ページ1に含まれる内容の要旨
ENGLISH
COLOUR TELEVISION
INSTRUCTIONS
AV-29Q317B AV-21Q317B
AV-29RXP8 AV-21R318
AV-29S357 AV-21RXP8
AV-21S357
This illustration shows AV-29S357.
The illustrations of AV-29S357 is used in this instruction manual for explanation
purpose. Your TV may not look exactly the same as illustrated.
GGT0158-001B-E
G GGT0158-001B-E-EN.indd 1 GT0158-001B-E-EN.indd 1 1 19-09-07 09:10:40 9-09-07 09:10:40
ページ2に含まれる内容の要旨
Thank you for buying this JVC colour television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. TO PREVENT FIRE OR SHOCK HAZARD, DO TO ENSURE PERSONAL SAFETY, OBSERVE THE NOT EXPOSE THIS APPLIANCE TO RAIN OR FOLLOWING RULES REGARDING THE USE OF WARNING CAUTION MOISTURE. THIS TV. • The apparatus • Operate only • Never block or cover the ventilation openings. shall not be from the • Never install the TV where good ventilation is unatt
ページ3に含まれる内容の要旨
PREPARATION FUNCTIONS REFERENCE Knowing your TV’s features Contents Please see the chart below and check the function are equipped for your TV's model number. Knowing your TV’s features ...................3 The model number is indicated at the rear of your TV. When you press a button concerned to a function Connections ..........................................4 that is not available for your TV, it does not work and the logo "Ø" appears on the screen. Initial settings .........................
ページ4に含まれる内容の要旨
IN(VIDEO-3) RV L/MONO Connections The illustration of AV-29S357 is shown here for explanation purpose. Your TV may not look exactly the same as illustrated. CAUTION Ensure to turn off all equipments including the TV before connecting the AC mains plug to the AC outlet. Connecting to the aerial cable and VCR Connecting to the rear component/video input terminal and output terminal VHF/UHF TV rear terminals outdoor aerial VCR (for playing) DVD player (composite signals) 75-ohm coaxial cable VC
ページ5に含まれる内容の要旨
PREPARATION Initial settings Edit the channel list Turn on the TV 4 1 or wait 15 seconds to To edit the run Setup Tour channel list, To complete \ page 15. JVC logo appears Setup Tour To restart Setup Tour after above setup has completed Select a language 1 2 Select (while the cursor is pointing to Vieät PICTURE MODE and within 3 seconds) 2 Confirm Searching for the channels (AUTO PROGRAM) AUTO PROGRAM 3 22% OK / : EDIT To stop or wait until AUTO PROG
ページ6に含まれる内容の要旨
Remote control buttons and basic functions Turn the TV on from standby and vice versa • Insert two batteries by following the and polarities and inserting the end Programme and recall 4 favourite channels first. (colour buttons: red, green, yellow, blue) • Use AA/R6/UM-3 dry cell batteries. Choose the TV channel you wish to programme • If the remote control does not work properly, fit new batteries. The supplied batteries are for testing, not regular use. PROGRAMMED! ■ Press and hold any
ページ7に含まれる内容の要旨
PREPARATION TV buttons and functions The illustration of AV-29S357 is shown here for explanation purpose. Your TV may not look exactly the same as illustrated. TV or Video terminal input selection, Exit from the menu Video and audio Display the menu and exit after finish setting input jacks for VIDEO-3 mode Channel selection, To select menu function ECO sensor TV’s main power on/off Volume level adjustment, To choose a Top Remote control sensor Headphone jack menu and adjust the desired menu
ページ8に含まれる内容の要旨
Operating the menus (continued) You can use the DVD MENU by switch channel to VIDEO-2 or press the DVD MENU button on the remote control. See the menus location in the below table. For RF / Video-1 / Video-3 (MENU) For Video-2 (DVD MENU) Top menu Page 2nd menu 3rd menu / Adjustments 3rd menu / Adjustments DVD THEATER STATUS set to OFF : USER / SHARP / CLEAR / VIVID / SOFT 9 PICTURE MODE USER / VIVID / SOFT DVD THEATER STATUS set to ON : USER / SHARP / CLEAR PICTURE PICTURE MODE set to USER : CON
ページ9に含まれる内容の要旨
FUNCTIONS Picture setting COLOUR SYSTEM WHITE BALANCE You can change the white balance of the picture to better match the type You can select the appropriate colour system when the picture is not clear of video being viewed. or no colour appears. MENU PICTURE menu WHITE BALANCE AUTO → PAL → SECAM → NTSC3.58 → NTSC4.43 NORMAL Normal white balance You can also operate this function from the menu. COOL Bluish white MENU SET UP menu COLOUR SYSTEM WARM Reddish white For the colour system in each co
ページ10に含まれる内容の要旨
Picture setting (continued) PICTURE SETTING AI ECO SENSOR (ECO)/ECO MODE You can adjust the desired picture setting when selecting USER in You can automatically adjust TV screen contrast according to the PICTURE MODE. brightness of your room. MENU PICTURE menu PICTURE MODE USER OFF Cancel the function. 1 MODE-1/ECO-1 Mild contrast (recommended). MENU PICTURE menu PICTURE SETTING 2 MODE-2/ECO-2 Even contrast. CONTRAST 2 : Lower contrast 3 : Higher contrast DISPLAY (for Al ECO SENSOR only)
