ページ1に含まれる内容の要旨
4-259-440-13 (1)
For your safety
Digital Photo Let’s get the photo
frame ready
Frame
Let’s view an image
DPF-D1020/D1010
Try using various functions
DPF-D820/D810
DPF-D720/D710/D700
Troubleshooting
Additional information
Operating Instructions
Before operating this unit, please read this manual thoroughly and
retain it for future reference.
Owner’s Record
The model and serial numbers are located at the rear.
Record the serial number in the space provided below. Refer to
these numbers whenever
ページ2に含まれる内容の要旨
Note: WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. To reduce fire or shock hazard, do not These limits are designed to provide reasonable expose the unit to rain or moisture. protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
ページ3に含まれる内容の要旨
Declaration of Conformity Declaration of Conformity Trade Name: SONY Trade Name: SONY Model No.: DPF-D710 Model No.: DPF-D820 Responsible Party: Sony Electronics Inc. Responsible Party: Sony Electronics Inc. Address: 16530 Via Esprillo, San Diego, Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A. CA 92127 U.S.A. Telephone No.: 858-942-2230 Telephone No.: 858-942-2230 This device complies with part 15 of the FCC This device complies with part 15 of the FCC Rules. Operation is subject to t
ページ4に含まれる内容の要旨
Disposal of waste batteries For the State of California, USA (applicable in the European Union only and other European countries with Perchlorate Material - special handling may apply, separate collection systems) See This symbol on the battery or on the www.dtsc.ca.gov/hazardouswaste/perchlorate packaging indicates that the battery Perchlorate Material: Lithium battery contains provided with this product shall not be perchlorate. treated as household waste. On certain batteries this s
ページ5に含まれる内容の要旨
Notice for users Read this before using Program © 2010 Sony Corporation Notes on playback Documentation © 2010 Sony Corporation Connect the AC adaptor to an easily accessible AC outlet. Should you notice an abnormality in it, disconnect it from the AC outlet immediately. All rights reserved. This manual or the software described herein, in whole or in part, may not be Notes on copyrights reproduced, translated or reduced to any machine Duplication, edition, or printing of a CD, TV readable
ページ6に含まれる内容の要旨
Table of Contents Read this before using ......................................................................................5 For your safety Checking included items ...................................................................................8 Identifying the parts ..........................................................................................9 x Digital photo frame ...............................................................................................9 x Remote cont
ページ7に含まれる内容の要旨
Changing the settings of the auto power on/off function ............................... 24 Changing the settings .................................................................................... 26 Displaying an image stored in a USB memory device .................................... 27 Connecting to a computer .............................................................................. 28 Troubleshooting If an error message appears ..........................................................
ページ8に含まれる内容の要旨
oyou saey For your safety Checking included items Make sure that the following items are included. Digital photo frame (1) Stand (1) Attaching to the screw hole (page 11) , Remote control (1) (except for DPF- Removing the protective sheet D700) (page 11) , AC adaptor (1) Connecting to the AC power source (page 13) , Operating Instructions (this manual) (1) The supplied CD-ROM contains the Digital Photo CD-ROM (Digital Photo Frame Frame Handbook that explains operations and setups Handb
ページ9に含まれる内容の要旨
For your safety Identifying the parts x Digital photo frame Front LCD screen Remote sensor (except for DPF-D700) Sony logo Rear BACK button ENTER button Direction (v/V) buttons Direction (B/b) buttons MENU button VIEW MODE button (page 16) 1 (on/standby) button Standby Indicator EXT INTERFACE (USB A) connector USB mini B connector (page 28) Memory card slot (page 15) Access lamp Holes for hanging unit on the wall DC IN 12 V jack (DPF-D1020/D1010) / DC IN 5 V jack (DPF-D820/D810/D720/D710/D700) S
ページ10に含まれる内容の要旨
x Remote control (except for DPF-D700) VIEW MODE buttons 1 (on/standby) button SLIDE-SHOW ( ) button SINGLE button CLOCK ( ) button INDEX ( ) button MENU button Zoom in ( ) button Direction (B/b/v/V) buttons ENTER ( ) button BACK button Zoom out ( ) button MARKING ( ) button IMPORT ( ) button SORT button DELETE ( ) button SELECT DEVICE button ROTATE ( ) button About descriptions in this manual The operations described in this manual are based on those with the buttons on the photo frame. Wh
ページ11に含まれる内容の要旨
