ページ1に含まれる内容の要旨
4-075-587-22
TM
Operating Instructions
KV-32FV16 KV-36FS12 KV-36FV16
© 2000 by Sony Corporation KV-32FV26 KV-36FS16 KV-36FV26
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Important Safeguards For your protection, please read these instructions completely, and Attachments keep this manual for future reference. Do not use attachments not recommended by the Carefully observe and comply with all warnings, cautions and manufacturer, as they may cause hazards. instructions placed on the set, or described in the operating instructions or service manual. WARNING Cleaning To guard against injury, the following basic safety precautions should be observed in the install
ページ4に含まれる内容の要旨
Power-Cord Protection Service Do not allow anything to rest on or roll over the power cord, and do not place the set where the Damage Requiring Service power cord is subject to wear or abuse. Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions: Antennas ❑ When the power cord or plug is damaged or frayed. Outdoor Antenna Grounding If an outdoor antenna is installed, follow the precautions below. An ❑ If liquid has been spilled
ページ5に含まれる内容の要旨
Contents Introducing the FD Trinitron Wega Using the Menus Overview................................................................1 Overview..............................................................25 Presenting the FD Trinitron Wega......................2 Using the Video Menu .......................................26 Using the Remote Control ...................................3 Using the Audio Menu ......................................27 Using the Channel Menu.............................
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
Introducing the FD Trinitron Wega Overview This chapter defines the contents of your Wega TV, and provides an overview of how to set up and use basic features. Topic Page Presenting the FD Trinitron Wega 2 Using the Remote Control 3 1
ページ8に含まれる内容の要旨
Introducing the FD Trinitron Wega Presenting the FD Trinitron Wega The FD Trinitron Wega (pronounced VAY-GAH) is characterized by outstanding contrast, uncompromising accuracy, and corner-to- corner detail. You’ll recognize the superiority of Wega technology almost immediately. The first thing you’ll notice is minimal glare from the flat picture tube. This flat-screen technology improves picture detail without distortion, unlike conventional curved screens. The FD Trinitron delivers outs
ページ9に含まれる内容の要旨
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
Installing the TV Overview This chapter includes illustrated instructions for setting up your TV: Topic Page Connecting a Cable or Antenna 6 Connecting a VCR and Cable 9 Connecting a VCR and Cable Box 10 Connecting Two VCRs for Tape Editing 11 Connecting a Satellite Receiver 12 Connecting a Satellite Receiver with a VCR 13 Connecting an Audio Receiver 14 Connecting a DVD Player with Component Video 15 Connectors Connecting a DVD Player with A/V Connectors 16 Connecting a Camcorder 17 Using the
ページ12に含まれる内容の要旨
Installing the TV Connecting a Cable or Antenna Connecting Directly The connection you choose depends on the cable found in your home. Newer homes are equipped with standard coaxial cable (see to Cable or an A); older homes probably have 300-ohm twin lead cable (see B); still Antenna other homes may contain both (see C). A VHF Only or VHF/UHF or Cable VHF/UHF 75-ohm Rear of TV coaxial cable B VHF Only or UHF Only or VHF/UHF 300-ohm twin VHF/UHF lead cable Rear of TV Antenna connector C VHF
ページ13に含まれる内容の要旨
Installing the TV Cable and Antenna If your cable provider does not feature local channels, you may find this set up convenient. ✍ This connection applies to all models except KV-36FS12. AUX CATV cable Rear of TV (No connection to TO CONVERTER) TO CONVERTER Antenna cable VHF/UHF Select CABLE or antenna (ANT) mode by pressing ANT on the remote control. ✍ In order to receive channels with an antenna, you need to turn your Cable to OFF and perform the Auto Program function (see page 29). Cable
ページ14に含まれる内容の要旨
Installing the TV Cable Box and Cable For this set up, you can switch between scrambled channels (through your cable box), and normal (CATV) channels by pressing ANT on the remote control. ✍ This connection applies to all models except KV-36FS12. Cable box AUX Rear of TV IN OUT TO CONVERTER 75-ohm coaxial cable (not supplied) Signal VHF/UHF CATV cable (unscrambled channels) ✍ Your Sony remote control can be programmed to operate your cable box (see “Programming the Remote Control” on page 42)
ページ15に含まれる内容の要旨
Installing the TV Connecting a VCR and Cable 1 Connect the cable TV cable to the VCR’s IN jack. 2 Using a coaxial cable, connect the VCR’s OUT jack to the TV’s VHF/UHF jack. 3 Using an A/V cable, connect the VCR’s A/V OUT jacks to the TV’s A/V IN jacks. ✍ If your VCR has an S VIDEO jack: For best picture quality, use an S VIDEO connection instead of the yellow video cable on your combined A/V cable. Using an S VIDEO cable, connect the VCR’s S VIDEO OUT jack to the TV’s S VIDEO IN jack. S VID
ページ16に含まれる内容の要旨
Installing the TV Connecting a VCR and Cable Box ✍ This connection applies to all models except KV-36FS12. 1 Connect your incoming cable connection to the TV’s VHF/UHF jack. 2 Using a coaxial cable, connect the cable box’s IN jack to the TV’s TO CONVERTER jack. 3 Using a coaxial cable, connect the cable box’s OUT jack to the VCR’s VHF/UHF IN jack. 4 Using an A/V cable, connect the VCR’s A/V OUT jacks to the TV’s A/V IN jacks. ✍ If your VCR has an S VIDEO jack: For best picture quality, use
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
Installing the TV Connecting a Satellite Receiver with a VCR 1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE IN jack. 2 Connect the CATV cable to the VCR’s VHF/UHF IN jack. 3 Using a coaxial cable, connect the VCR’s OUT jack to the TV’s VHF/UHF jack. 4 Using an A/V cable, connect the satellite receiver’s A/V OUT jacks to the VCR’s A/V IN jacks. 5 Using an A/V cable, connect the VCR’s A/V OUT jacks to the TV’s A/V IN jacks. Satellite receiver TV Coaxial cable VCR
ページ20に含まれる内容の要旨
Installing the TV Connecting an Audio Receiver 1 Using audio cables, connect the TV’s AUDIO OUT jacks to the audio receiver’s audio LINE IN jacks. AUDIO-L (white) AUDIO-R (red) Line input 14
