ページ1に含まれる内容の要旨
ASKO
XL TALL TANK
DISHWASHER
INSTALLATION
INSTRUCTIONS
A A A A AUT UT UT UT UTOMA OMA OMA OMA OMATIC HIGH L TIC HIGH L TIC HIGH L TIC HIGH L TIC HIGH LOOP OOP OOP OOP OOP
T T The dr he dr he drain hose is f ain hose is f ain hose is fastened to the bac astened to the bac astened to the back k k
T The dr he drain hose is f ain hose is fastened to the bac astened to the back k
of of of of of the mac the mac the mac the mac the machine a hine a hine a hine a hine at the best height. t the best heig
ページ2に含まれる内容の要旨
INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION Read these instructions carefully and completely before If you are replacing an old dishwasher, you must check you install the machine. The installation should be the plumbing connection and wiring before you move carried out by a qualified person who is familiar with all the new dishwasher into place. local codes and ordinances for electrical and plumbing connections. NOTE: Cosmetic damage must be reported to the ASKO dealer with
ページ3に含まれる内容の要旨
DIMENSIONS DIMENSIONS DIMENSIONS DIMENSIONS DIMENSIONS UNIT DIMENSIONS UNIT DIMENSIONS UNIT DIMENSIONS UNIT DIMENSIONS UNIT DIMENSIONS US Metric Measurements Measurements Height 34" - 37" 864 - 939 mm Width 24" 610 mm Depth 23-5/8" 600 mm Depth w/door open 48” 1219 mm Weight 104 lb 48 kg 48" 1219 mm 24" 23-5/8" 610 mm 600 mm Door 6-1/4" 2-1/4" 1½” 159 mm 57 mm 38 mm PREP PREP PREPARING ARING ARING THE L THE L THE LOCA OCA OCATION TION TION PREP PREPARING ARING THE L THE LOCA OCATION TION The bes
ページ4に含まれる内容の要旨
CORNER INST CORNER INST CORNER INST CORNER INST CORNER INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION INST INST INST INST INSTALLING ALLING ALLING ALLING ALLING THE THE THE THE THE TIP GU TIP GU TIP GU TIP GU TIP GUARDS ARDS ARDS ARDS ARDS (OPTIONAL) (OPTIONAL) (OPTIONAL) (OPTIONAL) (OPTIONAL) If the dishwasher is installed in a corner, there must be When it is not possible to fasten the dishwasher to the a minimum clearance of 2” (50 mm) from the side wall cabinet, you should install tip
ページ5に含まれる内容の要旨
DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS ASKO provides a 7/8” (22 mm) corregated drain hose THREE THREE THREE THREE THREE W W W W WA A A A AY Y Y Y YS S S S S T T T T TO INST O INST O INST O INST O INSTALL ALL ALL ALL ALL which is connected to the back of the unit to form a high DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS DRAIN CONNECTIONS loop. If additional drain hose is the added hose and any joints or connections ca
ページ6に含まれる内容の要旨
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS WARNING! Before working on wiring for any WARNING! electrical appliance, be sure the electrical power Do not use an extension cord for this appliance. has been turned off at the breaker/fuse box. WARNING! Disconnect electrical power supply and place a tag at the disconnect switch indicating that you are working on the circuit. WARNING! Electrical and grounding connections must compl
ページ7に含まれる内容の要旨
MO MO MO MO MOVING VING VING VING VING THE MA THE MA THE MA THE MA THE MACHINE INT CHINE INT CHINE INT CHINE INT CHINE INTO PLA O PLA O PLA O PLA O PLACE CE CE CE CE WARNING! Make sure you put the protective slides on the legs to prevent damaging the floor when you slide the unit into place (see page 6). 1. Position the machine in front of the cabinet opening. 2. Make the height adjustment while the dishwasher is in front of the opening. 3. Pull out the drain hose to ensure there are no sharp be
ページ8に含まれる内容の要旨
CONNECTING THE ELECTRIC CABLE CONNECTING THE ELECTRIC CABLE CONNECTING THE ELECTRIC CABLE CONNECTING THE ELECTRIC CABLE CONNECTING THE ELECTRIC CABLE If the cord is not long enough, or if a hard-wire installation is needed, follow the steps below to complete the electrical connection. 4. Connect ground wire to ground connection screw WARNING! Before starting this procedure, be sure on the bottom. the power is turned off at the breaker/fuse box. 1. Connect supply cable with a UL-listed strain re
ページ9に含まれる内容の要旨
ADJUSTING THE LEVELING LEGS ADJUSTING THE LEVELING LEGS ADJUSTING THE LEVELING LEGS ADJUSTING THE LEVELING LEGS ADJUSTING THE LEVELING LEGS Now that all the connections are made and the machine 2. Using a 1/2” (12 mm) wrench, adjust the locking is in place under the cabinet, you should make the final nuts until the machine is height adjustment. level. (The machine may have an inclination of 1/4" 1. You should set the rear foot first. To do maximum without affecting this, use a its performance.)
ページ10に含まれる内容の要旨
FITTING THE FITTING THE FITTING THE D3252XLFI, D3532XLFI AND D3532XLFIWS D3252XLFI, D3532XLFI AND D3532XLFIWS D3252XLFI, D3532XLFI AND D3532XLFIWS FITTING THE FITTING THE D3252XLFI, D3532XLFI AND D3532XLFIWS D3252XLFI, D3532XLFI AND D3532XLFIWS CUST CUST CUST CUST CUSTOM DOOR OM DOOR OM DOOR OM DOOR OM DOOR P P P P PANEL ANEL ANEL ANEL ANEL The D3252XLFI, D3532XLFI, and D3532XLFIWS can ITEMS PR ITEMS PR ITEMS PR ITEMS PR ITEMS PRO O O O OVIDED VIDED VIDED VIDED VIDED WITH WITH WITH WITH WITH THE
ページ11に含まれる内容の要旨
MOUNTING MOUNTING MOUNTING MOUNTING MOUNTING THE THE THE THE THE W W W W WOOD P OOD P OOD P OOD P OOD PANEL ANEL ANEL ANEL ANEL 1. Locate the screw heads in the keyholes and push the wood panel to one side and align with the door. (Figure 5) 2. Clamp the wood panel to the dishwasher door to keep it securely in place. 3. Open the dishwasher door and screw the wood panel into position with the four long screws, two on either side. (Figure 6) . ADJUSTING THE DOOR SPRINGS ADJUSTING THE DOOR SPRINGS
ページ12に含まれる内容の要旨
INDEX INDEX INDEX INDEX INDEX A A A A A S S S S S Access holes 3 Slides for rear legs 6 C C C C C T T T T T Cabinet, fastening unit to 9 Technical data 2 Cabinet opening dimensions 3 Tip guards 2 Connecting to water supply 9 installing 4 Corner installation 4 Toe kick Cosmetic damage 2 installation options on FI units 11 installing 9 D D D D D Tools 2 Dimensions, unit 3 U U U U U Door panels, fully-integrated 11 Door springs, adjusting 10 Unit dimensions 3 Drain connections 4 W W
