ページ1に含まれる内容の要旨
Nokia Remote Camera
User guide
ページ2に含まれる内容の要旨
DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product PT-6 is in conformity with the provisions of the following Council Directive: 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/. Copyright © 2004-2005 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permissi
ページ3に含まれる内容の要旨
For your safety Read these simple guidelines. Not following them may be dangerous or illegal. SWITCH ON SAFELY Do not switch the device on when wireless phone use is prohibited or when it may cause interference or danger. ROAD SAFETY COMES FIRST Do not install the device in a vehicle. Do not use the device or your mobile phone to control or configure the device while driving; park the vehicle first. INTERFERENCE All wireless devices may be susceptible to interference, which could affect per
ページ4に含まれる内容の要旨
Contents 1. Introduction ......................................................................................6 About your camera............................................................................................................7 Network services................................................................................................................7 Battery information ..........................................................................................................8 Ba
ページ5に含まれる内容の要旨
General camera settings ............................................................................................................ 40 Time and date settings ............................................................................................................... 42 Notification settings ................................................................................................................... 44 Security settings....................................................................
ページ6に含まれる内容の要旨
Int r odu ct ion 1. Introduction The Nokia Remote Camera is an imaging device with a motion detector, thermometer, and microphone. With the camera you can capture still images and video clips remotely, and send them to your multimedia messaging (MMS) enabled mobile phone, or to an e-mail address. You control and configure the camera with text messages (SMS) or with the Remote Camera Manager application that can be downloaded from the camera to a compatible phone. See “Download Remote Camer
ページ7に含まれる内容の要旨
Introd uction Note: Check how large MMS messages your compatible mobile phone is capable of receiving. Your network operator may also restrict the size of MMS messages. Ask your network operator for details. The images and messages sent from the camera are charged to the subscription of the SIM card in the camera. Your device supports the sending of text messages beyond the normal 160-character limit. If your message exceeds 160 characters, it is sent as a series of two or more messages.
ページ8に含まれる内容の要旨
Int r odu ct ion ■ Battery information The Nokia Remote Camera contains a back-up battery which is used when there is a mains power cut. Therefore, the camera is not switched off during a mains power cut, unless the back-up battery runs out. Batteries and power supply Check the model number of any power supply before use with this device. This device is intended for use when supplied with power from the Nokia power supply AC-12. Warning: Use only batteries, power supplies, and enhancements
ページ9に含まれる内容の要旨
Introd uction example, when you carry a spare battery in your pocket or purse. Short- circuiting the terminals may damage the battery or the connecting object. Leaving the battery in hot or cold places will reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire! Dispose of batteri
ページ10に含まれる内容の要旨
Int r odu ct ion Important: Do not connect the power supply to a mains outlet when damp or wet. ■ Sales package contents The sales package of the Nokia Remote Camera includes the following: Nokia Remote Camera Back-up battery BL-5C Power supply AC-12 Stand cover Assembly kit for mounting the camera onto a wall or ceiling Outdoor shield for additional protection of the camera against heat and rain User guide ■ Camera features The camera has the following parts: Light indicators
ページ11に含まれる内容の要旨
F i r s t start-up 2. First start-up 1 To remove the back cover of the camera, press the buttons on the side (1) and slide the cover in the direction of the arrow (2). Note: Before removing the cover, always switch off the power and disconnect the power supply and any other device. Avoid touching electronic components while changing the covers. Always store and use the device with the covers attached. Figure 2 2 Open the battery lid, and release the SIM card holder. Figure 3 3 Insert your SI
ページ12に含まれる内容の要旨
Fi r s t start-up Figure 4 4 Insert the battery, close the battery lid, and replace the back cover. Always switch the device off and disconnect the charger before removing the battery. Figure 5 5 Connect the power supply to the mains outlet, and connect the power supply to the bottom of the camera stand. Wait for 15 seconds for the camera to start charging (the light indicator starts to blink green).The power supply also charges the back-up battery. Figure 6 12 Copyright © 2005 Nokia. All
ページ13に含まれる内容の要旨
F i r s t start-up Check the model number of any charger or power supply before use with this device. This device is intended for use when supplied with power from the Nokia power supply AC-12. Warning: Use only batteries, power supplies, and enhancements approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty, and may be dangerous. For availability of approved enhancements, please check with your dealer. When you disconnec
ページ14に含まれる内容の要旨
Fi r s t start-up If you enter a wrong digit, press the power button with short presses until the letter is displayed. Wait for 3 seconds, and re-enter the PIN code from the start. When you have entered all the digits of the PIN code, wait for 10 seconds. If you entered the PIN code correctly, the light indicators scroll up and down until the camera is connected to the network. The camera stores the PIN code in its memory and uses it automatically each time the camera is switched on. If y
ページ15に含まれる内容の要旨
F i r s t start-up The camera sends you a confirmation message when it has completed your request. 9 The camera starts searching for an MMS access point. The MMS access point contains all the settings needed to send multimedia messages. When the camera finds an access point, it sends you a text message. If the camera finds several access points, it sends you a list of the access points. Select an access point, and send the following command to the camera: 42 number of access point in the l
ページ16に含まれる内容の要旨
Fi r s t start-up Note on motion detection Motion detection is based on changes in the surrounding temperature, and thus it may react to flows of warm air, for example, when opening a door, if the camera is pointed towards the door. Also the distance from which the camera detects motion depends on the surrounding temperature: the greater the difference between the surrounding temperature and human body temperature, the farther the camera detects motion. The camera does not detect motion if
ページ17に含まれる内容の要旨
F i r s t start-up Figure 9 2 Attach the stand cover. Figure 10 3 Turn the camera in the desired position, and tighten the screw. Mind the power cord when turning the camera. Figure 11 17 Copyright © 2005 Nokia. All rights reserved.
ページ18に含まれる内容の要旨
Fi r s t start-up 4 If you use the camera outdoors, attach the outdoor shield. Figure 12 Place the camera on a desk 1 Turn the camera in the desired position, and tighten the screw as shown in Figure 11. 2 Attach the stand cover to the camera. See “Figure 10” on page 17. To remove the stand cover, press the hole in the stand cover with a pin or a small screw driver, and lift the stand cover. ■ Switch off the camera To switch off the camera, press the power button for a few seconds. The camera
ページ19に含まれる内容の要旨
F i r s t start-up phone, enter the code *#2820#. The Bluetooth address is displayed on the phone. 2 Ensure that Bluetooth is switched on in the phone. You must be within 10 metres of the camera to use Bluetooth wireless technology. 3 Send the following text message to the camera: 82 Bluetooth address of your phone The camera creates a Bluetooth connection to your mobile phone, and your phone starts downloading Remote Camera Manager from the camera. You can use and configure the camera with
ページ20に含まれる内容の要旨
Bas i c us e 3. Basic use You can operate the camera by sending text messages to the camera or with the Remote Camera Manager application. See “Download Remote Camera Manager” on page 18. Remote Camera Manager enables establishing a wireless Bluetooth connection between the camera and a mobile phone if they are within 10 metres of each other. Configuring the camera using Bluetooth is free. The master user of the camera has the right to use all camera functions. If other users are added to
