ページ1に含まれる内容の要旨
by
Instrucciones de instalación Installation Instructions
Notice d'installation
P515-359
F-Series
F51 Shown
Rounded Corner Faceplate
Lever (2) El modelo F51
Knob (2)
Placa delantera con
Manija (2)
F51 illustré
Perilla (2)
esquinas redondeadas
Levier (2)
Bouton (2)
Têtière à angles arrondis
Cylinder
Escutcheon Screws (4)
Strike
Cilindro
Escutcheon Screws (4)
Placa hembra
Cylindre
Escutcheon Screws (4)
Gâche
Escutcheon (2)
Drive-In Latch Adapter
Outside Chassis
Escutcheon (2)
Cylinder
Adaptador d
ページ2に含まれる内容の要旨
D. Prepare Door Jamb Two (2) ¹⁄₈" (3mm) One (1) 1" (25mm) Hole a. Mark centerlines on jamb exactly opposite center of latch hole. Pilot Holes ⁵⁄₈" (16mm) Deep b. Drill holes as shown. Dos agujeros Un agujero de 25 mm con c. Use strike as a pattern for mortise and pilot holes. Strike should fit flush. guía de 3 mm una profundidad de 16 mm Deux trous D. Preparación del batiente Un trou de 25 mm par pilotes de 3 mm 16 mm de profondeur a. Marcar líneas centrales en el batiente, exactamente en el
ページ3に含まれる内容の要旨
Keyed Functions 4 Remove Inside Knob/Lever and Rose/Escutcheon Keyed Functions a. Remove lever by pushing pin into hole and pulling lever off. Keyed Functions b. Remove rose/escutcheon from chassis. Remove Inside Knob/Lever and Rose/Escutcheon Non-Keyed Functions a. Remove lever by pushing pin into hole and pulling lever off. Non-Keyed Functions b. Remove rose/escutcheon from chassis. Non-Keyed Functions Remove Inside Knob/Lever and Rose/Escutcheon a. Remove lever by pushing pin into hole and pu
ページ4に含まれる内容の要旨
6 7 Escutcheon Installation Make sure escutcheon is straight. Insert two (2) screws and tighten into door. Escutcheon Installation Make sure escutcheon is straight. Insert two (2) screws and tighten into door. Escutcheon Installation Make sure escutcheon is straight. Insert two (2) screws and tighten into door. Incorrect Correct 6 8 If Needed, Reverse Levers Incorrecto Correcto NOTE: If lever is installed incorrectly, levers need to be reversed. Incorrecte Correcte FOR KEYED ENTRANCE: a. Rotate