ページ1に含まれる内容の要旨
DISHWASHER
DA 4142
152969 88/0 Instruction Book
UK
ページ2に含まれる内容の要旨
Description of the appliance 1. Water hardness adjustment 2. Upper basket stop 11 3. Upper spray arm 1 4. Salt container 5. Detergent dispenser 2 10 6. Control panel 7. Rinse aid dispenser 3 8. Filters 9. Lower spray arm 9 10. Upper basket 11. Worktop 4 8 7 5 6 IN112 The control panel 2
ページ3に含まれる内容の要旨
In daily use Check if it’s necessary to refill with special salt or rinse aid Loading cutlery and dishes Load cutlery and dishes into the dishwasher. Sponges, household cloths and any object that can Fill with dishwasher detergent . absorb water may not be washed in the dishwasher. Select a wash programme suitable for the cutlery and Before loading the dishes, you should: dishes. - Remove large left-overs. Start the wash programme. - Soften remnants of burnt food in pans When load
ページ4に含まれる内容の要旨
The upper basket Adjusting the height of the upper basket The upper basket is designed for plates (dessert plates, If washing very large plates you can load them in the lower saucers, dinner plates of up to 24 cm in diameter), salad basket after moving the upper basket to the higher position. bowls, cups and glasses. Arrange items on and Maximum height of the dishes in underneath the cup racks so upper basket lower basket that water can reach all With upper basket raised 20 cm 31 cm surfaces.
ページ5に含まれる内容の要旨
Washing programmes Programme Degree of soil Starting Required Cycle (2) Consumption values and position of the temperature description Programme Energy Water type of load programme push button duration consumption consumption (in minutes) (in kWh) (in litres) selector dial Cold prewash Intensive 65°C Heavy soil. Main wash up to 65°C 1 cold rinse 82 1,1 16 Crockery, cutlery, A 1 hot rinse pots and pans Drying Cold prewash (1) Normal soil. Main wash up to 50°C 50° Economy 50°C 1 cold rinse Crocker
ページ6に含まれる内容の要旨
570 - 600 600 Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. IN05 Proceed as follows: Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustabl
ページ7に含まれる内容の要旨
Service and Spare Parts In the event of your appliance requiring service, or if you wish Please note that a valid purchase receipt or guarantee to purchase spare parts please contact your local Service documentation is required for in-guarantee service calls. Force Centre by telephoning: 08705 929929 Customer Care Your telephone call will be automatically routed to the Service Department Force Centre covering your post code area. For the address of your local Service Force Centre and further Fo
ページ8に含まれる内容の要旨
From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. 14 billion USD in more than 150 countries around the world. © 0 04/03 Subject to change without notice Electrolux plc 2003
ページ9に含まれる内容の要旨
Instruction Book DISHWASHER - Before use - Maintenance - Installation Contents Before use 2 External cleaning 5 Setting the water softener 2 Prolonged periods of non-operation 5 Filling with salt 2 Frost precautions 5 Filling with rinse aid and adjusting the dose 3 Moving the machine 5 Use of detergent 3 Something not working 6 Hints and tips 4 Installation 7 Maintenance and cleaning 5 Water supply connections 7 Internal cleaning 5 Water outlet connection 7 Cleaning the filters 5 Electrical c
ページ10に含まれる内容の要旨
Before use Adjustment on the machine Before using your dishwasher for the AB first time: 1. Ensure that the electrical and water connections comply A with the installation instructions 1 2 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with salt 5. Fill the rinse aid dispenser. AA04 AA03 Setting the water softener Filling with salt The dishwasher is equipped with a water softener designed to Attention
ページ11に含まれる内容の要旨
Rinse aid Use of detergent Only use detergents specifically designed for use in Rinse aid is automatically added during the last rinse, dishwashers. ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds We recommend the use of Finish detergents which are about 110 ml of rinse aid, which is sufficient for 16 - 40 available in the following options: dishwashing programmes, depending upon the dosage Finish Double Action Tablets. Each
ページ12に含まれる内容の要旨
Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see "Washing Programmes" chart) so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash dishes under running water. For best washing and drying results Before loading, remove all scraps of food and soak very heavily soiled pots and pans.
ページ13に含まれる内容の要旨
Maintenance and cleaning The dishwasher must not be used without filters. Internal cleaning Incorrect repositioning and fitting of the filters will Ensure that the seals around the door, the detergent and rinse produce poor washing results. aid dispensers are cleaned regularly with a damp cloth. Cleaning the filters is vital to ensure correct operation of We recommend the use of Finish Dishwasher Cleaner every the machine. 3 months or run a 65°C wash without dishes using detergent. Regular use o
ページ14に含まれる内容の要旨
Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is in guarantee. Symptom Solution The machine will not start The door has not been
ページ15に含まれる内容の要旨
Installation Any electrical work required to install this appliance Likewise the internal diameter of the couplings used for should be carried out by a qualified electrician or connections to the waste outlet must be no smaller than the competent person. diameter of the hose provided. Any plumbing work required to install this appliance The sink plug must not be in place when the machine is should be carried out by a qualified plumber or competent draining as this could cause the water to sipho
ページ16に含まれる内容の要旨
This appliance complies with the following E.E.C. Directives: - 73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. 152981 52/3 Subject to change without notice 2 03/03
