ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
English Operating instructions Before operating the unit, please read this manual thoroughly, and retain it for future reference. As you read through this manual, buttons and settings on the camera are shown in capital letters. e.g., Press FLASH. WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to const
ページ3に含まれる内容の要旨
CAUTION Never expose the battery pack to temperatures above 140°F (60°C), such as in a car parked in the sun or under direct sunlight. TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Note: This equipment has been tested and fo
ページ4に含まれる内容の要旨
NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i.e., marked with or mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse co
ページ5に含まれる内容の要旨
Table of contents Before using your camera ....................................................................... 7 Parts identification .................................................................................. 8 Basic operations Preparation ...................................................................................... 11 1: Charging the battery pack ........................................... 11 2: Installing the battery pack .......................................... 12 3: Se
ページ6に含まれる内容の要旨
Be sure to read before using your camera Trial recording Before you record one-time events, you may want to make a trial recording to make sure that the camera is working correctly. No compensation for contents of the recording Contents of the recording cannot be compensated for if recording or playback is not made due to a malfunction of the camera, floppy disk, etc. Precautions on camera care The LCD screen is manufactured using high-precision technology. However, there may be some tiny black
ページ7に含まれる内容の要旨
Before using your camera This digital still camera uses a floppy disk as media. Use the following floppy disk type. •Size: 3.5 inch •Type: 2HD •Capacity: 1.44 MB •Format: MS-DOS format (512 bytes × 18 sector) When using 3.5 inch, 2HD floppy disk other than described above, format it using the camera or personal computer. Do not shake or strike the unit Malfunctions, inability to record images as well as inability to use floppy disks or image and memory data breakdown, damage or loss may occur. D
ページ8に含まれる内容の要旨
Parts identification See pages in ( ) for more details. Lens Shutter button (16) Photocell window Lens cap for flash Do not block when recording. Flash emitter (10) Slot for AC power adaptor code Self-timer lamp The lamp keeps on blinking until Tripod receptacle recording starts after Make sure that the length of the the shutter button is tripod screw is less than depressed. 7/32 inch (6.5 mm). To insert the floppy disk Insert the floppy disk until it clicks. Before inserting, chec
ページ9に含まれる内容の要旨
Hooks for strap Attaching the shoulder strap BRIGHT +/– button Press to adjust the brightness of the LCD screen. PLAY/CAMERA LCD screen switch (16, 18) POWER switch Slide down to turn on/off the Lithium battery power. compartment (33) ACCESS lamp (16) PICTURE EFFECT button (31) DISK EJECT lever PROGRAM AE button (32) (8) DISPLAY button Battery cover/ Press to display or go off the OPEN (BATT) indicators on the LCD screen. button (12) The indicators do not go off in the following
ページ10に含まれる内容の要旨
Zoom lever “T” side: for telephoto (subject appears closer) “W” side: for wide-angle (subject appears farther away) Move the zoom lever to the “W” side until the focus is sharp. You can shoot a subject that is at least about 3 1/4 feet (about 100 cm) away from the lens surface in the telephoto position, or about 1/2 inch (about 1 cm) away in the wide-angle position. Floppy disk slot FLASH CHARGE lamp Flash button AUTO is set at the factory. Each time you press the button, the flash mode changes
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
kPreparation Installing the battery pack 1 Open the battery cover. While sliding OPEN (BATT) in the direction of the arrow. (base) 2 Install the battery pack. Insert the battery pack with the V mark facing toward the battery compartment. 2 3 Close the cover. 1 Press the cover until it clicks. To remove the battery pack Open the battery cover. While sliding the battery release lever rightward, remove the battery pack. Be careful not to drop the battery pack when removing. Battery release lever Re
ページ13に含まれる内容の要旨
Basic operations About the power source This camera can be powered from the following two power sources: •Sony InfoLithium battery* (L series), NP-F330 (supplied)/F530 (not supplied)/F550 (not supplied) •AC power adopter AC-VQ800 (not supplied) When you use the camera for a long time, we recommend you to power the camera from a wall outlet with the AC power adaptor. * “InfoLITHIUM” battery pack The “InfoLITHIUM” is a lithium ion battery pack which can exchange data with compatible equipment abou
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
Basic operations The indicators during recording The indicators on the LCD screen are not recorded. Flash indicator AE lock indicator /Flash level indicator Self-timer indicator Recording mode indicator Image quality Program AE indicator indicator Remaining disk capacity indicator Exposure/Zoom BMP STD W T 10 indicator* No. of stored E : 91 : 01 SEPIA images Picture effect indicator Self-diagnosis function indicator LCD brightness –EV +EV indicator* MENU 110min Adjusting the Remaining
ページ18に含まれる内容の要旨
kRecording and playing back images Playing back images on the LCD screen To watch the recorded images, slide POWER down to turn on the power and insert the floppy disk until clicks. 1 Set PLAY/CAMERA to PLAY. The last recorded image appears on the LCD screen. 2 Select the recorded image with the control button. Select the button on the LCD screen with the control button, then press it. : To display the preceding recorded image. : To display the next image. : To display 6 recorded images at a tim
ページ19に含まれる内容の要旨
Basic operations The indicators during playback Image number File type indicator Image quality indicator STD Remaining disk capacity indicator 11/12 Number of stored images in the floppy disk File name MVC-011S 1999 7 4 Recording date of the playback 12:30PM MENU INDEX image 110min Remaining battery time indicator Slide show button * INDEX button MENU button Image search buttons / buttons (Single screen mode)/ / buttons (Index screen mode) * Only displayed when the MULTI
ページ20に含まれる内容の要旨
kRecording and playing back images Battery life/No. of images that can be recorded/played back Battery Battery life No. of images (min.) (record/playback) Continuous recording 1) NP-F330 Unusing the flash 70 (60) 950 (850) 2) (Supplied) Using the flash 60 (50) 600 (500) 3) Continuous playing 110 (100) 1700 (1500) Continuous recording 1) Unusing the flash 130 (110) 1750 (1500) NP-F530 2) Using the flash 120 (100) 1200 (1000) 3) Continuous playing 230 (200) 3400 (3000) Continuous recording 1) Unus
