ページ1に含まれる内容の要旨
TM
ViewSonic
Digital Photo Frame - User Guide
VFM842/VFM1042
- Guide de l’utilisateur
- Guía del usuario
IMPORTANT: Please read this User Guide to obtain important
information on installing and using your product in a safe
manner, as well as registering your product for future service.
Warranty information contained in this User Guide will describe
your limited coverage from ViewSonic Corporation, which is also
found on our web site at http://www.viewsonic.com in English,
or in specific
ページ2に含まれる内容の要旨
Compliance Information FCC Statement This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec
ページ3に含まれる内容の要旨
Declaration of RoHS Compliance This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the Council on restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and is deemed to comply with the maximum concentration values issued by the European Technical Adaptation Committee (TAC) as shown below: Substance Proposed Maximum Concentration Actual Concentration Lead (Pb) 0.1% < 0.1%
ページ4に含まれる内容の要旨
Copyright Information © Copyright ViewSonic Corporation, 2010. All rights reserved. ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks of ViewSonic Corporation. Disclaimer:ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product. In the interest of continuing product improvement,
ページ5に含まれる内容の要旨
TABLE OF CONTENTS Introduction.............................................................................................................................................................................................1 Important Safety Precautions................................................................................................................................................................2 Main Features ......................................................................
ページ6に含まれる内容の要旨
Introduction Thank you for purchasing this Digital Photo Frame. This Digital Photo Frame is compatible with SD, MMC and MS memory card formats, which enables you to view digital photo directly from your camera’s memory card. This manual contains important safety information and operation instructions, so please read all the instructions carefully before using the Digital Photo Frame and keeps it for future reference. We have done our best to produce a complete and accurate man
ページ7に含まれる内容の要旨
Important Safety Precautions Always follow these basic safety precautions when using your Digital Photo Frame. This will reduce the risk of fire, electric shock, product damage and personal injury. Warning: Do not remove the cover or back to reduce the risk of electric shock. There are no user-serviceable parts inside. Refer servicing to qualified personnel. Warning: Do not expose the Digital Photo Frame to rain or moisture to prevent fire or electric shock hazard. Warning: If you wan
ページ8に含まれる内容の要旨
Cleaning Before cleaning the Digital Photo Frame make sure it is turned off. Never spray or pour liquid directly onto the screen or plastic casing. To clean the LCD screen, wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles. If it is still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner on a clean, soft, lint-free cloth to clean the screen. To clean the plastic casing, use a soft, dry cloth. If it is still not cl
ページ9に含まれる内容の要旨
Main Features 21.3cm/8.4”(VFM842) or 26.4cm/10.4”(VFM1042) Digital TFT LCD: 800*600 4:3 Decorative appearance Displays digital photos (JPEG) Slide show with background music and multiple transition effects Playback of music files Playback of video files Calendar and clock display Alarm setting Compatible with SD/MMC/MS memory cards USB Host for connecting to the USB mass storage 2GB Internal memory built in ViewSonic VFM842/VFM1042 4
ページ10に含まれる内容の要旨
Controls and Connections 1. MENU Press to enter main menu 7. Mini-USB connection 2. EXIT Exit button 8. USB HOST 3. ENTER Play/Pause/Confirm button 9. SD/MMC/MS card slot 4. Navigation button 10. 5V 2A DC Input socket 5. Working indicator light 11. Wall hanger 6. Hold to power on or off 12. Adjustable stand ViewSonic VFM842/VFM1042 5
ページ11に含まれる内容の要旨
Remote Control 1 To zoom in the photo. 2 EXIT To return to the previous menu. 3 To rotate the photo. 4 To copy or delete files. 5 To move the cursor left. 6 To start slide show. 7 SETUP To enter the setup menu. 8 To turn on/off the unit. 9 To play in mute. 10 To increase the volume. 11 To move the cursor up. 12 To decrease the volume. 13 To move the cursor right. 14 ENTER To confirm the selection; start or pause playback. 15 To move the cursor down. 16 STOP To stop m
