ページ1に含まれる内容の要旨
OPERATION MANUAL
Cilo C-101DVD-Player
ページ2に含まれる内容の要旨
02
ページ3に含まれる内容の要旨
Tableofcontents Before use Programme 15 Zoom 15 Table of contents 3 NTSC/PAL 16 Safety precautions 4 Volume and Mute 16 Important safety notices 5 Mode 16 Important information 7 Menu 16 Suitable discs 8 Title 16 Disc protection 9 Angle 16 Audio 16 Control and connection Special features Normal connection 10 Front panel 12 JPEG 17 Remote control 13 Mp3 discs 17 Normal playback Reference Preparation 14 System setup 18 Normal playback 14 Troubleshooting 22 Pause 14 DVD characteristics 23 Stop play
ページ4に含まれる内容の要旨
Safety precautions A triangle with a lightning symbol draws the user's attention to “dangerous voltage” without insulation in the housing which may be high enough to entail a risk of electric shock. A triangle with an exclamation mark draws the user's attention to important instructions for use and maintenance in the accompanying manual which should be studied. Symbol for Class II (double insulation). TO MINIMISE THE RISK OF FIRE AND ELECTRIC SHOCK,DO NOT EXPOSE WARNING: DEVICE TO RAIN OR MOISTU
ページ5に含まれる内容の要旨
Impor tant safety notices WARNING: IT IS IMPORTANT THAT YOU STUDY AND OBSERVE BOTH THE INSTRUCTIONS IN THIS MANUAL AND THE INSTRUCTIONS ON THE DEVICE. KEEP THIS MANUAL FOR FUTURE USE. This device was developed and made with a view to providing maximum safety for the user. Incorrect use of the device may cause electric shock or fire. The protection built into this device will protect the user if the procedure below is observed in connection with installation, use and repair. This device is fully
ページ6に含まれる内容の要旨
Impor tant safety notices Lightning Discs Unplug the device for additional Do not use scratched, deformed or protection during thunder or when repaired discs. Such discs will break the device is not used for prolonged easily and may cause serious injury periods. This will prevent damage to and damage to the device. the device from lightning and surges. Damage Penetration of objects and liquid Unplug the device and contact skilled technicians in the Never push any objects through the following ca
ページ7に含まれる内容の要旨
Impor tant information Handling instructions Condensation Condensation may occur in the following cases: The DVD player's top and back panel may become warm after prolonged use. This is not due When the DVD player is moved directly from a to a defect. cold to a warm place. When the DVD player is not used, remove the When the DVD player is used in a room where disc and turn off the device. the radiator has just been switched on or where the cold air from the air condition plant is directed If the
ページ8に含まれる内容の要旨
suitable discs The following discs can be used: DISC’S MARKING CONTENTS DIMENSION DivX * * No other discs than those mentioned above cannot be used. Non-standard discs cannot be used, not even when marked as above. The quality of a CD-R, CD-RW, DVD-R, DVD+R, DVD-RW, DVD+RW, or DVD-RAM depends on the way the CD was recorded. In some cases, the quality can be very poor. DivX version: 3.11, 4.xx, 5,xx * 08
ページ9に含まれる内容の要旨
Disc protection and accessories Disc handling Storing the discs Do not store the discs where they may be Do not touch the playback side of the disc exposed to direct sunlight or where they are close Do not put paper or tape on the disc to sources of heat. Do not store the discs where they may be exposed to moist or dust, for example in a bathroom or close to a humidifier. Store the discs standing in a cassette. If the cassettes are stacked or an object is placed on the cassettes, the discs may b
ページ10に含まれる内容の要旨
Normal connection Back panel Y Pb/Cb Pr/Cr DVD PLAYER MODEL:CiloC-101 ITEM NO.: 11097.01 POWER SOURCE: 220-240V~50/60Hz POWER CONSUMPTION: 25W MAX SERIAL NO.: S-VIDEO VIDEO RIGHT LEFT COAXIAL OPTICAL SCART OUTPUT 12 456 3 7 8 1. Component video output 5. Composite video output 2. 5.1 channel audio output 6. Scart output 3. Coaxial output 7. Main power input 4. S-video output Normal connection Connection to television set through scart cable DVD PLAYER MODEL:CiloC-101 ITEM NO.: 11097.01 POWER SOU
ページ11に含まれる内容の要旨
To Pr/Cr video output To Pr/Cr video output To Pb/Cb video output To Pb/Cb video output To Y video output To Y video output Connect either Normal connection Connection to an analogue surround system and a TV with a component YUV video input. Y Pb/Cb Pr/Cr D MODEL:CiloC-101 ITEM NO.: 11097.01 POWER SOURCE: 220-2 POWER CONSUMPTION SERIAL NO.: S-VIDEO VIDEO RIGHT LEFT COAXIAL OPTICAL SCART OUTPUT To Y video input To Pb/Cb video input To audio inputs of the amplifier To Pr/Cr video input Note: Downm
