ページ1に含まれる内容の要旨
g
GE Consumer Home Services Training
TECHNICAL SERVICE GUIDE
Triton XL
Dishwashers
MODEL SERIES:
EDW4000 PDW7300
EDW4060 PDW7700
GSD6200 PDW7800
GSD6300 PDW7880
GSD6600
GSD6660
GSD6700
PUB # 31-9085 09/01
g
ページ2に含まれる内容の要旨
! IMPORTANT SAFETY NOTICE The information in this service guide is intended for use by individuals possessing adequate backgrounds of electrical, electronic, and mechanical experience. Any attempt to repair a major appliance may result in personal injury and property damage. The manufacturer or seller cannot be responsible for the interpretation of this information, nor can it assume any liability in connection with its use. WARNING To avoid personal injury, disconnect power before servicin
ページ3に含まれる内容の要旨
Table of Contents Table of Contents Introduction ......................................................................................................... 2 Nomenclature ...................................................................................................... 3 Control Panel Features5 Profile Models.................................................................................................4 GE Models...............................................................................
ページ4に含まれる内容の要旨
Introduction TM food particles. The Piranha hard food disposer The new Triton XL Dishwashers are packed with grinds and pulverizes any other food particles. features to get your dishes cleaner, pots and pans spotless, and keep your kitchen quieter... and with Triton XL Dishwashers run quieter thanks to our a power usage of 477 kWhr/yr, they have an TM ® QuietPower motor, PermaTuf tub, and the “EnergyStar” rating. QuietPower IV sound insulation, Thinstall. The Triton XL Dishwashers have 3 wash ar
ページ5に含まれる内容の要旨
Nomenclature Model Number P D W 7 3 0 0 G 0 0 W W Brand P = Profile E = General Electric - NATM Exterior Color G = General Electric BB = Black Product Type CC = Bisque CD - Counter Top DW = Dishwasher SS = Stainless Steel SD = Standard SC = Convertable WW = White SM = Spacemaker SS = Compact (18 in.) RF = Retrofit HD = Home Depot Derivative Engineering Model Suffix Model Designator Designates features–the higher the number, the more features. Model Year Designator Nomenclature Serial
ページ6に含まれる内容の要旨
Control Panel Features Profile Models Throughout this manual, features and appearance may vary from your model. 1 6 TIME REMAINING 3 5 4 2 Control Settings Status Indicator Lights 1 The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a malfunction (see page 6). The lights will come ON indicating the sequence of 8 operation the dishwasher is in. SENSING Displayed while the ExtraClean™ Sensor is measuring the amount of soil and temperature
ページ7に含まれる内容の要旨
COOK Heavy 11.4 gal., 95 min. WARE Medium 10.0 gal., 71 min. Light 10.0 gal., 66 min. This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils. This cycle may not remove burned-on foods. Everyday dishes are safe to be used in this cycle. NORMAL WASH Heavy 9.9 gal., 74 min. Medium 7.0 gal., 61 min. Light 5.6 gal., 48 min. This cycle is for medium/heavily soiled dishes and glassware. SPEED CYCLE Heavy 9.3 gal., 36 min. Medium 7.2 gal., 36 min. Light 5.7 gal., 33
ページ8に含まれる内容の要旨
DELAY HOURS You can delay the start of a wash cycle for up to 9 hours (on some models). Press the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle, then press START/RESET. The machine will count down and start automatically at the correct time. Pressing START/RESET a second time will cancel the DELAY START selection. NOTE: If you forget to fully close the door a reminder signal will beep until you do so. RESET To change a cycle after washing starts, touch
ページ9に含まれる内容の要旨
ExtraClean™ Sensor Selections 2 The light above the selected pad will be ON to indicate which ExtraClean™ Sensor Selection has been selected. ANTI-BACTERIA Heavy 10.0 gal., 93 min. Medium 8.6 gal., 90 min. Light 7.2 gal., 90 min. This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature of your inlet water. NOTE: The Anti-Bacteria cycle is monitored for sanitization requirements. If the cycle is interrupted durin
ページ10に含まれる内容の要旨
LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle. Children cannot accidentally start dishwasher by touching pads with this option selected. To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds. To lock the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn off. EXTRA When selected, the NORMAL WASH cycle will run longer with heatin
ページ11に含まれる内容の要旨
Component Locator Views Door View (Panel and Escutcheon Removed) Vent Driver Control Module Door Interlock (Active Vent) Flapper Switch (Active Vent) Detergent/ Rinse Agent Module Factory Test Cable Circulation Pump House Electrical Supply Flood Switch Junction Box – 9 –
ページ12に含まれる内容の要旨
Door View (Front Panel ONLY Removed) Control Module Escutcheon Keypad Latch Handle Active Vent Assembly Bottom View Circulation Pump Flood Switch Junction Box Motor FRONT FRONT Water Valve Factory Test Cable Connector Turbitity Sensor Drain Line Check Valve BACK BACK Sump Heating Drain Pump High Drain Loop Element Retaining Nuts – 10 –
ページ13に含まれる内容の要旨
Inside View Upper Spray Arm Middle Spray Arm Water Supply Connection Main Conduit Lower Spray Arm Heating Element Fine Filter Inlet Cover Hub Inside Door View Detergent/Rinse Module Detergent Compartment Vent (Active Vent) P0003687 – 11 –
ページ14に含まれる内容の要旨
Side View Drain Tube Assembly Fill Door Funnel Spring Fill Water Hose Valve Drain Line Check Valve P0003689 – 12 –
ページ15に含まれる内容の要旨
Dishwasher Components Flapper Active Vent Door Components The door components are accessible by removing 3 Phillips screws from each side of inner door and Electronic Interlock Control 2 T20 torx screws from the bottom of the door. Switch Assembly Carefully separate the inner door panel from the outer door panel. To access the active vent, flapper, and door interlock switch, the escutcheon keypad assembly must be removed. Detergent Module Escutcheon Keypad Assembly The keypad and 2 ribbon cables
ページ16に含まれる内容の要旨
Control Module 2 Tabs 1 Screw Removal 1. Remove the outer door panel (see Door Compo- nents). 2. Open the door and remove the 3 screws from the back on the right side of the escutcheon keypad assembly. 3. Remove 1 screw from the right side of the control module and slide the module out. 4. Unplug the connectors from the module. Installation P0003697 Note: The gray cable is a factory test cable (see Factory photo) and may be removed when servicing Test Cable control module. 1. Plug connectors int
ページ17に含まれる内容の要旨
Stainless Steel Bowed Panel (On Some Models) Disassembly 1. Open the dishwasher door to the fully open (89 degrees open) position. 2. Remove 8 screws (4 screws per side) which hold the outer panel to the door assembly. Be careful not to remove the 2 screws which hold Do not remove the escutcheon to the door assembly. this screw from either side. 3. Slowly close the door. 4. Once the door is closed, remove the 2 screws that connect the bottom of the outer panel to the hinge arms. 5. While holdin
ページ18に含まれる内容の要旨
sure that the protruding ribs from the escutch- eon fit inside the stainless steel front opening. Adjust the position of the outer panel up or down, left or right to center the panel with the escutcheon. 6. Once the panel is centered, install the 2 screws in the bottom of the panel to connect the stain- less steel outer panel to the hinge arms. Re- check to make sure the escutcheon ribs are protruding through the panel opening. 7. While holding the outer panel against the door assembly, slowly
ページ19に含まれる内容の要旨
Bottom Door Seal Bottom Door Seal The bottom door seal is replaceable by removing the outer door panel (see Door Components). With the door closed, insert a flat-blade screwdriver under the bottom of the door into the channel and twist to break the bead. Open the door and pull the seal from the channel. To install the seal, snap the seal into the channel, working from one side of the door to the other, until the entire bead is complete and the seal slides freely in the channel. Drain System Bott
ページ20に含まれる内容の要旨
L1 Output from J2-5 Dishwasher Doesn’t Drain DOOR DRAIN PUMP INTERLOCK RX WR WX M J2-5 N NO COM 30 Attempt to activate drain pump using service mode (refer to Service Mode chapter). YES NO Pump activate? Check for clogged: inlet cover Is L1 sump voltage drain pump present at pump? drain pipe Note: Perform this test one-way check valve with wiring connected (in drain pipe) and YES NO pump under load. Check for open circuit between Check pump for open/ control module and pump or short
