ページ16に含まれる内容の要旨
For the first 30 seconds after the power plug is in- serted into the wall outlet, the unit will check the OPERATION condition of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash green, orange and red. MAIN UNIT OPERATION Main Unit Controls • AUTO • SILENT • MEDIUM • HIGH • MAX • POLLEN Plasmacluster Indicator Light Plasmacluster MODE-ON / OFF Button The unit will start operating when the MODE-ON / OFF Button is pressed. The unit will begin operatin
ページ17に含まれる内容の要旨
Operations available with the Remote Control • AUTO • MANUAL • POLLEN • OFF TIMER REMOTE CONTROL OPERATION • DISPLAY ON/OFF Plasmacluster ion mode • When you press the POWER ON/OFF Button, a short beep will selections sound and operation will start. As the initial operation mode, it • AUTO automatically goes to the AUTO (Fan level) and AUTO • CLEAN Plasmacluster ion Mode. • ION CONTROL • OFF •To stop operation, press the POWER ON/OFF Button again. A long beep will sound and operation will stop.
ページ18に含まれる内容の要旨
CARE AND MAINTENANCE WASHABLE ACTIVE CARBON FILTER CARE Allow the filter to 3 HAND WASH ONLY! soak approxi- mately 30 min- DO NOT TUMBLE DRY! utes before washing. Care Cycle If the filter surface is When the Filter Indicator Light very dirty, scrub with comes on, this indicates that the fil- an old toothbrush or ter needs to be cleaned. If the unit the like. is kept on 24 hours a day then the Filter Indicator Light will activate in about 2 months. CAUTION The Filter Indicator Light is for ref- e
ページ19に含まれる内容の要旨
FILTER CLEANING Clean the top surface of the Pre-Filter Dry the filter out- 6 lightly with a vacuum cleaner. doors if possible in a well ventilated Pre-Filter area. CAUTION • Let the filter dry thoroughly. If used while the filter is still moist, then the air that is exhausted from the main unit will have an odor. It may take 1 or 2 days to dry. • Dry the filter outdoors in a well ventilated area. If dried indoors, it may give an odor. In addi- NOTE tion, the water dripping off the filter may so
ページ20に含まれる内容の要旨
CARE AND MAINTENANCE (To maintain optimum performance of this product, please clean the unit including its sensors and filters periodically.) When cleaning the unit, be sure to unplug the power cord, and never handle the plug with wet hands. Electrical shock and/or bodily injury may occur as a result. DUST SENSOR MAIN UNIT ODOR SENSOR To prevent dirt or stains on the The maintenance cycle for both the Odor and Dust main unit, clean as often as nec- sensors is every 3 months. essary. If stains a
ページ1に含まれる内容の要旨
R
FP-N60CX
AIR PURIFIER
OPERATION MANUAL
PURIFICATEUR D’AIR
MANUEL D’UTILISATION
Floor / Tabletop type
Type mobile
*Plasmacluster is a trademark of
Sharp Corporation.
*Plasmacluster est une marque de
commeree de Sharp Corpration.
FRANÇAIS ENGLISH
ENGLISH
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ENGLISH FEATURES CONTENTS Plasmacluster Ion Control • FOR YOUR PROTECTION (U.S.) ...............E-2 The unit controls the ratio of negative ions • CONSUMER LIMITED WARRANTY (U.S.) .E-3 and positive ions depending on the con- • FOR YOUR PROTECTION (CANADA) .......E-4 dition of the room. • LIMITED WARRANTY (CANADA) ...............E-5 • Clean Mode SAFETY PRECAUTIONS ........................ E-6 Approximately the same numbers of posi- • RISK OF ELECTRIC SHOCK ......................E-6 tive and negat
ページ4に含まれる内容の要旨
FOR YOUR PROTECTION (the United States) To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the back side of the unit. MODEL NUMBER SERIAL NUMBER DATE OF PURCHASE Dealer Name Address City State Zip Telephone TO PHONE: Dial 1-800-BE-SHARP (237-4277) for: SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION TO WRITE:
ページ5に含まれる内容の要旨
CONSUMER LIMITED WARRANTY CONSUMER LIMITED WARRANTY FOR THE U.S. USERS SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the “Product”), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the per
ページ6に含まれる内容の要旨
FOR YOUR PROTECTION (Canada) To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the back side of the unit. MODEL NUMBER SERIAL NUMBER DATE OF PURCHASE Dealer Name Address City Province Postal Code Telephone TO PHONE: Dial 1-905-568-7140 for: SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION TO WRITE: For servic