ページ12に含まれる内容の要旨
front panel Front panel STANDBY PLAY/PAUSE STOP PREVIOUS NEXT OPEN/CLOSE HEADPHONE VOLUME - VOLUME + 12 3 4 5 6 789 7 10 1. Standby LED 6. Previous 2. Standby 7. Headphone volume 3. Play/Pause 8. Next 4. Headphones 9. Open/Close 5. Stop 10. DVD tray 12
ページ13に含まれる内容の要旨
Remote control Remote control No.: Function Page 1. STANDBY 14 2. PROGRAM 15 1 17 3. DISPLAY 15 18 2 4. A-B 15 3 19 4 20 5. REPEAT 15 5 21 6. 0-9 DIGITS -- 7. AUDIO 16 6 8. ANGLE 16 9. MODE 16 22 10. SLOW 15 23 11. SCROLL UP 20 24 7 12. ENTER 14/20 8 25 13. SCROLL LEFT 20 14. STOP 14 26 9 15. FAST REVERSE 14 10 27 16. PREVIOUS 14 11 17. OPEN/CLOSE 14 12 13 18. TITLE 16 28 19. MENU 16 29 20. L/R -- 21. SETUP 20 14 30 22. +10 -- 15 31 16 23. TIME 15 32 24. SUBTITLE 16 25. ZOOM 16 26. PAUSE 14 27.
ページ14に含まれる内容の要旨
Normal playback Preparation Stop playback When you wish to watch a DVD film, switch on the 1. Press the STOP button to stop the playback. The TV-set and choose the video input connected to the start logo will reappear on the TV screen. Some DVD player. discs offer the possibility of resuming playback When you wish to listen to the disc from the audio from the same spot, for example DVDs and music system, switch on the audio system and choose the CDs. input connected to the DVD player. 2. Press P
ページ15に含まれる内容の要旨
Advanced playback IMPORTANT All descriptions refer to DVDs. Function and display may vary if other types of discs are used. VIDEO MODE REPEAT The video output can be set to “YUV”, "CVBS”, Press REPEAT once to choose on-screen which or “RGB”. chapter to repeat. Press once more to choose the title to be repeated, and press a third time to choose to repeat all, and four times to cancel the OSD (On Screen Display) repetition. Press DISP to switch between “title played”, “title left”, “chapter played
ページ16に含まれる内容の要旨
Advanced playback ZOOM MENU Press this button to see the main menu and make Press this button to enlarge the picture. The size of the desired choice. (This button can be used for the picture changes every time the button is DVDs with multi-layer menu. Make the desired pressed. choice). NTSC/PAL TITLE Choose between PAL, NTSC, and multi through the setup menu. In the multi function, the device will find On some DVDs, the title menu will be shown when the right system. this button is pressed. Numb
ページ17に含まれる内容の要旨
Special features Playing JPEG files JPEG files contain picture information which can be encoded by micro computer software and transmitted to the TV screen via a video output interface. This function is useful in many contexts. For example teachers can change pictures to be shown in the classroom to JPG files by means of a digital camera or a scanner which are often used within the IT world and transfer the pictures to CD-R discs. This will make things easier for the pupils when the teachers pla
ページ18に含まれる内容の要旨
System setup ANGLE MARK DVD SETUP MENU When a DVD enabling multiple camera angles is used, the user can select a certain camera angle When you press the SETUP key on the remote by means of the ANGLE key on the remote control. control, the setup menu will be displayed. However, the function must be activated first. The ANGLE MARK setting must be “ON”, if you want When you have entered the setup menu, press the unit to support multiple camera angles. the Scroll buttons to navigate and select the i
ページ19に含まれる内容の要旨
System setup SCREEN SAVER SPDIF SETUP If the unit is not used for 2 minutes, the screen Here you set up the digital sound format that saver will be activated. This will prolong the comes from the co-axial or optical output on the service life of the connected TV set. The screen back panel. This signal is used when the unit is saver is preset to “ON”. connected to a digital surround receiver. OFF: Closes the digital outputs. RAW: Opens for the pure, non-modulated digital signal. PCM: Stands for P
ページ20に含まれる内容の要旨
System setup DYNAMIC RANGE COMPRESSION CVBS: Composite video output through the To avoid disturbing the neighbours at night, you Scart output. can use this function to reduce the sound RGB: RGB output through the Scart output. effects volume without changing the original Component: Component video output through tone. the component video outputs on the back panel. Note: This output may allow both Interlace Scan and Progressive Scan. You switch between IS and PS by means of the MODE key on the re
