ページ1に含まれる内容の要旨
AT&T
®
SPlRIT
Communications System
SPIRIT Attendant ConnecT/R
Owner’s Manual
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS ately. Do not plug the product back in until To reduce risk of injury from fire or electric it has been dried thoroughly. shock, always follow bask safety precautions when using this product. Install this product securely on a stable 5. The safety symbol (exclamation point surface. Damage may result if the product inside a triangle) on the Attendant falls. ConnecT/R alerts you to the Important operat- 6. Install this product in a protected location ing and maintena
ページ3に含まれる内容の要旨
to your business or home, consult your local manual. If you cannot resolve the problem, power company. or if the product is damaged, Call the AT&T Helpline at 1-800-628-2888. Do not open the 13. Use only a UL Listed wall plug-in power product. Opening the product may expose transformer that has Class 2 outputs and you to dangerous voltages or other risks. the following characteristics: 10. During thunderstorms, avoid using tele- Input rating: 99-127 V AC rms 60 Hz phones except cordless models.
ページ4に含まれる内容の要旨
Table of Contents Introduction 1 Installation 3 ® 4 Step 1— Mount the SPIRIT Attendant ConnecT/R Step 2—Connect the SPIRIT Attendant ConnecT/R 5 7 Step 3—Test the Equipment Troubleshooting 8 9 Appendix A—Wiring Requirements 10 Appendix B—Warranty While reasonable efforts were made to ensure that the information in this document was complete and accurate at the time of printing, AT&T assumes no responsibility for any errors. Changes or corrections to the information contained in this docum
ページ5に含まれる内容の要旨
Introduction ● The SPIRIT Attendant is a device which The following descriptions define important provides automated call-handling capabili- terms used in this manual. ties for the SPIRIT Communications System. ® The SPIRIT Communications System This Owner’s Manual will help you set up your Attendant ConnecT/R provides you with SPIRIT Attendant ConnecT/ R for your particu- the ability to add a SPIRIT Attendant to lar business needs. your SPIRIT System. It connects to the controller. The cont
ページ6に含まれる内容の要旨
2 Figure 2. SPIRIT Attendant ConnectT/R Applications
ページ7に含まれる内容の要旨
Installation 3. Never touch uninsulated telephone wires or INSTALLATION INSTRUCTIONS terminals unless the telephone line has been disconnected at the network interface. 1. Never install telephone wiring during a Iightning storm. 4. Use caution when installing or modifying telephone lines. 2. Never install telephone jacks in wet loca- tions unless the jack is specifically designed for wet locations. Directly connected by a cord from one unit to the other, or connected via a wiring run. Figure
ページ8に含まれる内容の要旨
4 Step 1 — Mount the SPIRIT Attendant ConnecT/R (optional). of the tab against the inside of one of the The SPIRIT Attendant ConnecT/R is designed feet. Repeat for the second tab. to be placed on your desk or mounted on any vertical surface. Do not place it on the floor. Hardware has been included to mount the SPIRIT Attendant ConnecT/R on the wall: two plastic wall-mount tabs, two anchors, and two #6 screws. 1. Select an appropriate location. The SPIRIT Attendant ConnecT/R can be no more than
ページ9に含まれる内容の要旨
studs or cross members), partially screw the Attendant to the SPIRIT Attendant two screws into the wall at the marks, ConnecT/R. remove them, hang the tabs on the screws, Please check the cabling requirements in Appen- and then tighten the screws. dix A before proceeding. Consult with the person who customized your SPIRIT System before attaching the SPIRIT Attendant ConnecT/R to the controller. NOTE: The "4-wire cord" mentioned in the steps below comes with the SPIRIT Atten- dant ConnecT/R. Any
ページ10に含まれる内容の要旨
6 3. Do not connect a SPIRIT Telephone to the 1. Connect the SPIRIT Attendant ConnecT/R SPIRIT Attendant ConnecT/R. to the Controller. Using 4-wire cord, plug one end into the CTRLR jack on the back of 4. Connect the SPIRIT Attendant ConnecT/R the SPIRIT Attendant ConnecT/R and to the AC power outlet. Plug the power connect the other end into the STATION jack connector into the POWER jack on the back on the controller. 2. Connect the SPIRIT Attendant to the SPIRIT Attendant ConnecT/R. Us
ページ11に含まれる内容の要旨
NOTE: Use only a UL Listed wall plug-in NOTE: If the caller requests the SPIRIT power transformer that has Class 2 Attendant to transfer a call to an extension number that is between the valid pro- outputs and the following characteristics: gramed lowest and highest extension but there is no station set plugged into that Input rating: 99-127 V AC rms 60 llz 150 mA maximum station port, the caller will be placed on hold and the SPIRIT Attendant will not bc 27-35 V DC at 200 mA able to retrieve t
ページ12に含まれる内容の要旨
8 Troubleshooting device operates. Call the AT&T Helpline at This section should help you determine the 1-800-628-2888 if you need assistance. cause of problems you might encounter and help you resolve them. Remember that the way your SPIRIT System was customized may influence how a particular What to Check Operational Difficulty Ringing Night Service customization* SPIRIT Attendant doesn’t respond to outside calls Do Not Disturb active Delayed Ringing active* Abbreviated Ringing active* No Rin
ページ13に含まれる内容の要旨
Appendix A — Wiring Requirements Note the following cabling requirements before 104386545). In addition, you will need a Building Entrance Protector, which can connecting the equipment. If these limits (which are the same ones that apply to our current house up to six 4C1S Block Protectors. Order Model 110ANA1-06 (comcode SPIRIT System) are exceeded, the SPIRIT 105736482). Contact your AT&T representa- Attendant ConnecT/R may not work properly. tive for additional information. ● The total w
ページ14に含まれる内容の要旨
Appendix B — Limited Product Warranty and Limitation of Liability AT&T warrants that the product will be free from ● Product abuse, misuse or the negligent acts of persons not under the reasonable control of defects in material and workmanship for one year from the date of purchase. If the product becomes AT&T. defective and such defect reported to AT&T EXCEPT AS SPECIFICALLY SET FORTH ABOVE, within the one-year warranty period, AT&T will AT&T, ITS AFFILIATES, SUPPLIERS AND DEAL- repair
ページ15に含まれる内容の要旨
Index AT&T Helpline 8 Controller 1 CTRLR jack 6 Installation 3 Connect the ConnecT/R 5 Connect the SPIRIT Attendant 6 Mount the ConnecT/R 4 Test the equipment 7 POWER jack 6 Power Transformer 6 Safety Instructions 3 SPIRIT Attendant 1 STATION jack 5 TEL DEVICE jack 6 Troubleshooting 8
ページ16に含まれる内容の要旨
FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio fre- quency energy and, if not installed and used in accordance with this Owner’s Manual, may cause harmful interfer- ence to radio communic
ページ17に含まれる内容の要旨
518-453-712
