ページ1に含まれる内容の要旨
Digital
Video Camera
Let’s Make Memories
User Guide
Please read these instructions
completely, before operating
this product.
memorexelectronics.com
MCC215
ページ2に含まれる内容の要旨
CONTENTS Contents................................................1 • Viewing the Version ........................26 Safety Precautions................................2 • Setting the Icon...............................27 Location of Controls...........................4 • Turning the Audio Recording Using the Strap ...................................6 On and Off ......................................28 Getting Started ....................................7 • Changing the TV System................29
ページ3に含まれる内容の要旨
SAFETY PRECAUTIONS FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
ページ4に含まれる内容の要旨
SAFETY PRECAUTIONS Be sure to observe the following precautions when using the unit: • This unit works best when used in bright lighting, such as sunlight or a brightly-lit room. Results in dimly-lit areas will vary. • Never attempt your own repairs. Always leave service to authorized repair facilities. • Keep the unit away from water and other liquids, and never let it get wet. Never use when it is raining or snowing. • Should foreign matter or water get into the unit, immediately turn the powe
ページ5に含まれる内容の要旨
LOCATION OF CONTROLS REAR/INTERIOR 6 1 7 2 8 3 4 5 9 AV CABLE PART NO. 1. Up π Button E532R4POLAR0001* 2. OK Button 3. Display USB CABLE PART NO. 4. Down † Button E531RAMTOMIN008* 5. MENU Button 6. Power Button *Consumer Replaceable Part 7. Mode Control (See page 46 to order.) 8. SHUTTER Button 9. USB/TV OUT Jacks (Under Compartment) 4
ページ6に含まれる内容の要旨
LOCATION OF CONTROLS (CONTINUED) FRONT/SIDE 6 1 2 3 4 6 5 1. Battery Compartment 6. Strap Holders (BATTERY COVER PART NO. (HANDSTRAP PART NO. P337RBDV096C011*) K910RDV096C0001*) 2. Speaker CD PART NO. K539RCD096C0001* 3. Lens 4. SD/MMC Card Slot (Bottom of *Consumer Replaceable Part Unit) (See page 46 to order.) 5. Microphone 5
ページ7に含まれる内容の要旨
USING THE STRAP 1 2 Insert the Velcro straps into each of the Press the velcro ends onto the straps to Strap Holders. adjust the length of the straps as desired. 3 Fold over the Strap Flap and connect as shown. Adjust as desired to fit your hand. 6
ページ8に含まれる内容の要旨
GETTING STARTED INSTALLING THE BATTERIES 1 2 Remove the battery compartment cover by Slide the cover back on. sliding it off. Insert three (3) AAA batteries NOTE: When the batteries are low, the into the battery compartment, observing the battery low indicator will blink in the display. polarity marks (+/–) as shown. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1.Use only the size and type of batteries specified. 2.Be sure to follow the correct polarity when
ページ9に含まれる内容の要旨
GETTING STARTED (CONTINUED) TURNING THE POWER ON AND OFF 1 2 Press the Power button to turn the unit Press and hold the Power button until on. “Memorex” will appear briefly in the “Goodbye” appears in the display display. (approximately one second). NOTE: To save the battery power, the unit will automatically turn off after 60 seconds of inactivity, but the pictures will remain in memory. 8
ページ10に含まれる内容の要旨
GETTING STARTED (CONTINUED) INSERTING AN SD/MMC MEMORY CARD (UP TO 2 GB) An SD/MMC card must be inserted in 1 order to take pictures/videos with this camera. Insert the SD/MMC card with the label side facing the display side of the camera as shown. HINTS ON USING AN SD/MMC CARD: 1. When an SD/MMC card is inserted, the Card indicator will appear in the display and new pictures taken will be stored on the SD/MMC card automatically. 2. Push the SD/MMC card all the way in to make sure the SD/MMC car
ページ11に含まれる内容の要旨
P SET OPERATION TAKING A SINGLE PICTURE 1 2 1 1 2 2 Press the Power button 1 to turn the Press the Up π button 1 to zoom in or unit on. Rotate the Mode control 2 to the Down † button 2 to zoom out as the Picture Taking position. desired. This zoom function works only for resolutions of 640 x 480 and 1280 x 1024. NOTES: 3 • Keep the object in the center of the display and an acceptable distance from the camera. • Set the desired picture settings as indicated, beginning on page 11. Press the Shutt
ページ12に含まれる内容の要旨
