ページ1に含まれる内容の要旨
43-144
5.8GHz Digital
Accessory Handset
for 43-141
43-142
43-143
What’s Included
• Handset (1) Handset (1) • Belt Clip (1) Belt Clip (1)
• Charger (1) • AC Adapter (1)
• Ni-MH Battery Pack (1) • User’s Guide (1)
(inside handset)
Please read this User’s Guide before installing,
setting up and using your new phone.
www.radioshack.com
UU01639BZ_1.indd 1 12/18/2006 11:09:36 AM
ページ2に含まれる内容の要旨
Contents Features 3 Introduction 4 Selecting a Location 4 Installing the Charger 5 Connecting/Charging the Battery 5 Installing a Belt Clip 8 Using an Optional Headset 8 Registeringthe Handset 9 Resetting Handsets 10 Resetting theHandset Without theBase 11 Controls & Functions 12 Reading the Display 13 UsingY our Accessory Handset 17 Using Hold,Conference, T ransferand Intercom 23 Care 25 Service and Repair 25 FCC Statement 25 Glossary 27 Limited One-Yea
ページ3に含まれる内容の要旨
Features Additional Handset — lets you addup to ten additional handsets to expand your telephone system ( RadioShack 43-141, 43-142 or 43-143). You can even transfer an outside callor make an intercom conversation between handsets. 5.8 GHz Digital Spread Spectrum System — spreads the signal across several frequencies,providing additional security for yourphone conversation. 10 Tone and 10 Melody Ringer Control — lets you control the waythe ring sounds. Voice Mail/Message
ページ4に含まれる内容の要旨
Introduction Thank you for purchasingthis RadioShack 5.8 GHz Accessory handset.Y ourhandset is designed for use with a RadioShack 5.8 GHzExpandable Cordless Telephone. You can use thishandset in any room inyour home or office that has an AC outlet. You can also transfer an outside call toanother handset. This handset is designed to work only with a RadioShack 5.8 GHz Expandable Cordless Telephone (Cat. No. 43-141, 43-142 and43-143). Do not try to useit
ページ5に含まれる内容の要旨
Installing the Charger You can power the charger usingthe supplied 9V, 210 mAA C adapter. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the bottom ofthe charger . Route the cord through thestrain relief slot and plug theadapter intoa standard AC outlet. Caution: You must use a Class 2 power source that supplies 9V DC and delivers at least 210 mA. Its center tip must be set to positive and its plug must fit the charger’s DC IN 9V jack. The
ページ6に含まれる内容の要旨
Before using your phone, you must install the battery pack, and then charge itfor about 15-20 hours. 1. Pressdown and slide the battery compartment cover off. 2. Plugthe battery pack’s connector into the socket in the compartment (the connector fits only one way), then placethe battery pack in thecompartment. MODELS VARY! PLACE HANDSET ON THEBASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL appears. 3. Replace the cover. To charge the battery pack, place the handset
ページ7に含まれる内容の要旨
About once a month, fully discharge the battery by keeping the handset offthe base or chargeruntil LOW BATTERY stays lit.Otherwise, the battery packloses its ability to fully recharge. If you are notgoing to useyour phone for an extended period, disconnect the battery pack.This increases the battery pack’s usablelife. Ifyou have troubleinstalling the battery pack, take the handsetto your local RadioShack store for assistance. Warning: • Dispose of old
ページ8に含まれる内容の要旨
Installing a Belt Clip To attach the belt clip, insert the belt clip into the holes on each sideof the cordless handset. Press downuntil it clicks. To remove the belt clip, pull either side of the belt clip to release thetabs from the holes. Using an Optional Headset You can make or answercalls handsfree using an optional headset that hasa 3/32-inch (2.5-mm) plug. Yourlocal RadioShack store hasa variety of headsetsavailable. 1. To connect the headset, gently flip
ページ9に含まれる内容の要旨
• Always place the handset properly on the charger NOTES whenever you are recharging the handset. • You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for added convenience. Registering the Handset You must register the handset tothe base before you can use it. Base Models 43-141, 43-142: To register to a 43-141 or 43-142 base,simply place the accessoryhandset in thebase. While the handset is registering, HANDSET REGISTE
ページ10に含まれる内容の要旨
Base Model 43-143: 1. On the base, press the MENU soft key. 2. Scroll down to REGISTER HANDSET and press the OK softkey . 3. On the handset, press and hold # untilthe display reads HANDSET REGISTERING and youhear a beep. 4. When REGISTRATION COMPLETE is displayed; the handset has been registered to the base. If REGISTRATION FAILED. appears, please try these steps again. Resetting Handsets Ifyou want to register a handsetto a different baseor replace a handset wi
