ページ1に含まれる内容の要旨
Dishwasher
Installation instructions
DW60CE and DW60CC models
and User guide
NZ AU SG
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
1 Contents Safety and warnings 3 Installation instructions 6 Introduction 14 Using your dishwasher – quick reference 15 CE models Controls and starting a wash 16 CC models Controls and starting a wash 20 Changing the wash programme 22 Setting Delay start 23 Changing the wash zone 24 User preference settings 25 Caring for your dinnerware 26 Loading 27 Water hardness and dishwashing 31 Wash programmes and detergent quantities 32 Adding detergent 33 Using rinse aid 34 After the
ページ4に含まれる内容の要旨
2
ページ5に含まれる内容の要旨
3 Safety and warnings Your dishwasher has been carefully designed to operate safely during normal dishwashing procedures. Please keep the following instructions in mind when you are using your dishwasher. Important safety instructions For your safety, follow basic precautions when using your dishwasher, including the following: Please read all instructions before operating your dishwasher. The information in this user guide must be followed to minimise the risk of fire or explosion, or to
ページ6に含まれる内容の要旨
4 Safety and warnings Important safety instructions Operational Use the dishwasher only for its intended function as described in this user guide. This appliance is intended to be used in household and similar applications such as: – staff kitchen areas in shops, offices and other working environments; – farm houses; – by clients in hotels, motels and other residential type environments; – bed and breakfast type environments. Some dishwasher detergents are strongly alkaline. They can
ページ7に含まれる内容の要旨
5 Safety and warnings Important safety instructions Maintenance Do not repair or replace any part of the dishwasher or attempt any servicing unless specifically recommended in this user guide. We recommend that you call a Fisher & Paykel Authorised Service Agent. Keep the floor around your dishwasher clean and dry to reduce the possibility of slipping. Keep the area around and underneath your dishwasher free from the accumulation of combustible materials, such as lint, paper, rags and chem
ページ8に含まれる内容の要旨
6 Installation instructions Before you start Safety and compliance These instructions are intended as a guide only. It is the responsibility of the installer to ensure that installation complies with applicable regulations and local government by-laws. Installation must be performed by a suitably qualified person. Incorrect installation or malfunctioning resulting from incorrect installation are not covered by warranty. Carefully read through the ‘Safety and warnings’ section of this do
ページ9に含まれる内容の要旨
7 Installation instructions Technical data Check the electrical data on the rating label (located on the left-hand side of the dishwasher’s stainless steel inner door). Should the data on the rating label be different to those specified below, consider those on the rating label as correct. Capacity 14 standard place settings Mains water pressure 0.03-1 MPa (= 0.3-10 bar) Power voltage 220-240 V (50 Hz) Maximum current intensity 10 A Total absorbed power 1800-1950 W Colour
ページ10に含まれる内容の要旨
8 Installation instructions Product and cabinetry dimensions F B C E G A D Product dimensions (mm) A overall height of product with top panel in place 850 (min) -870 (max)** with top panel removed* 820 (min) -840 (max)** overall width of product 595 B 600 overall depth of product C depth of open door 595 D (measured from front of kickstrip) Cabinetry dimensions (mm) inside height of cavity E with top panel in place 855 (min) -875 (max)** with top panel removed* 825 (mi
ページ11に含まれる内容の要旨
9 Installation instructions Preparing the product and cabinetry The top panel may be removed to suit underbench cavity height. See the illustrations below. 1 23 Important! To prevent possible steam damage to the cabinetry, ensure that any bare wood surrounding the dishwasher is sealed with an oil-based paint or moisture-proof polyurethane. Services can be located either side of the dishwasher. Ensure that the services hole has a minimum diameter of 50 mm. mm
ページ12に含まれる内容の要旨