P SET 4 OPERATION (CONTINUED) CHANGING THE PICTURE MODE 1 2 1 2 Press the Power button 1 to turn the Press the MENU button and the settings will appear. unit on. Rotate the Mode control 2 to the Picture Taking position. Single Picture 3 Continuous Three Pictures 10 Seconds Self-Timer 1 15 Seconds Self-Timer 2 3 20 Seconds Self-Timer Press the Up π button 1 or the Down † button 2 to select the Picture Mode setting (see above). Press the MENU button 3 to select the desired Picture Mode, and then p
ページ13に含まれる内容の要旨
P SET 4 OPERATION (CONTINUED) CHANGING THE PICTURE RESOLUTION 1 2 1 2 Press the MENU button and the Press the Power button 1 to turn the settings will appear. unit on. Rotate the Mode control 2 to the Picture Taking position. 0.3 Mega Pixels 3 1.3 Mega Pixels 1 2.0 Mega Pixels (interpolated) 3.0 Mega Pixels (interpolated) 2 3 Press the Up π button 1 or the Down † button 2 to select the Resolution setting (see above). Press the MENU button 3 to select the desired Resolution, and then press the OK
ページ14に含まれる内容の要旨
P SET 4 OPERATION (CONTINUED) CHANGING THE WHITE BALANCE 1 2 1 2 Press the MENU button and the Press the Power button 1 to turn the settings will appear. unit on. Rotate the Mode control 2 to the Picture Taking position. Auto Adjusts White balance 3 Under Sunlight 1 Under Cloudy Skies Under Tungsten 2 3 Under Fluorescent Lights Press the Up π button 1 or the Down † button 2 to select the White Balance setting (see above). Press the MENU button 3 to select the desired White Balance, and then pres
ページ15に含まれる内容の要旨
P SET 4 OPERATION (CONTINUED) CHANGING THE EV COMPENSATION 1 2 1 2 Press the Power button 1 to turn the Press the MENU button and the settings will appear. unit on. Rotate the Mode control 2 to the Picture Taking position. EV+2 EV-1.5 3 EV+1.5 EV-2.0 1 EV+1 EV+0 2 3 EV-1 Press the Up π button 1 or the Down † button 2 to select the EV Compensation setting (see above). Press the MENU button 3 to select the desired EV Compensation, and then press the OK button 4 to confirm and exit. 14 SET V
ページ16に含まれる内容の要旨
SET V OPERATION (CONTINUED) VIEWING THE PICTURES 1 2 1 P 1 2 2 Press the Power button 1 to turn the Press the Up π button 1 or the Down unit on. Rotate the Mode control 2 to † button 2 to select other pictures. the Picture Viewing position. 3 2 1 To delete the selected picture, press the MENU button 1. Press it again to select 1, then press the OK button 2. “Y” and “N” will appear in the display. Select “Y” to delete the last picture taken, or select “N” to exit. To delete all pictures, press th
ページ17に含まれる内容の要旨
SET OPERATION (CONTINUED) RECORDING A VIDEO 1 2 1 2 Press the Power button 1 to turn the Press the Shutter button and then the unit will start recording the video and unit on. Rotate the Mode control 2 to the counter will start counting. Press the Video Taking position. the Shutter button again to stop recording. NOTES: • Keep the object in the center of the display and an acceptable distance from the camera. • Set the desired video settings as indicated, beginning on page 17. 16 SET V P
ページ18に含まれる内容の要旨
SET 4 OPERATION (CONTINUED) CHANGING THE VIDEO RESOLUTION 1 2 1 2 Press the Power button 1 to turn the Press the MENU button and the settings will appear. unit on. Rotate the Mode control 2 to the Video Recording position. QVGA (Good Quality) 3 VGA (Best Quality) 1 2 3 Press the Up π button 1 or the Down † button 2 to select the Resolution setting (see above). Press the MENU button 3 to select the desired Resolution, and then press the OK button 4 to confirm and exit. 17 SET V P
ページ19に含まれる内容の要旨
SET 4 OPERATION (CONTINUED) CHANGING THE WHITE BALANCE 1 2 1 2 Press the MENU button and the Press the Power button 1 to turn the settings will appear. unit on. Rotate the Mode control 2 to the Video Recording position. 3 Auto Adjusts White balance Under Sunlight 1 Under Cloudy Skies Under Tungsten 2 3 Under Fluorescent Lights Press the Up π button 1 or the Down † button 2 to select the White Balance setting (see above). Press the MENU button 3 to select the desired White Balance, and then press
ページ20に含まれる内容の要旨
SET 4 OPERATION (CONTINUED) CHANGING THE EV COMPENSATION 1 2 1 2 Press the MENU button and the Press the Power button 1 to turn the settings will appear. unit on. Rotate the Mode control 2 to the Video Recording position. EV+2 EV-1.5 3 EV+1.5 EV-2.0 1 EV+1 EV+0 2 3 EV-1 Press the Up π button 1 or the Down † button 2 to select the EV Compensation setting (see above). Press the MENU button 3 to select the desired EV Compensation, and then press the OK button 4 to confirm and exit. 19 SET V P
