ページ1に含まれる内容の要旨
MODEL C500
MODEL C501CY
MODEL C501K
READ AND SAVE THESE INSTRUCTIONS
INSTALLATION
ALL ELECTRICAL WORK MUST BE DONE IN ACCORDANCE WITH LOCAL AND/
OR NATIONAL ELECTRICAL CODE AS APPLICABLE.
TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING, OR
SERVICING THIS PRODUCT.
1. Hold chime mechanism against wall and mark four (4) mounting holes.
2. Drill 3/16” holes where marked and tap in wall anchors from parts bag.
3. Bring wiring through access hole(s) in chime mechanism backplate.
4. Attach
ページ2に含まれる内容の要旨
INSTALLATION (continued) 6. Connect wires to appropriate terminals. RECOMMENDED NEW CONSTRUCTION WIRING Ground 120 Volt AC Lighted or Unlighted Buttons Front Side Rear 16 VAC Transformer 1 2 3 F S R NOT USED Nine volt batteries not used Volume Control REPLACING EXISTING 2-NOTE CHIME Ground 120 Volt AC Lighted or Unlighted Buttons Front Side Rear 16 VAC Transformer 1 2 3 F S R NOT USED 9V 9V Requires Two 9 Volt Batteries Volume Control 7. Install two (2) alkaline 9-volt batteries, if appr
ページ3に含まれる内容の要旨
SPECIAL MOUNTING INSTRUCTIONS FOR MODEL C500 DOOR CHIME Model C500 may be surface-mounted or recessed into the wall. SURFACE-MOUNTED 1. Remove chime mechanism from wood case. 2. Remove and discard shipping panel from top rear of wood case. 3. Mount and wire chime mechanism. 4. Hang wood case from chime mechanism. 5. Install chime tubes. RECESSED-MOUNTED 1. Cut out a 10-1/2” wide by 59-1/8” high hole in wall centered between two wall studs. 2. Make two mounting frames from 2 x 4’s (Figure 1). 3.
ページ4に含まれる内容の要旨
SERVICE PARTS 2 1 3 4 KEY PART NO. NUMBER DESCRIPTION 1 99521018 Case, Oak (C500) 97014976 Cover, Cherry (C501CY) 99522831 Cover, Oak (C501K) 2 99521400 Solenoid/PC Board Assembly 3 99522069 Matched Set of (4) Chime Tubes (Includes Hangers) 4 99521420 Faceplate (C500) Broan-NuTone LLC, Hartford, WI 53027 NuTone, Inc., Cincinnati, OH 45227 99042836D
