ページ1に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION
TM
EMERSON AND THE G-CLEF LOGO ARE REGISTERED TRADEMARKS
OF EMERSON RADIO CORP., PARSIPPANY, NEW JERSEY, U.S.A.
20” Digital / Analog
Television
Owner’s Manual
CR202EM8
TO RECEIVE DIGITAL/ANALOG SIGNAL,
YOU MUST CONNECT ANTENNA.
IF YOU NEED ADDITIONAL ASSISTANCE WITH SETUP OR OPERATING AFTER
READING OWNER’S MANUAL, PLEASE CALL TOLL FREE 1-800-256-2487, OR
VISIT OUR WEB SITE AT http://www.EmersonAu
ページ2に含まれる内容の要旨
NTRODUCTION I WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC RISK OF ELECTRIC SHOCK SHOCK IS PRESENT WITHIN THIS UNIT. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS SYMBOL INDICATES THAT THERE ARE DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE IMPORTANT OPERATING AND MAINTENANCE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVI
ページ3に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION 15. POWER LINES - An outside antenna system should not be located c. If the TV has been exposed to rain or water. in the vicinity of overhead power lines or other electric light of d. If the TV does not operate normally by following the operating power circuits, or where it can fall into such power lines or circuits. instructions. Adjust only those controls that are covered by the When instal
ページ4に含まれる内容の要旨
NTRODUCTION I LOCATION For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation: • Shield it from direct sunlight and keep it away from sources of intense heat. • Avoid dusty or humid places. • Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes. • Ins
ページ5に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION Features Contents • DTV/TV/CATV INTRODUCTION - You can use your remote control to select Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 channels which are broadcast in digital format and Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Supplied Accessories
ページ6に含まれる内容の要旨
NTRODUCTION I Remote Control Function 1. POWER button (p10) 7. DTV/TV button (p13) Press to turn the unit on and off. P ress to switch between the digital 2. Number buttons (p12) mode (DTV) and analog mode DTV POWER / TV • Press to select channels. (TV). 1 7 AUDIO INFO -/ENT button 8. INFO button (p13) 8 • P ress to shift the minor channel Digital Mode (DTV) 9 1 2 3 from the major channel. • P ress to display the channel +100 button number and the program 4 5 6 2 • P ress to select
ページ7に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION Control Panel 1. Infrared Sensor Window Receives infrared rays transmitted from the remote control. 2. POWER button (p10) Press to turn the unit on and off. K L 3. CHANNEL / buttons (p12) Press to select channels or move up/down through the main menu items. X Y 4. VOLUME / buttons (p12) X Y Press to adjust the volume or move right( )/left( ) through the main menu items. 5. MENU button (p
ページ8に含まれる内容の要旨
ONNECTION C Cables not included. Please purchase the necessary cables at your local store. Basic Connection This section describes how to connect the unit to an antenna, cable/satellite box, etc. Note: • Be sure your antenna or other device is connected properly before plugging in the power cord. [Antenna Cable Connection] When connecting the unit to an antenna or cable TV company (without cable/satellite box) Connect the RF coaxial cable on your home outlet to the antenna input jack of this
ページ9に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION Cables not included. Please purchase the necessary cables at your local store. External Device Connection [S-video or Video Cable Connection (Rear)] S-video connection offers good picture quality for video devices connected to the unit. Video connection offers standard picture quality for video devices connected to the unit. Make the connection as illustrated below. When the audio jack of the video
ページ10に含まれる内容の要旨
NITIAL SETTING I These operations are accessible by remote control. Some may also be accessible by controls on the main unit. Initial Setup Note: • If you connect the cable system directly, contact the CATV This section will guide you through the unit’s initial setting which includes installer. selecting a language for your on-screen menu and “AUTO PRESET CH”, which • If you press [POWER] or [MENU] during “AUTO PRESET CH”, automatically scans and memorizes viewable channels. this settin
ページ11に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION Note: Auto Channel Scan • If you connect the cable system directly, contact the CATV If you switch wires (e.g., between antenna and CATV) or if you move the installer. unit to a diff erent area after the initial setting, or if you recover the DTV • If you press [POWER] or [MENU] during “AUTO PRESET CH”, channel you deleted, you will need to perform auto channel scan. the setting will be canceled
