ページ1に含まれる内容の要旨
4-204-616-67
R
420461667
Trinitron Colour
Television
GB
Instruction Manual
KV-28DS60U
KV-28DS65U
KV-32DS60U
KV-32DS65U
©1999 by Sony Corporation Printed in UK
ページ2に含まれる内容の要旨
NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A molded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA ASA or BSI to BS 1362 (i.e. marked with T or ) must be used. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has
ページ3に含まれる内容の要旨
GB Instruction Manual 1
ページ4に含まれる内容の要旨
General operation of your remote control 2
ページ5に含まれる内容の要旨
Table of contents Safety First 4 Quick Start Guide 5 Checking the accessories supplied 5 Inserting batteries into the remote control 5 Connecting the speakers 6 Connecting the aerial 8 Switching on the TV 8 Automatically tuning the TV 9 Viewing digital or analogue channels 10 Overview 11 Overview of the TV set buttons 11 Overview of the remote control buttons 12 Additional TV Features 13 Adjusting the picture 13 Changing picture and sound modes quickly 13 Adjusting the sound 14 Setting up Dolby
ページ6に含まれる内容の要旨
Safety First Safety Information Televisions operate on extremely high voltages. To prevent fire or electric shock, please follow the safety procedures indicated below. For your own safety, never open the cabinet. Refer servicing to qualified personnel only. For General Safety • Do not expose the TV set to rain or moisture. • Do not remove the rear cover. For Safe Installation • Do not install the TV in hot, humid or excessively dusty places. • Do not block or cover the ventilation openings. For
ページ7に含まれる内容の要旨
Quick Start Guide Follow steps 1-7 to: Check the accessories supplied Insert batteries into your remote control Connect the speakers to your TV Connect the aerial to your TV Plug in and switch on the TV View programmes on your TV 1. Checking the accessories supplied Surround Speakers Batteries Remote Control Note: The remote control supplied may be type RM-892. However, the operating function of each button will be the same. 2. Inserting batteries into the remote control Always remember to dispo
ページ8に含まれる内容の要旨
Quick Start Guide 3.1. Connecting the speakers Before switching on the TV, you need to connect the speakers to the TV using the leads ! provided. The striped lead is for the red terminal of the speaker; the black lead for the black terminal. Dolby* ProLogic Surround normally requires 5 speakers: Centre Speaker (incorporated in the TV) - to anchor the stable sound image, like dialogues, to the TV screen. Left and Right Front Speakers (incorporated in the TV) - for the normal two channel stereo o
ページ9に含まれる内容の要旨
Quick Start Guide 3.2. Connecting the speakers b) To connect your own speakers (when using your own speakers, make sure they are at least 4 ohms impedance and magnetically shielded): striped black lead lead 2S S 4 1/ 1 2 4 L/G/ S/I C .... S R/D/ D/D S R/D/D/D L/G/S/I MODEM 7 Surround Speakers Centre Speaker Your sitting position
ページ10に含まれる内容の要旨
Quick Start Guide 4. Connecting the aerial Connect a conventional aerial to the socket marked on the rear of the TV. 1/ 1 2 S 2 4 S 4 S/I L/G/ C .... S R/D/ D/D S MODEM R/D/D/D L/G/S/I 5. Switching on the TV Connect the TV plug to the mains socket (220- 240V AC, 50Hz) and switch on. Push in the on/off switch on the front of the TV. 8
ページ11に含まれる内容の要旨
Quick Start Guide 6. Automatically tuning the TV You can tune the TV to receive the new digital channels and/or the traditional analogue channels. If at any time during this procedure you want to return to the normal TV picture, press the MENU button. SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] 1 Press the MENU button on the remote control to display Screen Position [ 0 ] Strobe Str
ページ12に含まれる内容の要旨
Quick Start Guide 7. Viewing digital or analogue channels Once you have tuned in the new digital channels and/or the traditional analogue channels, you have the option to view the digital or analogue channels using the TV menu system or the channel table. SCREEN MODE Using the TV menu system Screen Mode [zoom ] Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] Strobe Strobe Auto 16:9 [on] Correction
ページ13に含まれる内容の要旨
Overview Overview of the TV set buttons You must press the control button to activate and illuminate the control panel before you can use the other buttons on the top of the TV set. Programme Up (+) or Down (-) buttons. Press to select TV channels. Volume control buttons. Press to increase (+)/decrease (-) volume. CONTROL button. Video input button. Press to activate and illuminate the control panel. Press to select the input signals fromVCR etc. PROGR – + – + CONTROL On/Off Switch. Press to swi
ページ14に含まれる内容の要旨
Overview Overview of the remote control buttons VCR on/off button Press to temporarily switch off To mute sound VCR (if Sony VCR connected). Press again to switch on VCR. Press to mute TV sound. Press again to To temporarily switch off TV restore the sound. Press to temporarily switch off TV. Press again to switch on TV from standby mode. NOTE: After 15 -30 minutes without a TV signal To return to TV mode and without any button being pressed, the TV Press to return to the normal operation switc
ページ15に含まれる内容の要旨
Additional TV Features Adjusting the picture Although the picture is adjusted at the factory, you can modify it to suit your own taste. SCREEN MODE Screen Mode [zoom ] 1 Press the MENU button on the remote control to display Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] the menu on the TV screen. Strobe Strobe Auto 16:9 [on] Correction [off] Auto 16:9 [on] Correction [off] 2 Move the OK button
ページ16に含まれる内容の要旨
Additional TV Features Adjusting the sound Although the sound is adjusted at the factory, you can modify it to suit your own taste. SCREEN MODE 1 Press the MENU button on the remote control to display Screen Mode [zoom ] Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] the menu on the TV screen. Screen Position [ 0 ] Strobe Strobe Auto 16:9 [on] Correction [off] Auto 16:9 [on] Correction [off] 2 Move the OK button on t
ページ17に含まれる内容の要旨
Additional TV Features Setting up Dolby ProLogic Before listening to Dolby Surround sound, you can adapt the Dolby features to suit your own taste. It is normal to set up the levels and modes of the speakers only when installing the TV and the speakers or when changing the position of the speakers. SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] 1 Press the MENU button on the remote control to display the S
ページ18に含まれる内容の要旨
Additional TV Features Changing the screen mode Using this Screen Mode feature you can change the aspect ratio of the screen or reproduce the main picture image by image (Strobe function). SCREEN MODE Screen Mode [zoom ] 1 Press the MENU button on the remote control to display Screen Position [ 0 ] SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] the menu on the TV screen. Strobe Strobe Auto 16:9 [on] Correction [off] A
ページ19に含まれる内容の要旨
Additional TV Features Exchanging programme positions After tuning you may wish to change the channel order on the TV. You may wish for example to exchange the channel on programme number 8 with the channel on programme number 10. SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] 1 Press the MENU button on the remote control to display SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] Strobe Strobe Auto 16:9 [on] th
ページ20に含まれる内容の要旨
Additional TV Features Using the parental lock This function enables you to prevent children watching undesirable broadcasts. SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] 1 Press the MENU button on the remote control to display SCREEN MODE Screen Mode [zoom ] Screen Position [ 0 ] Strobe Strobe the menu on the TV screen. Auto 16:9 [on] Correction [off] Auto 16:9 [on] [off] Correction 2 Move the OK button on the remo
