ページ1に含まれる内容の要旨
20” Color Television TTM-2004
ページ2に含まれる内容の要旨
Important Safeguards This symbol indicates that this product incor- CA CA CA CA CAUTION UTION UTION UTION UTION porates double insulation between hazard- ous mains voltage and user accessible parts. RISK OF ELECTRIC SHOCK When servicing use only identical replace- DO NOT OPEN ment parts. Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. This symbol indicates im- This symbol indicates “d
ページ3に含まれる内容の要旨
Important safeguards 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the appa- ratus. When a cart is used, use caution when mov- ing the carts/apparatus combination to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or p
ページ4に含まれる内容の要旨
Contents Overview 4 Remote control 5 Basic operation 6 Menu overview 7 External connection 8 Using the PICTURE menu 10 Using the P.LOCK menu 11 Using the TIMER menu 13 Using the PRESET menu 14 Using the EXTRA menu 15 Picture defects and countermeasures (VHF/UHF reception) 16 Troubleshooting 17 Specifications 18 3
ページ5に含まれる内容の要旨
Overview 1. Power Button 2. Remote Sensor 3. Power Indicator 4. TV/AV Selection Button 5. Volume Down Button 6. Volume Up Button 7. Program Down Button 3 2 1 8. Program Up Button 9. Menu Button 10. Video Input Jack 11. Audio Input Jack 49 5 6 7 8 10 11 12 12. Headphone 13. Antenna Jack 13 Remote control 4
ページ6に含まれる内容の要旨
Remote control Power key Mute Key Press once to turn off the volume Timer Key Press again to restore Use this key to select the sleep timer Number Keys Two keys must be pressed to Display Key select a channel when when Use this key to display the ANTENNA is se to AIR. For current channel information channels 2 through 9, press 0 (such as channel, time, etc.), first,then the channel number press it again to exit. (for example, 02,12). Three keys must be pressed when you se- Picture Key lect a c
ページ7に含まれる内容の要旨
Basic operation Connect to AC outlet Insert the mains wire plug of the unit into 120V AC outlet, unplug the AC cord when the unit will not be used for a long period time. How to power on/off You can turn on the power by using the POWER button at TV front panel (or the POWER button on the remote control). Non-signal power-off in 10 minutes If the unit doesn’t receive a signal state, the TV will enter standby mode automatically in 10 minutes. To turn it on, press the POWER button on the remote con
ページ8に含まれる内容の要旨
Menu overview The PICTURE menu will allow you to make adjustments to your pic- ture settings. You can set P.LOCK and V-CHIP in this menu. The TIMER menu sets the clock on your TV and allows you to program your TV for scheduled viewing by using the ON/OFF timer. The PRESET menu provides sev- eral options for your channel set- tings. G Set CCD, LANGUAGE and BLUE BACKGROUND in this menu. Menu basic operation 1. To enter a menu, press the menu button on the TV (or on the remote control), then use th
ページ9に含まれる内容の要旨
External connection CONNECTING TO AC POWER SUPPLY Use the AC polarized line cord provided for op- eration on AC. Insert the AC cord plug into a po- larized AC outlet. AC Outlet NOTE: Polarized AC Plug If the polarized AC plug does not fit into a non- polarized AC outlet, do not attempt to fix or cut the blade of the plug. It is the user’s responsibility to have an electrician replace the obsolete outlet. Connecting Antenna to TV Choose the type of antenna hook-up style (A,B,C or D) that resembl
ページ10に含まれる内容の要旨
External connection Connecting an Antenna or Cable System to VCR and TV Antenna Choose your antenna hook-up style A, B or C and connect to “IN FROM ANT.” on the VCR. Connect cable from “OUT TO TV” on VCR directly to the 75 Ω input terminal on your TV. STYLE A STYLE B STYLE C 75 Ω TERMINAL BACK OF VCR IN OUT BACK TV PANEL Cable Service Connect cable directly to “IN FROM ANT” on VCR . (If using a cable box, connect cable to input on box. Connect cable from output on box to “IN FROM ANT” on
ページ11に含まれる内容の要旨
Using the PICTURE menu Using the SETUP menu Adjust left to decrease picture contrast. CONTRAST Adjust right to increase picture contrast. Adjust left to darken the picture. BRIGHT Adjust right to brighten the picture. Adjust left to decrease color intensity or saturation. COLOR Adjust right to increase color intensity or saturation. Adjust left to decrease the red tone. TINT Adjust right to increase the red tone. Adjust left to soften the picture detail. SHARPNESS Adjust right to sharpen the pic
