Gianni Industries , IncDG-30の取扱説明書

ページ1に含まれる内容の要旨

DG-30 Digital Keypad / Proximity Entry system
Operation User's Manual




1. Product Characteristic:

Allows up to 150 Proximity cards / tokens or PIN codes
Tamper Switch Included
Door Reed Switch Input for Anti-Trailing
Fully Programmable via keypad and master code
Extendable from keypad only to proximity controller
Supports 26 or 34-bit Wiegand auxiliary reader
Logical memory to prevent duplication
Non-Volatile Memory
Invalid PIN Lock-out





2. Specific

ページ2に含まれる内容の要旨

3. The indicator signal chart: Sound and LED indicator: Red LED Power on Green LED Relay activated LED signal Tri-color-Yellow Entering the Program mode Tri-color-Red Slot position is registered Tri-color-Green Slot position is ready to register Slot position is ready to register 、Effective card （PIN 1 Beep codes ）、Exit from the Program mode 2 Beeps Entering the Program mode Sound signal Slot position is registered 、Data computing error 、 other 3 Beeps operation mistakes 、 d

ページ3に含まれる内容の要旨

Followed By 「03 」：This will set the system to be used as : Slots 001~150 for PIN codes only Note: When system format has the change, there’s a possibility the card stored would be invalid. Please reset the system and input all cards /tokens. Add card and deletion Enter the Programming mode, Enter the slot position code 「001~100 」 A. Green light comes on: This slot position is ready to register the card 1. Present card in front of the reader Yellow LED blinks (beep) enr

ページ4に含まれる内容の要旨

Tamper switch contact output e (fre voltage contact) Reset to Factory Master Code reset to Factory 「12345 」 Insert the jumper RES1 1-2 position 5 audible beeps Reset successful Return Insert the jumper to 2-3 position Remove all stored information Insert the jumper RES1 1-2 position 5 audible beeps Master Code reset to Factory 「12345 」 after 5 seconds 5 audible beeps Remove all stored information Return Insert the jumper to 2-3 position. Note: If you only wish