ページ1に含まれる内容の要旨
INSTRUCTION MANUAL
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
ページ2に含まれる内容の要旨
Contents 1. Description of the controls________________________________16 2. Troubleshooting _______________________________________25 Thank you for choosing one of our products. You are advised to read this manual carefully; it contains all the information you need about the right conditions for the proper, safe use of your dishwasher. The individual sections are laid out to provide you with a step-by-step guide to all your appliance's functions; the texts are easy to understand and are complet
ページ3に含まれる内容の要旨
User instructions 1. Description of the controls 1.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming, switch-off etc. procedures are only possible when the door is open. 2 34 5 11 10 7 6 9 813 12 1 end Auto 3/1 60°-70° ON/OFF BUTTON 1 Pressing this button energises the appliance. SELECTED PROGRAM INDICATOR LIGHTS 2 Illumination of this light denotes the program selected and the occurrence of a fault (troubleshooting). PROGRAM SELECTION BUTTON 3 By p
ページ4に含まれる内容の要旨
User instructions "3/1" OPTION BUTTON (on some models only) 8 Press this button to activate the option for use of 3/1 products. "3/1" OPTION LIGHT (on some models only) 9 Illuminates to indicate that the function is activated. HALF LOAD BUTTON (on some models only) 10 Press this button to activate the half load wash option. HALF LOAD LIGHT (on some models only) 11 One of the two buttons illuminates to indicate that the half load wash option in the top or bottom basket has been selected. PROGRA
ページ5に含まれる内容の要旨
User instructions SETTING THE WASHING PROGRAM AND SWITCHING ON To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling. 2 34 5 11 10 7 6 9 813 12 1 end Auto 3/1 60°-70° After using the table to identify the most appropriate washing program: • press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; • keep pressing the PROGRAM SELECTION button
ページ6に含まれる内容の要旨
User instructions DURATION CONSUMPTION PROGRAMME, LOAD CROCKERY PROGRAM MINUTES WATER POWER NUMBER & SYMBOL AND CUTLERY PROGRESS (2) LITRES (1) KWh (2) Prewash at 45°C Very dirty Wash at 70°C pans and dishes, SUPER 5 2 cold rinses 110’ 20 1,70 even with Rinse at 70°C dried-on dirt Dry Pans and dishes _ awaiting 6 SOAK Cold prewash 16' 6 a further wash Wash at 38°C Dishes QUICK 7 Cold rinse 45' 13 0,85 with light dirt Rinse at 68°C Cold prewash Wash at 40°C Wash immediately Wash at 55°C 8 AUTO 40
ページ7に含まれる内容の要旨
User instructions TABLE FOR CERTIFICATION BODIES Reference standard EN 50242 Reference program BIO Load 14 place-settings Type of detergent B Amount of detergent 35 g Rinse aid setting 5/6 1.2 Washing programs Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded. • The spray arms are able to rotate freely and without obstruction. • The dishwasher door is secur
ページ8に含まれる内容の要旨
User instructions SELECTING HALF LOAD WASH This function is ideal for small loads and saves water and electricity. It is controlled by the HALF LOAD (10) button, with two alternatives: 1) press the button once to select washing in the top basket (the relative light comes on); 2) press the button a second time to select washing in the bottom basket (the relative light comes on); 3) press the button a third time to return to the normal full load washing mode (washing in both baskets, both lights o
ページ9に含まれる内容の要旨
User instructions "3/1" OPTION BUTTON (available in all programs except the soak program) By pressing the button (8) you activate the "3/1" option, confirmed when the relative light comes on. This option has been studied for the use of dishwashing powder or tablets with integrated substances in place of regenerating salt or rinse-aid known on the market as “3 in 1” or “triple action” products; in this case the dishwasher will use the product in an optimal way avoiding salt and rinse-aid consumpt
ページ10に含まれる内容の要旨
User instructions 2 34 5 11 10 7 6 9 813 12 1 end Auto 3/1 60°-70° ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting below to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELAY button (12) and keep it pressed until the preset value appears followed by a full stop (normally 3.). Release the button then press it again in succession to display the value required, referring to the table. The 6 setting levels available will appear in this order: 3
ページ11に含まれる内容の要旨
User instructions If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, because it might cause problems in execution of the program. END
ページ12に含まれる内容の要旨
User instructions 2. Troubleshooting The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings: FAULT DESCRIPTION Acquastop failure The anti-flooding system has been activated (for the E1 relevant models only). The system is tripped in case of water leaks. Contact the after-sales service. Safety level The system which limits the water level inside the dishwasher has been tripped. Interrupt the program
ページ13に含まれる内容の要旨
User instructions FAULT DESCRIPTION Turbine flow-regulator malfunction (for the relevant models only) The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and E7 switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service. Alternate washing system malfunction Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program
ページ14に含まれる内容の要旨
INSTRUCTION MANUAL W WA AR RN NIIN NG GS S A AN ND D R RE EC CO OM MM ME EN ND DA AT TIIO ON NS S,, G GU UIID DE E F FO OR R T TH HE E U US SE E O OF F B BA AS SK KE ET TS S A AN ND D F FO OR R C CL LE EA AN NIIN NG G D DIIS SH HW WA AS SH HE ER RS S
ページ15に含まれる内容の要旨
Contents 1. Safety and operating instructions __________________________28 2. Installation and hook-up _________________________________31 3. Operating instructions ___________________________________35 4. Cleaning and maintenance _______________________________46 Thank you for choosing one of our products. You are advised to read this manual carefully; it contains all the information you need about the right conditions for the proper, safe use of your dishwasher. The individual sections are lai
ページ16に含まれる内容の要旨
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 72/23, 89/336 (INCLUDING 92/31) CURRENTLY IN FORCE, INC
ページ17に含まれる内容の要旨
Safety instructions THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH COULD OTHERWISE BE CAUSED BY INAPPROPRIATE WASTE HANDLING OF THIS PRODUCT. THE SYMBOL ON THE PRODUCT, OR ON THE DOCUMENTS ACCOMPANYING THE PRODUCT, INDICATES THAT THIS APPLIANCE MAY NOT BE TREATED AS HOUSE
ページ18に含まれる内容の要旨
Safety instructions DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKET. TAKE CARE NOT TO CUT YOURSELF AND ENSURE THAT THEY DO NOT PROJECT FROM THE BASKET. AQUASTOP MODELS THE AQUASTOP DEVICE PREVENTS FLOODING IN THE EVENT OF A WATER LEAK. WHEN THE AQUASTOP DEVICE IS TRIPP
ページ19に含まれる内容の要旨
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw t
ページ20に含まれる内容の要旨
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused. CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” A gas thre