ページ7に含まれる内容の要旨
T H R O U G H T C S U E S B T O E H R LIMITED WARRANTY Consumer Electronics Products Congratulations on your purchase! Sharp Electronics of Canada Ltd. (hereinafter called “Sharp”) gives the following express warranty to the first con- sumer purchaser for this Sharp brand product, when shipped in its original container and sold or distributed in Canada by Sharp or by an Authorized Sharp Dealer: Sharp warrants that this product is free, under normal use and maintenance, from any defects in materi
ページ8に含まれる内容の要旨
SAFETY PRECAUTIONS RISK OF ELECTRIC SHOCK • These servicing instructions are for use by qualified personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating in- structions unless you are qualified to do so. •To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the p
ページ9に含まれる内容の要旨
CAUTIONS CONCERNING THE OPERATION OF THIS PRODUCT • Do not block the intake and air outlet. • Do not use the unit near or on hot objects, such as a stove. Also, do not use the unit where it may come into contact with steam. • Do not use the unit on its side. Deformation, malfunction and/or overheating of the motor may occur as a result. • Do not install when there is generation of oily residue, such as in a kitchen. • Do not use detergent when cleaning the unit. The unit surface may become damag
ページ10に含まれる内容の要旨
PART NAMES AUTO Operation Fan Level Indicator MAIN UNIT DISPLAY Indicator Light Light OFF Timer Display Indicator Lights (set using remote control) AUTO SILENT MED HIGH MAX Filter Indicator Light If the Filter Indicator Light is lit, the Washable Active Carbon Filter needs to be cleaned. OFF TIMER PLASMACLUSTER INDICATOR LIGHT FILTER CLEAN-SIGN Plasmacluster ion operation is selected using the remote control. Blue light When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmaclus
ページ11に含まれる内容の要旨
Pollen Mode Indicator CLEAN-SIGN LIGHT Light The color changes according to the air condition. Clean (Green) Slightly Impure (Orange) Very Impure (Red) CLEAN-SIGN CLEAN-SIGN CLEAN-SIGN HIGH MAX POLLEN ABOUT THE CLEAN-SIGN • The sensors display a CLEAN-SIGN depending on relative changes to the environment from the time the power plug is inserted into the h wall outlet and thereafter. • When the air is extremely impure at the time the power plug is in- serted, the CLEAN-SIGN LIGHT may light green
ページ12に含まれる内容の要旨
PART NAMES BACK Purified Air Louver Handle • The purified air discharge can be changed Air Outlet to the directions indicated by the arrows as desired. Power Cord Power Plug ACCESSORIES Remote Control (1 unit) Battery (AA battery X 2) • Operation Manual E-10
ページ13に含まれる内容の要旨
PREPARATION INSERTING BATTERIES IN THE REMOTE CONTROL Remove the back cover 1 Press and slide the back cover to re- move. Insert batteries 2 Insert batteries with and as shown below. Close the back cover 3 Battery Information • The batteries for this remote control are for initial use only . Change the batteries when necessary. • Incorrect usage of the batteries may cause battery fluid leakage and/or damage. Take care of the following when handling: • When replacing the batteries, replace both
ページ14に含まれる内容の要旨
• Be sure to remove the power plug from the wall outlet. PREPARATION Be sure to remove the power plug from the wall outlet. FILTER INSTALLATION To maintain the quality of the filters, they are placed in the main unit within plastic bags. Be sure to remove the filters from the plastic bags before using the unit. Filter Removal 1 Place the unit facing up. 1 Lay the unit on a flat surface such as a table, making sure not to pinch the power cord on the rear of the unit. Table Soft cloth 1 Front Pane
ページ15に含まれる内容の要旨
outlet. Filter Installation 2 Tabs After the True HEPA Filter is re- 1 moved from the plastic bag, place it within the Filter Frame with the tabs facing up. True HEPA Filter (See the diagram to the right.) Filter Frame Ensure that the filter is installed correctly. Do not install the filter backwards or the unit will not operate properly. Washable Active Carbon Filter After removing the Washable 2 Active Carbon Filter from the plastic bag, place it within the True HEPA Filter Filter Frame on top
