ページ1に含まれる内容の要旨
Instructions for use
_i!!iiiii
_AVOX
3135 015 10521
ページ2に含まれる内容の要旨
Once your PHILIPS MAGNAVOX purchase is registered, you're eligible to receive all the privileges of owning a PHILIPS MAGNAVOX product. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. _Model Your completed Warranty Registering your product within Registration Card serves as 10 days confirms your right to verification of ownership in the antees you'll receive all the infor- maximum protection under the matio
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS - Readbeforeoperatingequipment This product was designed and manufactured to meet strict quality and 11. Power-Cord Protection - Power supply cords should be routed so safety standards. Thereare, however, some installation and operation pre- that they are not likely to be walked on or pinched by items placed cautions which you should be particularly aware of. upon or against them, paying particular attention to cords and plugs, convenience receptacles, and the point where the
ページ4に含まれる内容の要旨
Introduction Here are a few of the special features built into this new Color Television: Welcome/Registration of Your TV ............................ 2 SmartLock TM feature allows you to block the view- Safety/Precautions ..................................................... 3 ing of certain channel or external audio/video con- Table of Contents ....................................................... 4 nections where you might not want your children Features ....................................
ページ5に含まれる内容の要旨
yhur Cable TV input into your ome may be a single (75 Remember: ! ohm) cable, or a Converter Box Set the TV for the installation. In either case the type signal you've connection to the TV is very easy. just,connected (see the Tuner' section Just put the threaded end of the on page 11 of this cable signal to the TWs antenna manual.) plug and screw it down tight, To select only the _If your Cable TV signal is a sin- channel numbers on gle round cable (75 ohm) then your Cable system you're ready t
ページ6に含まれる内容の要旨
A combination antenna receives normal broadcast channels Remember: t Be sure to set the (VHF 2-13 and UHF 14-69). Note: For homes with separate UHF and VHF antennas TV for the type sig- Your connection is easy since you will need an optionalcombiner to connect to the TV. nal you've connect- there is only one 75C_ (ohm) ed (see the "Tuner" u/v antenna plug on the back of your section on page I I TV - and that's where the antenna of this manual.) goes. To set the TV to Combiner has Found ,_ If you
ページ7に含まれる内容の要旨
TTv,he basic Antenna, or Cable to VCR to TV connection is shown to the right. For more information on other hookups (possible when Cable Converter/Descrambler boxes are included) refer to your accessory VCR and Cable Converter Owner's Manual for details. <_ Connect yourAntenna or Cable TV signal to the IN FROM ANT(enna) p ug on the VCR. <_ Connect the OUT TO TV plug TV (connecting cable supplied with the VCR.) on the VCR to the 75£2 plug on the 300 to 750 Outdoor Ohm Adapter VHF/UHF __Anlenna OU
ページ8に含まれる内容の要旨
71 <_ Press the POWER button to I turn the TV ON. <_ Press the VOLUME + button to increase the sound level or the VOLUME - button to lower the sound level. The Front AudioNideo Input Jacks make it real easy to watch the playback Pressing both buttons at the same of a video tape using a camcorder time will display the onscreen menu. (or any accessory device) with Once in the menu, use these button AudlolVideo Output Jacks. to make adjustments or selections. Remote Sensor Window or _ Press the CHA
ページ9に含まれる内容の要旨
Press to tam the TV ON and OFF. Press to set the TV to automatically turn itself OFF. cc Button Press to select Closed Caption options within the menu. Clock Button Press for direct entry of the TIMER (Clock) features were you can set the TV's clock, the Start Time, and the Start Channel Controls. Press the number buttons to select TV channels. For single digit entries, press the number of the channel you desire, The TV will pause for a few seconds, then change to the selected channel, For chann
ページ10に含まれる内容の要旨
Z2 For our Spanish and French speak-i ing TV owners an onscreen LAN- l GUAGE option is present. With the l LANGUAGE control you can set the I_,, GUAGE control you can set the I TV's onscreen menu to he shown in TV s onscreen menu to he shown in I either English, Spanish, or French. either English_ or French. l <_ L_ Press Press the the MENU MENU button button on on the the / remote to show the onscreen menu. I rem°te t° sh°w the °nscreen menu" / _ _Q::F <_2_ Press Press the the CURSOR CURSOR UP
ページ11に含まれる内容の要旨
Tehe TUNER feature allows you to hange the TV s signal input to either CABLE, AUTO or ANTENNA mode. It's important for the TV to know what type of signal to look.for: From a Cable TV signal or a nor- hal Antenna signal.) In the AUTO mode, when the AUTO PROGRAM /Oature is activated, the TV will auto- matically choose the correet mode. CC F [_-rw • I <_ Press the MENU button on the SmartLock REVIBN • LANGUAGE ENGLISH I remote to show the onscreen menu. BRIGHTNESSmlB,...... 30 ITU R c uq _--_ Press
ページ12に含まれる内容の要旨
7q -- Vour TV can automatically set itself I for local area (or Cable TV) chan- nels. This makes it easy for you to select only the TV stations in your area when the CHANNEL (+), (-) but- tons are pressed. Note: Make sure the antenna or cable signal connection has been completed before AUTO PROGRAM is used. CC _q: I rup •1 LANGUAGE EN(_ISH <_ Press the MENU button on the SmaFtLock REVEVV • TUNER CABLE BRIGHTNESS _........ 30 remote to show the onscreen menu. lAUra mOemU •1 <_ Press the CURSOR UP
ページ13に含まれる内容の要旨
E-q w Channel Edit makes it easy for you to ADD or DELETE channels from the list of channels stored in the TV_s memory. <_ Press the MENU button on the I remote to show the onscreen menu. <_ Press the CURSOR UP • or O£17< • DOWN • buttons to scroll through CC OFF the onscreen menu until the word I -ruP •1 TUNER CABLE SETUP s h gh ghted. SrnartLockREVEVV • AUTOP_ • BRIGHTNESS I_'....... 30 <_ Press the CURSOR RIGHT • button to display the SETUP menu features. <_ Press the CURSOR UP • or DOWN • bu
ページ14に含まれる内容の要旨
[3 trois, select a channel and follow the steps shown below." _ To adjust your TV picture con- @ Press the MENU button on the remote to display the onscreen menu. <_ Press the CURSOR UP • or SEILP • DOWN • buttons until the word Smar'tLock _ • BRIGHTNESS is highlighted. (Or, IBRI_T_SS m ....... 301 COLOR, PICTURE, SHARPNESS, SmartLock REbIEVV • COLOR ll' ....... 30 TINT, COL. TEMP depending on the BRIC4HTNESSi ....... 30 PICILIRE B ....... 30 adjustment you want to make.) [COLOR PICTURE _ ......