ページ11に含まれる内容の要旨
3. DEREGISTER HS appears.Move the cursor to select YES. Press the OK soft key. 4. ARE YOUSURE? appears. Move the cursor to select YES, and then press the OK soft key. Youwill heara confirmation tone. Resetting the Handset Without the Base If the original base this handset was registered to is not available for some reason (forexample, it is lost or somehow incapacitated), you can still reset the handset and use it with anotherbase. 1. Pressand hold and # for mo
ページ12に含まれる内容の要旨
Controls & Functions Handset 1 6 2 7 3 8 4 9 14 10 15 16 11 17 5 12 18 13 19 20 21 22 1. Handset Antenna 12. /TONEkey 2. Headset Jack Cover 13. SPEAKERkey 14. key (up) 3. Belt Clip Hole 15. key (endcall) 4. SpeakerphoneSpeaker andRinger 16. key (caller ID) 17. key(down) 5. HandsetBattery Compartment 18. #key (pound) 6. New Messageindicator 19. REDIAL/PAUSE key 7. HandsetEarpiece 20. INT’COM/HOLD key 8. Handset Display (intercom/hold) 9. Soft keys 21. Han
ページ13に含まれる内容の要旨
Reading the Display The handset displayuses the following icons to tell you thestatus of your phone. ICON STATUS DESCRIPTION Talk Appearswhile on a call. Appears whenP rivacy modeis Talk turnedon. Appearswhile recording a Talk conversation(Answering System base only). Talk Appearswhen you mutethe handset. に Appearswhen the handset Talk speakerphone is in use. Appears when T-coilmode isturned Talk on. Appears whenLine 1is in use.(two
ページ14に含まれる内容の要旨
The Standby Screen When thephone is in standby, thehandset display shows the following items: Ringer off icon (when the ringer is off)/ SUN 12:00A day ofthe week and time/battery icon Handset #1 HandsetID andBanner New CID: 5 Numberof new Caller ID calls received REDIAL MENU (If there are nonew Caller IDmessages, theHandset ID appears here.) Illustration is of a single line system. Dual line NOTE systems will have different soft keys
ページ15に含まれる内容の要旨
Using the Handset Menus To open the menu, pressthe MENU soft key. Highlight the option you wantby pressing the four-way function key. This will move the cursor; the optioncurrently highlighted appearsin reversedout text. Select the highlighted option by pressingthe OK soft key. To exitthe menu and return to standby, press on the handset. If you do not pressa key within 30seconds, the phone will time out and exitthe menu. When setting Date
ページ16に含まれる内容の要旨
If two letters in a row usethe same number key, enter the first letter, then use right or left on the four-way function keyto move the cursor to the next position to enter the second letter. For example, toenter “Movies”: 1. Press 6 onceto enter M. 2. Use right on thefour -way function key to move the cursor to the right. 3. Press 6 six times to enter o. 4. Press 8 six timesto enter v. 5. Press 4 six timesto enter i. 6. Press 3 five times to enter e. 7.
ページ17に含まれる内容の要旨
Using Your Accessory Handset Making and Receiving Calls Using the Using the handset speakerphone Making a 1. Remove the handset 1. Remove the call fromthe charger. handsetfrom the charger. 2. Dialthe number. 2. Dialthe number. 3. Press /FLASH. 3. Press . Answering 1. Pick upthe handset. 1. Pick up the handset. a call (If AutoTalk is on, the (IfAutoT alk is on, phonewill answer thephone will when you remove answer when you thehandset
ページ18に含まれる内容の要旨
Adjusting the Volume Choosefrom three ringer volume settings (off, low, andhigh). With the phone in Ringer Volume standby, use and to adjustthe ringer volume. Choosefrom sixvolume levels for the handset. Whileon acall, press to make Earpiece Volume thehandset volume louderor to make itsofter . Choose fromsix volume levels forthe handset speakerphone.While ona call, Speaker Volume press to make the speakervolume louder or to
ページ19に含まれる内容の要旨
Press to open the Caller ID list. The first thing you will see isthe summary screen.F rom thesummary screen, you have the following options: To scrollthrough thelist from A to Z, press . Scrollthrough the list To scrollthrough the list from Z to A press . Jump toentries Press the numberkey corresponding beginningwith a to the letter you want tojump to. particular letter Store aCaller ID entry Findthe entry youwant to store
ページ20に含まれる内容の要旨
Using the Phonebook Your phoneallows you to store up to2 numbers per name and upto 100 names in your phonebook. Your phone shares a total of 100memory entries between your phonebookand CID. Once you store 100 phonebook entries,CID information will notbe stored andwill only display at time of newincoming calls. When Phonebook entries are full,you will hear a beepand MEMOR Y FULL appears. You cannotstore any additional names and numbersunless