ページ1に含まれる内容の要旨
DG 6145
Dishwasher
Installation and use
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Safety Is a Good Habit to Get Into NOTICE - During installation, the power supply cord must not be Carefully read the instructions contained in this manual, as excessively or dangerously bent or flattened; they provide important information which is essential to - If the appliance is not operating properly or maintenance safe and proper installation, use and maintenance of the must be performed, disconnect the appliance from the appliance. power supply. 5.Keep detergents out of the reach of chil
ページ4に含まれる内容の要旨
Close-up View (Interior) E G F H J K L I Upper Rack Bottom Sprayer Arm Top Sprayer Arm Salt Container Cap Rack Height Adjustor Washing Filter Lower Rack Detergent and Rinse Aid Dispenser Technical characteristics Width cm. 44,5 Depth cm. 60 Height cm. 85 Capacity 8 standard place settings Mains water pressure 0,2 ÷10 bar (20 Kpa÷ 1 MPa) Power voltage See data plate Total absorber power See data plate Fuse See data plate GB 2
ページ5に含まれる内容の要旨
Salt... Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If The dishwasher is designed to allow for adjusting the hard water is used in the dishwasher, deposits will form on amount of salt consumed based on the harness of the water the dishes and utensils. used. This is intended to The appliance is equipped with a special softener that uses optimize and customize the level a salt specifically designed to eliminate lime and minerals of salt consumption so tha
ページ6に含まれる内容の要旨
Detergent and Rinse Aid.... Detergent Rinse Aid Detergent specifically intended for use with dishwashers This product makes dishes sparkle and helps them to dry must be used. The dispenser must be refilled before the without spotting. The dispenser is located on the inside start of each wash cycle following the instructions provided panel of the door and should be filled after every 80 wash in the "Wash Cycle Table." The detergent dispenser is cycles (or when the rinse aid indicator light comes
ページ7に含まれる内容の要旨
Loading the Dishwasher Bottom Rack Before placing the dishes in the dishwasher, remove the Upper Rack larger food particles to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Pull out the racks to facilitate loading the dishwasher. How to Use the Lower Rack We recommend that
ページ8に含まれる内容の要旨
Turning on the Appliance Starting a wash cycle.... If you forget to load some of the dishes... 1. Make sure that the plug for the appliance is inserted into The wash cycle can be interrupted by pressing the ON-OFF the wall socket. button. You can then load additional dishes and turn the 2. Make sure that the water supply is turned on to full appliance back on. The cycle will start where it left off. pressure. 3. Load the dishwasher (see the section entitled, "Loading At the end of the wash cycle
ページ9に含まれる内容の要旨
Wash Cycle Table Cycle Description of Detergent Rinse Aid Cycle Selection Cycle Information Pre-wash with hot water Very dirty (45°C). dishes, pots and Extended wash at 65°C. pans (not to be 20 gr. * Rinse with cold water. used with Rinse with hot water at 70°C. delicate items). Drying. 1) Heavy Duty Pre-wash with cold water. Normally dirty Extended wash a 65°C. dishes, pots and Rinse with cold water. 20 gr. * pans. Standard Rinse with hot water at 70°C. 2) Normal Wash daily cycle. Drying. (IEC-
ページ10に含まれる内容の要旨
Energy Saving Tips - Use the right amount of detergent: if you use too much - It is important to try and run the dishwasher when it is detergent, the result will not be cleaner dishes, but, rather, fully loaded in order to save on energy. In order to prevent a greater negative impact on the environment. odors from forming and food from caking onto the dishes, you can run the hold cycle. - There is no utility in rinsing dishes, cookware and utensils before placing them in the dishwasher. - Choose
ページ11に含まれる内容の要旨
Cleaning and Special Maintenance Improper replacement of Filter Assembly the filters may reduce the For best performance and results, the filter assembly must performance level of the be cleaned. appliance and damage The filter efficiently removes food particles from the wash A dishes and utensils. water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing Cleaning the Spra
ページ12に含まれる内容の要旨
Installation Drain Hose Connection Positioning the Appliance Insert the drain hose into a Position the appliance in the desired location. The back drain pipe with a minimum should rest against the wall behind it, and the sides, along A diameter of 4 cm., or let it run the adjacent cabinets or wall. The dishwasher is equipped into the sink, making sure to with water supply and drain hoses that can be positioned avoid bending or crimping it. to the right or the left to facilitate proper installati
ページ13に含まれる内容の要旨
Electrical Connection Electrical Connection As the colours of the wires in the mains lead may not If your appliance is supplied with a 13 amp. fused plug it correspond with the coloured markings identifying the can be plugged into a 13 amp socket for immediate use. terminal in your plug, proceed as follows: Before using the appliance please read the instruction below. connect Green & Yellow wire to terminal market “E” or coloured Green or Green & Yellow. WARNING: THIS APPLIANCE MUST BE EARTHED.
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
Viale Aristide Merloni 47 60044 Fabriano tel. (0732) 6611 - Italy 04/99 - 195023285.00 - Xerox Business Services - DocuTech