ページ12に含まれる内容の要旨
ATCHING TV W Channel Selection Volume Adjustment K Select channels by pressing [CH /L] or [the Number buttons]. This section describes how to adjust the volume. The mute function, which turns the sound off and on, is also described. • To select the memorized channels, Use [VOL X / Y] to adjust the audio volume. use [CH K / L] or [the Number buttons]. • T o select the non-memorized channels, use [the Number buttons]. VOL or VOL To Use [the Number buttons] TV VOLUME 20 - When selectin
ページ13に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION DTV Switching Each Mode You can easily switch with the remote control to the DTV (ATSC) and TV In the digital mode, the detailed broadcasting information for the current (NTSC) or to access an external device when they are connected to the unit. channel such as program title, the program guides are displayed. Press [DTV/TV] repeatedly to change the input mode. Press [INFO] repeatedly to cycle throu
ページ14に含まれる内容の要旨
ATCHING TV W TV Screen Display Mode Sleep Timer DTV The sleep timer can be set to automatically turn off the unit after an incremental period of time. 2 types of display modes can be selected in the digital mode when the broadcasting station is sending 16:9 video signal. Press [MENU] to display the main menu. Press [SLEEP] to set the sleep timer. 1 1 MENU SLEEP Use [CH K / L] to select “DTV SETUP”, then press 2 SLEEP OFF [VOL X]. e.g.) digital TV mode • Sleep timer display appear
ページ15に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION PTIONAL SETTING O Channel Add/Delete The channel add/delete function lets you add the channel that was not added by the auto channel scan due to the reception status at the initial setting. You can also delete the unnecessary channels. Press [MENU] to exit. Press [MENU] to display the main menu. 6 1 MENU MENU Note: Use [CH K / L] to select “CHANNEL SETUP”, 2 • ” ADD/DELETE(DTV)” or “ADD/DELETE
ページ16に含まれる内容の要旨
PTIONAL SETTING O Picture Adjustment Closed Caption You can adjust brightness, contrast, color, tint and sharpness. You can view closed captioning (cc) for TV programs, movies and news. Closed caption refer to text of dialogue or descriptions displayed on-screen for the hearing impaired. Press [MENU] to display the main menu. Press [MENU] to display the main menu. 1 1 MENU MENU Use [CH K / L] to select “PICTURE”, then press [VOL X]. Use [CH K / L] to select “CAPTION”, 2 2 then use [VOL X /
ページ17に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION DTV Closed Caption DTV In addition to the basic closed caption described on page 16, DTV has its own closed caption called DTVCC. Use this menu to change the settings for DTVCC. Press [MENU] to exit. Press [MENU] to display the main menu. 3 1 MENU MENU K Use [CH / L] to select “DTV SETUP“, 2 Note: then press [VOL X] . • To show the closed caption on your TV screen, broadcast signal must conta
ページ18に含まれる内容の要旨
PTIONAL SETTING O DTVCC Style DTV You can change the style of DTV CC such as font, color or size, etc. Press [MENU] to display the main menu. • CAPTION SIZE 1 Closed captioning font size can be changed as below. • FONT STYLE MENU Font style of the displayed caption can be switched as below. • CHARACTER EDGE Use [CH K / L] to select “DTV SETUP”, 2 Edge type of the displayed caption can be switched then press [VOL X]. as below. e.g.) digital TV mode • FORE COLOR, BACK COLOR
ページ19に含まれる内容の要旨
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION V-chip V-chip reads the ratings for programs, then denies access to the programs which exceed the rating level you set. With this function, you can block certain programming inappropriate for children. Use [the Number buttons] to enter the 4-digit Press [MENU] to display the main menu. 3 1 numbers for your password. 1 2 3 MENU PASSWORD 4 5 6 - - - - Use [CH K / L] to select “V-CHIP SETUP“,
ページ20に含まれる内容の要旨
PTIONAL SETTING O A. TV Rating [To Set the Sub Ratings] Use [CH K / L] to select “TV RATING“, 4 As for TV-Y7, TV-PG, TV-14 or TV-MA, you can further then press [VOL X]. set the sub ratings to block specific elements of e.g.) digital TV mode CH programming. To set the sub ratings, follow the steps - V - CHIP SETUP - or below. TV RATING CH MPAA RATING DOWNLOADABLE RATING Use [CH K / L ] to select the desired main rating, CHANGE PASSWORD 1 then press [VOL X] twice to show
