ページ1に含まれる内容の要旨
INSTRUCTION MANUAL
G GU UIID DE E F FO OR R U US SIIN NG G T TH HE E D DIIS SH HW WA AS SH HE ER R A AN ND D T TH HE E W WA AS SH HIIN NG G P PR RO OG GR RA AM MS S
ページ2に含まれる内容の要旨
Contents 1. Safety and operating instructions ___________________________ 2 2. Installation and hook-up___________________________________ 5 3. Description of the controls _________________________________ 9 4. Operating instructions ___________________________________ 19 5. Cleaning and maintenance _______________________________ 33 6. Troubleshooting ________________________________________ 37 Thank you for choosing one of our products. You are advised to read this
ページ3に含まれる内容の要旨
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 73/23, 89/336 (INCLUDING 92/31
ページ4に含まれる内容の要旨
Safety instructions OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMEN
ページ5に含まれる内容の要旨
Safety instructions LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKE
ページ6に含まれる内容の要旨
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under con
ページ7に含まれる内容の要旨
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused. CONNECTING TO THE WATER SUPPLY Connect the intake hose t
ページ8に含まれる内容の要旨
Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION. NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD. IN THE EVENT
ページ9に含まれる内容の要旨
Installation instructions FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover A and fuse B. 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. The fuse cover must be refitted when changing a fuse a
ページ10に含まれる内容の要旨
User instructions 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on the front panel. 1 ON/OFF BUTTON 2 SELECTION PROGRAMS BUTTONS (P1...P5) 3 DELAY PROGRAM BUTTON (on some models only) 4 ½ LOAD WASH BUTTON (on some models only) 5 START/PAUSE BUTTON 6 POWER ON LIGHT 7 PROGRAMS LIGHTS 8 DELAY PROGRAM LIGHTS (on some models only) 9 ½ LOAD WASH LIGHT (on some models only) 10 PHASES/PROGRAM LIGHTS 11 NO SALT LIGHT (on
ページ11に含まれる内容の要旨
User instructions DURATION CONSUMPTION PROGRESS PROGRAM SELECTION TYPE AND GRADE DIRT PROGRAM MINUTES WATER POWER (2) LITRES (1) KWh (2) PANS AND DISHES SOAK AWAITING COMPLETION OF Cold prewash 15 6 0,03 THE LOAD Wash at 38°C DELICATE DISHES WITH QUICK Cold rinse 45 13 0,80 NORMAL DIRT Rinse at 58°C Wash at 55°C DISHES WITH NORMAL Cold rinse ECO DIRT, WASHED 100 14 1,20 Rinse at 69°C IMMEDIATELY AFTER USE Dry Wash at 65°C DISHES WITH NORM
ページ12に含まれる内容の要旨
User instructions DURATION CONSUMPTION PROGRESS PROGRAM SELECTION TYPE AND GRADE DIRT MINUTES WATER POWER PROGRAM (2) LITRES (1) KWh (2) Cold prewash Wash at 45°C + DELICATE DISHES WITH DELICATE Cold rinse 75 17 1,05 NORMAL DIRT Rinse at 69°C Dry Cold prewash DISHES WITH NORMAL Wash at 50°C BIO + DIRT, EVEN WITH DRIED-ON 180 ** ** (*) Rinse at 62°C RESIDUES Dry Cold prewash Wash at 65°C DISHES WITH NORMAL + NOR
ページ13に含まれる内容の要旨
User instructions 3.2 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded. • The spray arms are able
ページ14に含まれる内容の要旨
User instructions SELECTION PROGRAM The program selection is possible through the relative buttons (2). When the button relating to the program required is pressed, the relative light will come on to confirm the operation. START PROGRAM To start the dishwasher, press the START/PAUSE button (5) for a few seconds, until the light of the first phase of the selected program starts to flash (confirmation beep). This phase, that updates itself during the cycle,
ページ15に含まれる内容の要旨
User instructions END PROGRAM When the program finishes, a buzzer sounds briefly and all the PHASES/PROGRAM lights (10) flash. Press any of the SELECTION PROGRAMS buttons (2), stops the light flashins, and the dishwasher is now ready to perform a new cycle; opening and shutting the door or switching the appliance off and on has the same effect. INTERRUPTION OF A PROGRAM In order to interrupt a running program it is necessary: • press the START
ページ16に含まれる内容の要旨
User instructions ANNULLING A PROGRAM To annul the program in progress, it must first be interrupted (see “INTERRUPTION OF A PROGRAM”). Now press buttons P1+P2 simultaneously and the first three program lights will come on. In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupted
ページ17に含まれる内容の要旨
User instructions DELAY PROGRAM (on some models only) (available in all programs except the soak program) The PROGRAM DELAY button (3) can be pressed to delay the start of the washing program by 3, 6 or 9 hours. This function allows you to set the dishwasher to work at your preferred time of day. After selecting the delay, start the program (see relative section). The appliance will prewash the dishes, after which the "program delay" set previously will come into effect
ページ18に含まれる内容の要旨
User instructions To set the delay once the program has started, proceed as follows. If the program you wish to carry out is the same as the one already in progress: • press the START/PAUSE button (5) for a few seconds, until the PHASES/PROGRAM lights (10) come on; • annul the program in progress (see relative section) and wait for the cycle to come to an end; • select the program again; • select the delay required; • press the START/PAUSE button (5) to start the new
ページ19に含まれる内容の要旨
User instructions TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dishwasher to a hot water supply up to 60°C. • When possible, skip the drying cycle by leaving the door open when the washing cycle is complete; the air and the res
ページ20に含まれる内容の要旨
User instructions 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with