ページ12に含まれる内容の要旨
Battery installation for the Remote Control Remove the insulating mylar strip from the battery if the battery is being used for the first time, it is located at the bottom back side of the remote control. If the remote control unit fails to work even when it is operated near the unit, replace the battery. 1. Press and hold the battery release tab in the direction of arrow . 2. Pull out the battery holder completely in the direction of arrow as shown in the left. 3. Remove the old
ページ13に含まれる内容の要旨
Getting Started Hanging the frame to a wall The frame can also be mounted to a wall without the stand. 1. Prepare screws(less than Φ6mm) suitable for the screw holes on the rear panel. 2. Screw the screws into the wall. The distance between screws in horizontal is about 18-24mm. 3. Hang the photo frame on the wall with the wall hanger, you can set the device in the landscape orientation or in the portrait orientation. ViewSonic VFM842/VFM1042 8
ページ14に含まれる内容の要旨
Connecting to the power Plug one end of the power adaptor into the DC socket in the Digital Photo Frame, and the other into a wall outlet. Note: To turn on/off the Digital Photo Frame completely, hold the power button.. Inserting Media In order to play photos from a card or a memory stick, insert the card into its respective card slot on the Digital Photo Frame or use the USB port. This Digital Photo Frame is compatible with the following memory cards: • Secure Digital Card (SD) •
ページ15に含まれる内容の要旨
1. Insert the SD/MMC/MS card into the 3-in-1 card slot with 2. Push a USB memory stick into the USB HOST the metallic contacts facing towards the display. slot. Note: Do not use any force while inserting a memory card or attaching a memory stick. The 3-in-1 card slot only reads one memory card at a time. Do not insert more than one card into one memory card slot. To remove the cards or the USB memory stick, pull it out gently. Copy files from computer You can connect the dig
ページ16に含まれる内容の要旨
USB port on your computer. 3. The computer system detects “New hardware” and starts to install the driver automatically. Wait for the system to finish the installation. When it has finished, several “Removable Disk”, which indicate all drivers of the digital photo frame, will be created in “My computer”. 4. Drag and drop the files on your computer to the memory device connected to the digital photo frame or to the built-in memory. 5. To disconnect the USB cable from the computer, double
ページ17に含まれる内容の要旨
Appears when you purchase a Frame with NAND Memory flash memory. (only for model with internal memory) SD/MMC/MS Appears when you insert a SD, MMC or MS card. USB Appears when you inserted a USB flash driver. Photo To view photos of the memory source. Music To play music. Video To play videos. Calender To display the Calendar/Clock on the screen. To browse all the files of the memory source and Files copy or delete files. Setup To customize the settings of Digital P
ページ18に含まれる内容の要旨
Viewing Photos Press the EXIT key on the remote as necessary to enter the function select interface. Use or key on the remote to select a memory source (e.g. USB, SD/MMC/MS) in the main menu and press the ENTER key. Use or key t on the remote o select Photo icon, and then press the ENTER key on the remote. The photos are displayed on the screen in thumbnails or in slideshow mode which can be adjusted in Setup mode. Viewing thumbnails In Photo mode, the photos on the selected m
ページ19に含まれる内容の要旨
Browsing a single photo You can select a single photo to display on the screen: 1. Use or key on the remote to select a photo in the thumbnail view, and press the ENTER key on the remote. Or press ENTER key on the remote repeatedly to chage to single mode during slideshow.The selected photo is displayed on screen. 2. To zoom in a photo, use key and press ENTER key on the remote repeatedly. 3. To rotate a photo, use key and press ENTER key on the remote repeatedly. 4. To retur
ページ20に含まれる内容の要旨
Listening to Music In Music mode, the music file lists on the selected memory source can be displayed on the screen as thumbnails. 1. Press the EXIT key on the remote as necessary to enter the function select interface. 2. Use or key t on the remote o select a memory source (e.g. USB, SD/MMC/MS) in the main menu and press the ENTER key on the remote. 3. Use or key on the remote to select Music icon, and then press the ENTER key. The music file lists displayed on the screen 4. Us
