ページ1に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER
OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH
PPM1008 MINIMUM LOAD: 4 OHMS PER CHANNEL
8-Channel, 2 x 800 W Professional Powered Mixer
OWNER’S MANUAL
2 X 800W PROFESSIONAL POWERED MIXER
/
FX
FOOT SWITCH
ページ2に含まれる内容の要旨
Important Safety Instructions 1. Read these instructions. 19. NOTE: This equipment has been tested and found to comply with 2. Keep these instructions. the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 3. Heed all warnings. against harmful interference in a residential installation. This equip- 4. Follow all instructions. ment generates, uses, and can radiate radio frequency energy and, if 5. Do not use
ページ3に含まれる内容の要旨
Owner’s Manual Ready, steady, go! Read This Page! 1. Turn the channel level, mon 1, and FX/mon 2 We realize that you must be keen to try controls fully down. out your new powered mixer, but please 2. Turn down the compressor controls (ch. 1–4). read the safety instructions on page 2, and this page first. 3. Set all the EQ controls to the center, including the graphic EQ sliders. 4. Turn down the main level and monitor 1 level Setup controls. The PPM1008 powered mixer is designed to be e
ページ4に含まれる内容の要旨
Introduction • Independent 9-band graphic EQs with constant- It is possible that only one person will read this Q filters on main and monitor outputs manual all the way through. Hello mom. Here's another manual from your boy. • T ape/CD ster eo RCA outputs Thank you for choosing a Mackie professional pow- • 12-segment ster eo output meters on main mix, ered mixer. These powerful mixers are designed to meet and mono meter on monitor 1 the needs of almost any small to medi
ページ5に含まれる内容の要旨
Owner’s Manual Contents IMPORTANT SAFETY INSTRUCTIONS ........................ 2 MASTER CONTROLS READ THIS PAGE! .................................................... 3 36. MAIN MASTER GRAPHIC EQ ................... 20 INTRODUCTION ...................................................... 4 37. FX TO MAIN ........................................... 20 HOOKUP DIAGRAMS............................................... 6 38. MAIN LEVEL ........................................... 20 REAR PANEL FEATURES
ページ6に含まれる内容の要旨
Hookup Diagrams Front Panel P ower Amp Mode switch set to Stereo Mains Rear Panel Microphones press HI-Z button press HI-Z button Adjust Vocal Compression Keyboards P ortable Recorder SRM450 v2 P owered Stage Monitors (plays mon 1 output) P owered Subwoofers Passive Speakers (plays main mix below 100 Hz) (plays stereo main mix) This diagram shows microphones attached to channels 1 and 2, electric guitars connected directly to channels 5 and 6 (with hi-z switch pressed in), and a keyboard atta
ページ7に含まれる内容の要旨
Owner’s Manual Microphones Acoustic Guitar and Mic Front Panel P ower Amp Mode switch set to Mains/Mon 1 Rear Panel press HI-Z button Adjust Vocal Compression Drum Machine P ower Amplifier C300z Passive Stage Monitors dual-mono (plays mon 1 output) mode Keyboards SRM150 P owered Monitor (plays mon 1 output) Passive Speakers Passive Subwoofers House System (plays main mix below 100 Hz) (plays mono main mix) This diagram shows microphones attached to the mic inputs of channels 1 to 4, an electric
ページ8に含まれる内容の要旨
Wireless Microphone Microphones Front Panel P ower Amp Mode switch set to Stereo Mains Rear Panel Graphic EQ TM iPod Docking Station Wireless Mic Receiver Mackie d.2 Pro HD1521 HD1521 DJ Production Console P owered P owered Speaker Speaker MAIN OUT BOOTH FX PGM 2 PGM 1 MIC PHONO CD PHONO CD L R L L SEND RL L L L LINE MIC R RR R LIVE RETURN RECORD R L(MONO) R LINE GND LINE GND ~100-240 VAC 50-60Hz 20W L PHONO PHONO R Turntables with phono-level output Passive Speakers P owered Subwoofer P owered
ページ9に含まれる内容の要旨
Owner’s Manual Microphones Front Panel P ower Amp Mode switch set to Mon 1/Mon 2 Rear Panel press HI-Z buttons Adjust Vocal Compression Send HD1531 HD1531 Return Guitar Processor P owered P owered (connected to INSERT) Speaker Speaker C200z Passive Stage Monitors (plays mon 2 output) Keyboards C300z Passive Stage Monitors (plays mon 1 output) P owered Subwoofer P owered Subwoofer Electronic Drum Kit (plays right main mix) (plays left main mix) This diagram shows microphones attached to the mic
ページ10に含まれる内容の要旨
Rear Panel Features 2 X 800W PROFESSIONAL POWERED MIXER 4 2 6 3 6 1 OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL 5 1. POWER CONNECTION 3. SPEAKER-LEVEL OUTPUTS This jack accepts the supplied 3-prong IEC AC power These output connections provide speaker-level 2 X 800W PROFESSIONAL POWERED MIXER cord. output power from the internal power amplifiers to your passive speakers. The power output of the PPM1008 is Before you plug the AC power cord into the 500 watt
ページ11に含まれる内容の要旨
