ページ1に含まれる内容の要旨
!"
User’s Guide for
Nokia Image Frame SU-7
9311006
Issue 1
ページ2に含まれる内容の要旨
!" DECLARATION OF CONFORMITY We, NOKIA CORPORATION, declare under our sole responsibility that the product SU-7 is in conformity with the provisions of the following Council Directive: 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/. Copyright © 2004 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in t
ページ3に含まれる内容の要旨
!" Contents FOR YOUR SAFETY ................... 4 3. Using the Nokia Image Frame ........................... 16 Introduction ............................. 6 Viewing the images .................... 16 Power supply................................... 6 Editing the images ...................... 16 Technical data................................. 6 Switching the screensaver Image format .................................. 7 on and off.....
ページ4に含まれる内容の要旨
# !" FO R YO U R SA F E T Y FOR YOUR SAFETY Read these simple guidelines. Breaking the rules may be dangerous or illegal. Further detailed information is given in this manual. Do not connect the Nokia Image Frame to the mobile network when wireless phone use is prohibited or when it may cause interference or danger. INTERFERENCE All devices may get interference, which could affect performance. SWITCH OFF IN HOSPITALS Follow any regul
ページ5に含まれる内容の要旨
!" FO R Y O U R SA F E T Y IMPORTANT: Only use chargers in dry conditions. Never supply power to the device with a charger when the device or charger or their parts are damp or wet. If the device has been exposed to salt water, wipe it immediately with a cloth dampened with fresh water to avoid corrosion. The device must then be carefully wiped dry. Do not point the IR (infrared) beam at anyone's eye or allow it to interfere with
ページ6に含まれる内容の要旨
$ !" Int r oduc t io n Introduction The Nokia Image Frame SU-7 is an enhancement product, which enables you to view the digital images taken or received by your IrDA-enabled Nokia phone or other compatible devices. You can connect the Nokia Image Frame to the devices using its infrared (IR) port. If you insert a SIM card to the Nokia Image Frame, you can also receive new images as MMS messages. You can place the Nokia Image Frame o
ページ7に含まれる内容の要旨
!" In tro du cti on o o Operating temperature: 0 C to 40 C Compatibility: The Nokia Image Frame SU-7 is compatible with phones and other devices that support image sending over infrared (IrDA). Note that if image sending cannot be activated from the phone (IrDA Send feature), the Nokia Image Frame can pull the images from the compatible Nokia phone when the phone’s IR connection has been activated. The Nokia Image Frame can a
ページ8に含まれる内容の要旨
% !" Ov er vi ew 1. Overview The Nokia Image Frame has the following parts: 1. Display 2. Infrared (IR) port 3. Control keys 4. Table support 5. Charger connector 6. Back cover You can use the Nokia Image Frame through the control keys on top of the device. The control keys are: 1. Power on/off key 2. Show/Brightness key 3. Rotation key 8
ページ9に含まれる内容の要旨
& !" Overview 4. Three-position switch: Slide show mode Image view mode Edit mode 5. Up key 6. Down key 7. Mark key 8. IrDA key There are three ways to press the keys. These are as follows: Press briefly - press a key for less than one second Press - press a key for at least one second - press and hold down the key for at least three Press and hold seconds Indicators on the display This indicator shows that the image has
ページ10に含まれる内容の要旨
!" Ov er vi ew This indicator blinks when the Nokia Image Frame attempts to establish the IrDA connection. When the connection is established and the Nokia Image Frame is sending or receiving an image, the indicator is displayed continuously. Confirms that the images have been successfully received or sent (the receiving device has confirmed the images as received). The image is not supported by the Nokia Image Frame. It is, for
ページ11に含まれる内容の要旨
!" Ge tti n g sta r te d 2. Getting started Setting up the Nokia Image Frame Warning! To avoid damage to the SIM card, do not install, move or remove the SIM card if the power supply is connected to an AC wall outlet. 1. If you want to be able to receive images over MMS, you have to insert a SIM card into the Nokia Image Frame. 1. With the display of the Nokia Image Frame facing you, detach the cover on the back of the Nokia I
