panel US version 1 2 4 5 6 7 8 9 10 11 12 3 13 - + 18 14 15 16 17 1 11 IR OUT 1, 2 Infrared flasher connectors TV input and output connectors Allow the control via the handset of auxiliary devices that accept infrared signals. 12 Voltage selector 2 MAIN RX TX CONNECT LED indicators Indicate signals being transmitted between units in a CONNECT system. 13 MAINS INPUT 3 ACC KNEKT connector 14 Speaker output connectors For installing unit in a KNEKT system. Amplified output for direct c
ページ13に含まれる内容の要旨
Connecting Connecting the aerials Connecting the Classik Movie System Connect the supplied AM and FM aerials as shown. Connecting the Classik Movie System to other components For the best performance, connect the Classik Movie System to other available components following the diagram below. SPEAKERS TITLE/BAND TV CLASSIK MOVIE SYSTEM IR SENSOR CLASSIK MOVIE SYSTEM Connecting to a TV (European version) VCR If your TV is fitted with an S-video input socket, connect as shown. SET-TOP BOX TO S VIDE
ページ14に含まれる内容の要旨
Connecting to a TV (US version) Connecting to a VCR (European version) Connecting the Classik Movie System to your VCR depends on the connections available If your TV is fitted with an S-video input socket, connect as shown. on the VCR. See your VCR’s instruction booklet for guidance. TO S VIDEO INPUT OF TV OR FROM S VIDEO OUTPUT ON VCR FROM VCR SCART SOCKET If your TV does not have an S-video input socket, connect the Classik Movie System to the TV as shown. COMPOSITE COMPOSITE Connecting to a
ページ15に含まれる内容の要旨
Connecting Connecting to speakers Connecting to an external power amplifier If you are not using an external power amplifier and are therefore connecting speakers If you are using an external power amplifier to feed audio signals to your speakers, directly to the Classik Movie System, follow the diagram below. follow the diagram below. TO POWER AMP INPUTS TO RIGHT TO LEFT TO RIGHT TO CENTRE TO LEFT FRONT SURROUND SURROUND FRONT SPEAKER SPEAKER SPEAKER SPEAKER SPEAKER - TO POWER AMP + OR ACTIVE S
ページ16に含まれる内容の要旨
Front Panel and Handset Front panel 5 6 1 2 15 16 23 17 18 3 4 14 10 TITLE/BAND IR SENSOR CLASSIK MOVIE SYSTEM 9 8 12 11 13 7 21 22 20 19 1 Disc drawer 14 ‘adjust’ Selects a function to be adjusted and also modifies the function of the VOL - / + keys. 2 Front panel display 15 / (stop/eject) Stops a disc playing. Opens/closes the disc drawer. 3 (mute) Mutes/unmutes the sound to the speakers and headphones. 16 TITLE/BAND Enters a DVD title menu. Switches tuner band. 4 SURROUND Selects a surro
ページ17に含まれる内容の要旨
Front Panel and Handset Handset 1 LEDs Indicate when a signal is being transmitted from the 23 Digits 0-9 / Shifted functions*** Numeric keys. Access to handset. certain additional functions.*** 2 24 DISP (display) Changes the time display on the front panel SHIFT Allows access to additional function on certain keys. when playing discs. 25 1 22 TUNER Selects tuner mode. 3 GOTO For jumping to a particular title, chapter, track or time 26 AUX For selecting auxiliary input/output sources. 2
ページ18に含まれる内容の要旨
To access the setup menus:* Setup Menus Ensure your TV is on and tuned to the Classik Movie System’s video output signal. About the setup menus ● Press SETUP on the front panel or handset.Your The on-screen setup menus enable you to configure your Classik Movie System to suit TV screen shows the SETUP MENU - MAIN PAGE. the number and size of your speakers, the picture format of your TV and much more. It is essential that you use the setup menus to inform the Classik Movie System about components
ページ19に含まれる内容の要旨
Setup Menus 2. Press ‘enter’ on the front panel or handset. The 2. Press ‘enter’ to return to the SETUP MENU - MAIN PREFERENCES PAGE menu is displayed. PAGE. 3. Use the key to highlight the EXIT SETUP option. Press ‘enter’. 3. Use the key to move to the DISC MENU option. The language options are displayed. Some changes made in the setup menus will be implemented immediately, others will be implemented after exiting setup. GENERAL SETUP TV DISPLAY 4. Use the key to move to the first language opti
ページ20に含まれる内容の要旨
PICTURE MODE SCREEN SAVER If when viewing a DVD the screen image flickers, If a still image is displayed on your TV screen for too choose a different option; either AUTO (suitable for long, damage to your screen can result. Setting to ON most DVDs), HI-RES (high resolution) or N-FLICKER activates a screen saver (a blank screen) after three (non-flicker). minutes. Press ‘enter’ on the front panel or handset to remove the screen saver. ANGLE MARK VIDEO OUT If set to ON, the symbol appears on the s