ページ11に含まれる内容の要旨
FUNCTIONS Picture in picture (PIP) operation Sound setting You can display a sub picture within the main picture on the screen. MaxxBass You can enjoy an enhanced bass sound which cannot be played by to display the sub picture. normal speakers. You can hear the sound from the main picture only. OFF MaxxBass is turned off. When main picture and sub picture are the same TV channel: HIGH MaxxBass effect is high. LOW MaxxBass effect is
ページ12に含まれる内容の要旨
Sound setting (continued) BALANCE SOUND SYSTEM You can adjust the volume balance between the left and right speakers. You can select an appropriate sound system when abnormal sound occurs even when the picture appears normal. MENU SOUND menu BALANCE B/G → I → D/K → M SOUND MODE This function is not available in video mode. You can choose the desired sound setting. For the sound system in each country or region, see the table below: USER Change the sound setting as you like. Area Country or Regi
ページ13に含まれる内容の要旨
FUNCTIONS Customized setting AUTO SIGNAL DETECT VNR When the DVD input signal is detected, the input mode will automatically You can reduce the picture noise. change to VIDEO-2 and when the DVD input signal is not detected, the MENU PICTURE menu VNR input mode will automatically change to RF previous input mode. OFF VNR is turned off. DVD players: Press the “POWER ON” button on the player for signal detection. AUTO Effect of VNR is automatically controlled. VCRs: Press the “POWER ON” button on
ページ14に含まれる内容の要旨
Customized setting (continued) ON TIMER BEEP You can set the TV to turn on automatically from standby mode at a set You can use the BEEP function to alert you during AUTO SIGNAL channel and time. DETECT, Al ECO SENSOR Detect, Stereo Detect, ON TIMER/OFF TIMER operations and when some buttons on the remote control are MENU FEATURES menu ON TIMER 1 pressed. MENU FEATURES menu BEEP (Choose ON or OFF) CHILD LOCK You can disable the front control buttons of the TV. 2 Choos
ページ15に含まれる内容の要旨
FUNCTIONS TV channel presetting To register the TV channels automatically OR 6 to search for the TV channel. (AUTO PROGRAM) (red) (green) You can register the TV channels automatically. 7 Searching stops when a channel is found and displayed. MENU SET UP menu AUTO PROGRAM 1 If the reception is Press the yellow or blue button to fine tune the TV AUTO PROGRAM poor channel. 2 If noisy sound is Press the 3 button to choose an appropriate sound 22% heard system. or
ページ16に含まれる内容の要旨
TV channel presetting (continued) CH/CC number CC US CCIR OIRT AUSTRALIA CH US CCIR OIRT AUSTRALIA When you want to use the INSERT function on CC 18 E S-18 CH 33 US-33, W+48 E33 AU-34 CC 19 F S-19 CH 34 US-34, W+49 E34 AU-35 page 15, find the CH/CC number corresponding CH 35 US-35, W+50 E35 AU-36 CC 20 G S-20 to the channel number of the TV channel from CC 21 H S-21 CH 36 US-36, W+51 E36 AU-37 CC 22 I S-22 CH 37 US-37, W+52 E37 AU-38 this table. CC 23 J S-23 CH 38 US-38, W+53 E38 AU-39/AU-40 C
ページ17に含まれる内容の要旨
REFERENCE Troubleshooting If a problem occurs when you are using the TV, check the below Problem Cause / Solution Page troubleshooting guide before calling for repair. Colour patches appear • This maybe due to magnetized device such – at the corner of the as a speaker placed near to your TV. Move it Problem Cause / Solution Page screen away from your TV. Alternatively, you can also No picture, no sound • Deactivate the BLUE BACK function if it is 10 use the magnetic shielded speaker. turned o
ページ18に含まれる内容の要旨
Specifications MODE AV-21Q317B AV-21R318 AV-21RXP8 AV-21S357 TV RF systems B, G, I, D, K, M Colour systems (RF mode) PAL, SECAM, NTSC3.58 MHz, NTSC4.43 MHz (VIDEO mode) PAL, SECAM, NTSC3.58 MHz, NTSC4.43 MHz Channel and Frequencies VHF low channel (VL) : 46.25 to 140.25 MHz VHF high channel (VH) : 147.25 to 423.25 MHz UHF channel (U) : 431 to 863.25 MHz *Receives cable in mid band ( X to Z, S1 to S10, super band (S11 to S20) and hyper band (S21 to S41) Power input AC 110 to 240 V, 50/60 Hz (o
ページ19に含まれる内容の要旨
REFERENCE Specifications MODE AV-29Q317B AV-29RXP8 AV-29S357 TV RF systems B, G, I, D, K, M Colour systems (RF mode) PAL, SECAM, NTSC3.58 MHz, NTSC4.43 MHz (VIDEO mode) PAL, SECAM, NTSC3.58 MHz, NTSC4.43 MHz Channel and Frequencies VHF low channel (VL) : 46.25 to 140.25 MHz VHF high channel (VH) : 147.25 to 423.25 MHz UHF channel (U) : 431 to 863.25 MHz *Receives cable in mid band ( X to Z, S1 to S10, super band (S11 to S20) and hyper band (S21 to S41) Power input AC 110 to 240 V, 50/60 Hz (o
ページ20に含まれる内容の要旨
© 2007 Victor Company of Japan, Limited 0707SCT-NF-MT G GGT0158-001B-E-EN.indd 20 GT0158-001B-E-EN.indd 20 1 19-09-07 09:11:26 9-09-07 09:11:26