Owner’s Manual • 1/4" TS outputs ar e wir ed T ip positive, and 5. VENTILATION and REAR PANEL Sleeve negative. Ventilation holes in the rear panel and the bottom SLEEVE SLEEVE TIP panel allow the internal fans to flow breezy and minty- fresh cooling air over the internal power amplifiers. Do TIP TIP not obstruct these holes, or the amplifiers may overheat and shut down. SLEEVE Do not remove the feet, as these keep the 1/4" TS Connection powered mixer off the ground for ventilation. Thes
ページ12に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL Front Panel Features 2 X 800W PROFESSIONAL POWERED MIXER / 11 12 14 10 8 9 FX FOOT SWITCH 13 7 Patchbay section 7. MIC INPUTS This is where you plug in things such as: microphones, We use phantom-powered, balanced microphone line-level instruments, guitars, and effects, a r ecorder, inputs just like the big studio mega-consoles, for exactly PA system, powered monitors,
ページ13に含まれる内容の要旨
Owner’s Manual PHANTOM POWER 12. INSERT (CH. 1 to 6) Most modern professional condenser mics are These unbalanced 1/4" jacks on channels 1 to 6 are for equipped for phantom power, which lets the mixer connecting serial effects processors such as compres- send low-current DC voltage to the mic’s electronics sors, equalizers, de-essers, or filters. The insert point through the same wires that carry audio. (Semi-pro is after the gain switch [32] and compressor circuits condenser mics often have
ページ14に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL 2 X 800W PROFESSIONAL POWERED MIXER / 15 17 FX FOOT SWITCH 19 20 16 18 If they want "more me, and less Keith," you can turn 15. FX/MON 2 SEND OUTPUT up their channel's FX/mon 2 control, and turn down 1 This /4" TRS line-level output can be used to feed an Keith's. (If you were using monitor 1 to feed the stage external effects processor (FX) or another set of stage monitor,
ページ15に含まれる内容の要旨
Owner’s Manual (The main mix still plays the full frequency range, EFFECTS: SERIAL OR PARALLEL? this sub output is just a copy of the range below 100 Hz “Serial” means that the entire channel signal for external subwoofers.) leaves the mixer (insert [12] send), is routed through the effects device, and returns to the 19. MAIN OUTPUTS mixer (insert return). Examples: compressor, limiter, graphic equalizer. Line-level sources can also be These 1/4" TRS outputs supply the stereo main mix a
ページ16に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL 2 X 800W PROFESSIONAL POWERED MIXER 21 22 23 24 26 25 27 29 30 31 32 / 33 34 34 Channel Controls “U” like Unity gain Mackie mixers have a “U” symbol on almost every level The eight vertical channel strips look very similar, FX FOOT SWITCH with only a few differences between them. Each chan- control. It stands for “unity gain,” meaning no change in nel works independentl
ページ17に含まれる内容の要旨
Owner’s Manual 21. MON 1 23. HIGH EQ +15 This control allows you set up a nice monitor mix, The high EQ provides up to 15 +10 independent of the main mix or the monitor 2 mix. dB of boost or cut above 12 kHz, +5 Adjust these controls on each channel until your band is and it is also flat at the detent. 0 –5 happy with the stage monitor mix. The controls are off Use it to add sizzle to cymbals, –10 when turned fully down, deliver unity gain at the center an overall sense of transpar- –15 20Hz
ページ18に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL 2 X 800W PROFESSIONAL POWERED MIXER 21 22 23 26 24 27 25 29 30 31 32 / 33 34 29. LOW EQ 32. GAIN SWITCH +15 The low EQ provides up to 15 Press this in (low) if you are connecting a line-level +10 dB of boost or cut below 80 Hz. input source to channels 1 to 6. +5 FX FOOT SWITCH 0 The circuit is flat (no boost or Press this out (high) if you are connecting a micro- –5 c
ページ19に含まれる内容の要旨
Owner’s Manual 33. COMPRESSOR +20 Channels 1 to 4 have an in-line compressor circuit with a variable threshold. This is very useful for com- +15 pression of vocals, for example. When the incoming signals exceed the threshold level +10 set by this knob, the signal level is automatically com- pressed. This reduces the dynamic range, and reduces +5 the chance of distortion due to overloading the input signals. +0 Dynamic range is the difference in level be- tween the quietest part of your song
ページ20に含まれる内容の要旨
2 X 800W PROFESSIONAL POWERED MIXER OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH MINIMUM LOAD: 4 OHMS PER CHANNEL Master Controls As with the channel EQ, just take it easy. 35 2 X 800W PROFESSIONAL POWERED MIXER There is a large amount of adjustment, and if you are not careful, you can upset the delicate 37 balance of nature. Although it may not seem 40 cool to turn down controls, with EQ it is often your best option. Turn down the offending 36 frequency range, rather than boost the wa