ページ12に含まれる内容の要旨
!" Ge tti n g sta r te d 2. Connect the lead from the charger to the socket at the back of the Nokia Image Frame (1). 3. Connect the charger to an AC wall socket. 4. Set the Nokia Image Frame on the table with the control keys on the top. If most of your images are in the upright position, you can turn the Nokia Image Frame upright so that the control keys are on the right side of the display. All radio transmitting devic
ページ13に含まれる内容の要旨
!" Ge tti n g sta r te d Keying in the PIN code If the PIN query is activated on the SIM card, the Nokia Image Frame displays the PIN query when the power is switched on. Note: If you want to deactivate the PIN query, insert the SIM card to your phone and deactivate the PIN query as instructed in your phone’s user guide. 1. Press briefly or until the correct first number of the PIN code is highlighted. 2. Press briefly to se
ページ14に含まれる内容の要旨
# !" Ge tti n g sta r te d OTA message You can configure the MMS settings by an OTA message if your operator offers that service. Before receiving the settings, set the Nokia Image Frame Note: to the edit mode by sliding the three-position switch to . Send a text message 91 from your mobile phone to the phone number of the SIM card you inserted to the Nokia Image Frame. For example, 91 123
ページ15に含まれる内容の要旨
!" Ge tti n g sta r te d 27 Command for setting the SMS Center number. 43 Command for setting the password prompting on or off. 45 Command for setting the connection security on or off. 44 <1_or_2> Command for setting the authentication method for the connection. The method is normal (1) or secure (2). 46 <1_or_2> Command for setting the session mode. The mode is temporary (1) or permanent
ページ16に含まれる内容の要旨
$ !" U s i n g t h e No ki a I m a g e Fr am e 3. Using the Nokia Image Frame Viewing the images If there is only one image in the Nokia Image Frame, it is displayed when you switch on the power. If there is more than one image in the Nokia Image Frame, you can set the Nokia Image Frame to show just one image, or several images in rotation as a slide show. Setting Nokia Image Frame to show one image: 1. Slide the three position sw
ページ17に含まれる内容の要旨
!" U s in g t h e N o ki a I m ag e Fr a m e Marking the images for viewing: 1. Slide the three position switch to . 2. Press briefly or to scroll the images. 3. If you want to be able to view an image, mark it by pressing briefly while the image is displayed. The Nokia Image Frame displays the icon for all marked images. If you want to unmark an image, press briefly while the marked image is displayed. When the Nokia Image F
ページ18に含まれる内容の要旨
% !" U s i n g t h e No ki a I m a g e Fr am e Modifying the display brightness When the power is switched on, you can modify the brightness of the display by pressing briefly . There are five brightness levels, and each time you press , the level is raised by one. When the highest brightness level is used and you press , the Nokia Image Frame returns to the lowest brightness level. Sending an image from the Nokia Image Frame W
ページ19に含まれる内容の要旨
& !" U s in g t h e N o ki a I m ag e Fr a m e Receiving images over IR: 1. If you want the images in the Nokia Image Frame to be in a certain order, press briefly or to scroll to the image after which you want to store the new images. 2. Direct the IR ports of the Nokia Image Frame and the compatible sending device toward each other, and ensure that there are no obstructions between the devices. The maximum allowed distance is
ページ20に含まれる内容の要旨
!" U s i n g t h e No ki a I m a g e Fr am e 3. Activate the image source device’s IR connection. For more information on how to do this, refer to the user’s guide of that device. 4. Press to enter the active IR reception mode. The Nokia Image Frame displays the icon. 5. During the image transfer, the Nokia Image Frame displays the icon and the received images one by one. 6. After all the images have been received, the Nokia
