ページ1に含まれる内容の要旨
WF140 Freestanding Dishwasher
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it, unless they have had supervision or
ページ3に含まれる内容の要旨
Recomendations • To reduce energy and water consumption, remove all dirt residues from the dishes prior to loading the dishw• • Only run the dishwasher only when fully loaded. • Place hollow items (bowls, glasses and pans) face down in the basket. Before first use • Set the water softener level as required by the water hardness in the area. • Add 2kg of salt into the salt compartment and then fill with water to the top of the salt compartment. • Remove all the packaging materials from t
ページ4に含まれる内容の要旨
Control Panel Starting a programme • Press the Power button (1) to switch the dishwasher on. • Turn the Programme Selection Dial (2) until the required programme is indicated. • If required, press the Delay Timer button (3) repeatedly to set the programme. • If required, press the Prewash button (4). • Ensure the dishwasher door is closed. • Press the Start/Pause button (5) to begin the programme. If possible, do not open the dishwasher door once the programme has started. Using the delay timer
ページ5に含まれる内容の要旨
Detergent To fill the detergent compartment 1. Push the latch as shown in figure 1. 2. Add the required amount of detergent. The main detergent compartment “b” (figure 2) has lines to allow for specific amounts of 3 3 detergent. These are marked at either 15 cm or 25 cm , to be used depending on how dirty the dishes are. 3 If your dishes are in need of an intensive wash, then add 5 cm of detergent into the prewash section of the compartment “a” (figure 2). 3. Then close the d
ページ6に含まれる内容の要旨
ENGLISH T esting strip The washing effectiveness of your machine depends on the softness of the tap water. For this reason, your machine is equipped with a system that reduces the hardness in mains water supply.The washing effectiveness will increase when the system is correctly set. To find out the water hardness level of water in your area, contact your local water board or determine water hardness level by using the test strip(if available). ENGLISH Run Keep the Shake the Wait for Make your m
ページ7に含まれる内容の要旨
Rinse Aid Rinse Aid To fill the rinsRinse Aid e aid compartment Rinse Aid To fill the rinse aid compartment To fill the rinse aid compartment To fill the rinse aid compartment 1. Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap as shown in figure 4. 1. Open the rinse aid compartment by turning and removing the cap as shown in figure 4.
ページ8に含まれる内容の要旨
Alternative basket loads Dishwasher Baskets Lower Basket To adjust the height of the upper basket: 1. Open the basket retaining clips, as shown in figure 7, but turning them to the side. 2. Remove the upper basket, and relocate the alternate set of wheels on the runner, as shown in figure 8, pushing the basket back into place. 3. Close the basket retaining clips. fig 7 The images below are designed as guidance as to best practice for loading the dishwas
ページ9に含まれる内容の要旨
Standard loading and Test Data Capacity • Upper and lower baskets: 12 place settings. • The upper basket should be adjusted to high position. • Cups should be placed on to the dish rack pins. Detergent / Rinse aid 3 • 5 + 25 cm , in accordance with EN50242-DIN 44990 IEC 436 (international norms) / Rinse aid dosage adjustment: 4. Programme test • Economic 50°C, in accordance with EN 50242 (international norms.).
ページ10に含まれる内容の要旨
Programme Listing Extra Programme Prewash Quick Economic Normal Intensive intensive O O O O names and No heat 40 wash 50 wash 55 wash 65 wash (Prewash temperatures and intensive Pre-wash to Coffee, milk, Coffee, milk, Soups, sauses, Soups, sauses, Soups, sauses, Type of food rinse and loosen tea, cold meats, tea, cold meats, pasta, eggs, pilaf, pasta, eggs, pilaf, pasta, eggs, pilaf, waste residue-awaiting vegatables, not vegatables, not potatoe and potatoe and potatoe and full load-then
ページ11に含まれる内容の要旨
ENGLISH MAINTENANCE AND CLEANING Cleaning the machine in regular intervals prolongs the machine's service life. Oil and lime may accumulate in the machine's washing section. In case of such accumulation; ENGLISH -Fill the detergent compartment without loading any dishes into the machine, select a programme that runs at high temperature, and start the machine. In case of insufficiency, use special cleansing material available in the market. (Cleansing material produced special to ENGLISH machines
ページ12に含まれる内容の要旨
Failure Codes and Troubleshooting Your dishwasher control panel is equipped with a diagnostic display to help in the event of a problem with the appliance. Failure Codes and Troubleshooting The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance. Error Code Error description Advice Failure Codes and T Failur r e C oubleshoo odes and T ting roubleshooting Error code Intensive Normal Eco Quick Prewash Error Advice Your dishwasher control p
ページ13に含まれる内容の要旨
Failure Code and Troubleshooting Problem Possible cause Check the plug, fuse and circuit breakers of the mains supply The water tap is turned off The programme will not start The dishwasher door is not fully closed The water inlet filter or the machine filters are blocked The water drain hose is blocked or kinked. The water drain hose is blocked or knicked Water remains inside the dishwasher at the end of the The filters are blocked programme Power failure The dishwasher stops in the middle of
ページ14に含まれる内容の要旨
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the fitted plug is not suitable f
ページ15に含まれる内容の要旨
Installation • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. • The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation. • Ensure the appliance is level by adjusting the feet as necessary. • Only use the water inlet supplied with the appliance. • If the water pressure is above 10 bar, a pressure relief valve should be used. • After connecting the water
ページ16に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