ページ15に含まれる内容の要旨
rrVhe Contrast Plus (Black Stretch) J. feature helps to "sharpen" the picture quality. The black portions of the picture become richer in dark- ness and the whites become brighter: <_ Press the MENU button on the I remote to display the onscreen menu. '_ Press the CURSOR UP • or TINT ....... +....... O CURSOR DOWN • buttons until COL.TEMP the words CONTRAST PLUS are _NT ....... +....... 0 )CONTRAST PLUS OFFI OOL TEMP NORMAL h gh ghted. NOISEREDUCTION ON Iaor, rrR_'rPLUS ONI VOLUME ram, ....... 1
ページ16に含まれる内容の要旨
FOer reasons such as poor cable ception, the picture can some- times appear slightly "speckled" (or signal noise shown in the picture). The NOISE REDUCTION control can help eliminate this type of interference and improve the quality of the picture. <_ Press the MENU button on the COL_MP NORMAL ...... di I remote to display the onscmen menu. CONTRAST PLUS ON <_ Press the CURSOR UP • or IN_m _ ..... COL"fEMP NORMAL CURSOR DOWN • button until VOLUME I ....... 15 CONTRASTPLUS ON the words NOISE REDU
ページ17に含まれる内容の要旨
y;ur television comes with an nscreen clock. During normal operation the clock appears on the screen when the STATUS/EXIT but- ton is pressed or when channel changes occur <_ Press the CLOCK button on the remote to display the onscreen CLOCK menu. JcK --:--AMI T1MERACTIVE ON _ Press the CURSOR UP • OR CHANNEL 12 CURSOR DOWN • buttons until [SETCLOCK 10:00 AMI the words SET CLOCK are high- TIMERACqqk_ ON ghted. CHANNEL 12 <_;_ Enter the current time using the NUMBERED buttons. If the first numbe
ページ18に含まれる内容の要旨
ES] lust like an alarm clock you can J set the TV to turn itself on at the same time ev_ _ Press the CLOCK button to display the Clock onscreen menu. '_ Press the CURSOR UP • or CURSOR DOWN • button until the words TIMER ACTIVE are highlighted. <_ Press the CURSOR RIGHT SETCLOO( 10:Q3 AM I_ or CURSOR LEFT • button I]IMER At-roVE 0NI to select ON (if activating) or OFF CHANNEL 12 if deactivating) the Timer control. Sq-ART TIME -- : -- AM < Remember: Be sure to set g the clock to the current time,
ページ19に含まれる内容の要旨
Used along with the Clock fea- tures, you can select a specific channel that the television will tune to when the Timer Active control is turned ON. ¢_ Press the CLOCK button to display the Clock onscreen menu. SETCLOCK 10:00 AM _ Press the CURSOR UP• or TIMERACTIVE ON CURSOR DOWN • button until IC-_NB_ 12 I the word CHANNEL s highlighted. START_M_: - _: - - AM _ Press the number buttons to w _ nt_ rd the, :tarte t_ 2in i"o 'eltY otLt oo Remember: Be sure to set g the Timer Active control to ON.
ページ20に含まれる内容の要旨
U_ed along with the Clock fea- ure, you can select a specific time the television will turn on when the Timer Active control is turned ON. <_ Press the CLOCK button to display the Clock onscreen menu. ]IMER _ ON ,_ Press the CURSOR UP • or CHANNEL 12 CURSOR DOWN • button until ]IMERACTlVE ON ISTART]qME --:--AM I the words START TIME are high- CHANNEL 12 I ghted. ISTART "riME 08:30 AMI <_ Enter the time to turn on the TV using the NUMBERED but- [tons. If the first number is a single [digit first
