ページ1に含まれる内容の要旨
ATD‐80351
SABER II 15W CORDED UNDERHOOD LIGHT
USER’S MANUAL
FEATURES:
• 30 Super Bright SMD LEDs
• 18/2 SJTOW 25ft cord remains flexible in cold weather and water resistant
• ABS handle with double injection, impact protection and ergonomic design provides comfortable usage
• Aluminum alloy hook with PVC cover for protection, soft coated padded hooks help prevent scratching
of the vehicles surface
• The bar extends from 47" to 70" and easily attaches to most SUV's and truc
ページ2に含まれる内容の要旨
General Safety Warnings: WARNING: The instructions and warnings contained in this manual should be read and understood before using or operating this tool. Do not allow anyone to use or operate this tool until they have read this manual and have developed a thorough understanding of how this tool works. Failure to observe any of the following instructions could result in severe personal injury to tool user and bystanders, or cause damage to the tool and property. Keep this manual
ページ3に含まれる内容の要旨
WARNING: Grounded tools must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances. This tool is equipped with a 3‐prong plug and a 3‐wire grounding system. Never remove the grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. NOTE: Double insulated tools are equipped with a polarized plug (one blade is wider th
ページ4に含まれる内容の要旨
NOTE: The table below shows the correct size to use according to cord length and the amperage draw of the tool (specified on the nameplate). When in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord. (AWG = American Wire Gauge). Minimum Gauge for Extension Cords (AWG) (when using 120 volts only) Ampere Rating Total Length of Cord in Feet (meters) More Than Not More Than 25' (7.6m) 50' (15m) 100' (30.4m) 150' (45.7m) 0 6 18 16 16 14 6
ページ5に含まれる内容の要旨
Operating Instructions: • To use, plug the unit into any 110-120 VAC power source, such as a wall receptacle. • Press the on/off switch (l) to turn unit on, press the other side of switch (0) to turn it off. • The hooks can be adjusted by simply pulling out on them and affixing to whatever surface you like, such as a car hood. (Up to 70” wide) • Once your light is in place, it can be rotated to the desired position by simp
ページ6に含まれる内容の要旨
ATD-80351 ITEM# ORDERING PART# PART DESCRIPTION ITEM# ORDERING PART# PART DESCRIPTION 1 PRT80351-01 PULL ROD 12 PRT80351-12 BRIGHTNESS INDICATE BOARD 2 PRT80351-02 SCREW M5X9 13 PRT80351-13 POWER CORD 3 PRT80351-03 LEFT HANDLE SET 14 PRT80351-14 SWIVEL SHAFT 4 PRT80351-04 SCREW M3X5 15 PRT80351-15 POSITION BLOCK 5 PRT80351-05 PROTECTING COVER 16 PRT80351-16 LAMP HOLDER 6 PRT80351-06 LED PCB 17 PRT80351-17 PRESSURE SPRING 7 PRT80351-07 CLEAR TUBE LOWER 18 PRT80351-18 DRIVER 8 PRT80351-08 SCREW 2.