Let’s get the photo frame ready Let’s get the photo frame ready P Notes Remote control (except for DPF- � If the remote control stops working: D700) Replace the battery (CR2025 lithium battery) with a new one. � When the lithium battery becomes Pull out the protective sheet before use as shown in the weak, the operating distance of the remote control may shorten, or the figure. remote control may not function properly. In this case, replace the battery with a Sony CR2025 lithium batter
ページ12に含まれる内容の要旨
To display the photo frame on the wall PNotes � Use screws suitable for the quality of the material of the wall. The 1 Prepare screws (not supplied) suitable for the screw screws may be damaged, depending on the type of material holes on the rear panel. used in the wall. Set the screws in a pillar or stud in the wall. 3 4 mm ( /16 inch) � When you want to re-insert the memory card, remove the photo frame from the wall, then eject and More than 25 mm (1 inch) re-insert the memory card wh
ページ13に含まれる内容の要旨
Let’s get the photo frame ready PNotes Turning the photo frame on � The socket outlet should be as close as possible to the unit, and easily accessible. � Do not place the photo frame on an 1 Insert the plug of the AC adaptor into the DC IN 12 V unsteady or tilted surface. jack (DPF- D1020/D1010) / DC IN 5 V jack (DPF- � Connect the AC adaptor to an easily D820/D810/D720/D710/D700) on the rear of the photo accessible wall outlet close by. If frame. trouble occurs while using the adaptor,
ページ14に含まれる内容の要旨
Operations in an initial state zTips When the photo frame is turned on, the initial display appears. x If the photo frame is not operated If the photo frame is not operated for 10 seconds, the demo mode is displayed. x Releasing the demonstration mode If any other button than the power button is pressed, the screen returns to the initial display. Setting the current time 1 Press MENU, and B/b to select the (Settings) tab. v/V [Date/time Settings] , ENTER 2 Press v/V to select [Time] ,
ページ15に含まれる内容の要旨
Let’s view an image Let’s view an image PNote Inserting a memory card When using a memory card of the following types, make sure to insert it in an appropriate adaptor. Insert a memory card firmly into the corresponding slot If you insert it without an adaptor, with its label side facing toward you (when you are facing you may be unable to remove it. As the back side of the photo frame). shown in the right-most illustration below, make sure to insert the following types of memory cards
ページ16に含まれる内容の要旨
Changing the display 1 Press VIEW MODE repeatedly to select the view mode you want to display. PNote If you do not operate the photo frame for a certain period of time, the style indicated by the cursor is automatically selected. The display changes to the selected view mode. Using the remote control (except for DPF-D700) z Tip Press the VIEW MODE button corresponding to the view Style descriptions: mode you want to display. CD-ROM (Handbook) – “Changing the display” VIEW MODE buttons 2 Pr
ページ17に含まれる内容の要旨
Let’s view an image – Number of pixels (width × height) About the information displayed – Playback duration on the LCD screen –File size 4Setting information Icons Meaning Protect indication Associated file indication (Displayed when there is an associated file such as a motion file or a miniature e-mail image file.) Displays when you have registered a mark. The following information is displayed. Displays a video file. (DPF-D1020/D820/D720 only) 1Display type (In the Single view mode) –
ページ18に含まれる内容の要旨
PNote Playing a video file (DPF-D1020/ � You cannot play the following type of video file: D820/D720 only) – Video files processed with other video codec than The operations described in this section are based on those with the Motion JPEG buttons on the supplied remote control. – Video files that exceed maximum number of pixels either in width or height 1 Select a video file. (We cannot guarantee operation 1Press SINGLE. with video files not mentioned 2Press B/b to select the desired s
ページ19に含まれる内容の要旨
Let’s view an image z Tips Playing a slideshow with � To clear the selection, select the file to be cleared then press background music (DPF-D1020/ ENTER. The check mark (✔) next to the selected file disappears. D820/D720 only) � To delete a music file imported to internal memory, select [Delete BGM] on the [Slideshow Settings] screen in step 2 then press Importing a music file ENTER. Press v/V to select the music file you want to delete from the music file list and press 1 Insert a m
ページ20に含まれる内容の要旨
5 Press MENU. When you select (Slideshow) on the view mode screen, the music file with a check mark (✔) is played. PNotes Playing background music with a slideshow � Fast forward/backward playback of background music is not available. Also, you cannot change 1 Press MENU, select the (Settings) tab with B/b, the playback order of background then press v/V to select [Slideshow BGM Settings]. music files. � Background music cannot be 2 Press v/V to select [BGM ON/OFF] and press played d