10 Installation instructions Levelling and positioning the dishwasher Before sliding the dishwasher into position, adjust the feet with a spanner (1) to ensure that the dishwasher is level (2) and the required height. Do not lift the dishwasher from the door handle or top panel. Position the dishwasher in the cavity, ensuring that the hoses and power cord don’t get bent, crimped, or trapped under the dishwasher in the process (3). If you install the dishwasher with the top panel rem
ページ13に含まれる内容の要旨
11 Installation instructions Plumbing -- Waste connection These drainage options are designed to eliminate problems that occur with combined sink-dishwasher waste systems. Drainage option A: Separate sink and dishwasher waste systems The standpipe must have a minimum diameter of 38 mm and stand 750 mm above the floor. Use the supplied drain hose support to hold the drain hose in place in the standpipe. Important! We do not recommend connecting the drain hose or drain pipe directly to a built
ページ14に含まれる内容の要旨
12 Installation instructions Plumbing -- Water inlet connection Important! The appliance should be connected to the water main using the new water inlet hose supplied. Old hoses should not be used. Do not shorten the inlet hose. 1 Take note of water connection requirements. The dishwasher has a single valve water connection. We recommend a cold water connection for best performance and energy efficiency. o The incoming water temperature should not exceed 60 C. 2 Take note of the p
ページ15に含まれる内容の要旨
13 Installation instructions Electrical connection The dishwasher must not be connected to the electrical supply while installation is being carried out. Ensure all domestic wiring is properly earthed. Check the rating label (located on the left-hand side of the dishwasher’s stainless steel inner door) and ensure that the voltage and frequency values for the current in the house correspond to those on the rating label. Insert the plug into a properly earthed power outlet that has a disc
ページ16に含まれる内容の要旨
14 Introduction Before you start Make sure the installer has completed the ‘Final checklist’ in the Installation instructions. Read this manual thoroughly, taking special note of the ‘Safety and warnings’ section. Remove all the packaging and check that you have all the accessories listed below. Dishwasher features and accessories Utensil tray Upper basket Upper spray arm Lower basket Cutlery basket Door seal Rating label Detergent and rinse aid dispensers Lower spray arm Filters
ページ17に含まれる内容の要旨
15 Using your dishwasher – quick reference Starting a wash 1 Remove food scraps and load dishes carefully For more detail, see sections ‘Caring for your dinnerware’ ‘Loading’ 2 Add detergent For more detail, see sections ‘Water hardness and dishwashing’ ‘Wash programmes and detergent quantities’ ‘Adding detergent’ 3 Turn power on (check also if water is on) For more detail, see section ‘Controls and starting a wash’ 4 Check rinse aid level, refill if necessary For more detail, see sec
ページ18に含まれる内容の要旨
16 Controls and starting a wash - CE models delay 07 On/Off and Delay Display Heater Rinse aid Keylock start indicator indicator Control panel feature Action to take Turns the power to the dishwasher On/Off Press briefly to turn the on and off. dishwasher on and off. This disables all the buttons so a To activate or cancel Keylock, wash cannot accidentally be press and hold for 3 seconds Keylock started e.g. by children playing, (until you hear a long beep). LOC someone leaning against the
ページ19に含まれる内容の要旨
17 Controls and starting a wash - CE models heavy normal normal fast delicate rinse eco Programme Programme Start/Pause selector indicators To select and start a wash programme 1 Make sure that the dishwasher is powered on . 2 Press until the indicator of the desired programme lights up. 3 Press to start the programme. After 5 seconds, the selected programme indicator will start flashing, the dishwasher will beep once and the wash will start automatically. The display will show the a
ページ20に含まれる内容の要旨
18 Controls and starting a wash - CE models delay 07 On/Off and Delay Display Heater Rinse aid Keylock start indicator indicator To cancel a wash programme once it has started 1 Press to pause the programme. 2 Press to turn the dishwasher off. The programme has now been cancelled. If you wish, you can start a different one. Note: you may need to refill the detergent dispenser. CE MODELS