ページ12に含まれる内容の要旨
Using the P.LOCK menu Using the SETUP menu (continued) Figure 1 Note: 1. When you enter P.LOCK submenu first time, red “NEW CODE” will display on the menu, input four-digit numbers as your password by pressing 0-9 buttons. After you input the numbers, blue “ENTER CODE” will display on the menu, input again the password you have set to enter P.LOCK submenu, the submenu will display as the following: Figure 2 2. If you have set your password, when you want to enter P.LOCK submenu, the menu wi
ページ13に含まれる内容の要旨
Using the P.LOCK menu Using the V-CHIP menu V-CHIP Select this item to enter V-CHIP submenu. V-CHIP ON: Turn on V-CHIP function. OFF: Turn off V-CHIP function. MPAA RATING: Set MPAA rating. “BLOCK” prohibits watching the BLOCK channels, VIEW permits watching all channels. If ab high rating is set as “VIEW”, lower ratings will be set to VIEW mode. If a low rating is set to “BLOCK”, higher ratings will be set to BLOCK mode. G: For all children. PG: Directed to old children. PG-13: General Audience
ページ14に含まれる内容の要旨
Using the TIMER menu CLOCK Press number buttons to set HOUR and MINUTE. Press VOL button to circles between AM and PM. ON: Set the timer to be active. TIMER OFF: Turn off the timer. Note: Clock must be programmed before you can use the timer. Press number buttons to set HOUR and MINUTE. ON TIME Press VOL button to set AM or PM. Note: ON-TIME will turn on the TV automatically at preset time, and this func- tion activates only when you set TIMER ON. You can press 0-9 number buttons or PROG. / b
ページ15に含まれる内容の要旨
Using the PRESET menu G CH NO. Press number buttons or VOL / button to select your desired channel. ADDED: Select to add the channel that you selected in CH NO. CH DELETED: Select to delete the channel that you selected in CH NO. AIR: Select to receive television broadcast signal. ANTENNA CABLE: Select to receive cable signal. Select to start automatic channel search and store. AUTO PROGRAM Note: TIMER, ON TIME, ON CH, OFF TIME items in TIMER submenu will be reset when changing between AIR and
ページ16に含まれる内容の要旨
Using the EXTRA menu C1: Select to display Caption 1. CC C2: Select to display Caption 2. C MUTE: Only after pressing MUTE button, CAPTION will be displayed on the screen. TEXT1: Select it to display TEXT 1. TEXT2: Select it to display TEXT 2. OFF: Turn off the Caption. Tips: CAPTION prepared for TV programs can be pre-recorded (movies, daytime dramas etc.) This type of CAPTION is normally 1 or 2 lines of text. TEXT can include: Captioned program listing, farm news, sports report and news report
ページ17に含まれる内容の要旨
Troubleshooting VHF/UHF reception The most common types of television interference are as follows: SNOWY PICTURE Snowy picture is usually due to weak signal. Adjust antenna or install an antenna amplifier. DOUBLE IMAGE OR “GHOSTS” Double images are usually caused by reflections from tall buildings. Adjust the direction of the antenna or raise it. RADIO WAVE INTERFERENCE Wavy patterns are moving on the screen, which are usually caused by nearby radio transmitters or short- wave receiving equipme
ページ18に含まれる内容の要旨
Troubleshooting If you have any problem, check the countermeasures for each symptom listed below. The following symptoms may have been caused by inappropriate adjustments rather than actual malfunction of the unit. If the trouble persists, contact the service center. SYMPTOMS POSSIBLE SOLUTIONS Make sure the power cord is plugged in. TV does not operate Try another AC outlet. Power is off ; check fuse or circuit breaker. Station or CATV experiencing problems; tune to another sta- tion. Poor s
ページ19に含まれる内容の要旨
Specifications TUBE/POWER SUPPLY SIZE 20” ASPECT RATIO 4:3 POWER SUPPLY 120V~60Hz TUNER # OF CHANNELS 181 PICTURE CONTROLS TINT, COLOR, BRIGHTNESS, CONTRAST, SHARPNESS PICTURE SETTINGS PERSONAL, DYNAMIC, STANDARD, SOFT OSD LANGUAGES ENGLISH, FRENCH, SPANISH SOUND SPEAKER QUANTITY 2 AUDIO OUTPUT POWER 2W*2 CONNECTORS CABLE/ANTENNA INPUT 1 REAR AV INPUT 1FRONT HEADPHONE OUTPUT 1FRONT DIMENSIONS (INCH, WxDxH) 19.7 X 18.4 X 17.4 WEIGHT (LBS) 48.4 For service, support and warranty information, visit
