ページ1に含まれる内容の要旨
USER’S MANUAL
Part 2
1
900 MHz Digital Spread
Spectrum Frequency Hopping
Cordless Telephone 9410
Fold open this manual for information about this
telephone’s installation and operation. Please
also read Part 1 — Important Product Information.
AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in Mexico. 850002403 Issue 1AT&T 5/00
ページ2に含まれる内容の要旨
INSTALLATION Table/Desk Installation Wall Installation Standard Modular electrical telephone Modular outlet jack telephone Short telephone jack line cord Strain-relief groove Power cord Long telephone line cord Power cord The instructions below are for both table and wall base. Slide the base down onto the knobs until it locks installation. into place. 6 Charge the handset battery. 1 Choose a spot near an electrical outlet and a Place the handset face up or face down in the base. telephone jack.
ページ3に含まれる内容の要旨
TELEPHONE MEMORY The phone numbers you store in memory are saved when Dialing Memory Numbers you change the handset battery, or in the event of a power 1 Press P. failure. This cordless phone can store 20 telephone 2 Press m. numbers that you can dial just by pressing m and a 3 Enter the memory location (01–20) of the number number button. you’re calling. Storing Memory Numbers Erasing Memory Numbers 1 Make sure the PHONE light is off. 1 Make sure the PHONE light is off. 2 Press and release G. T
ページ4に含まれる内容の要旨
TELEPHONE OPERATION Allows you to hear caller, but caller can’t Make, answer hear you or end a call Access subscriber Headset jack services Access numbers in Light goes on when Redial last telephone memory handset is in use number called Light goes on when handset is charging in base Temporary Tone Send paging tone to handset Store numbers in Adjust handset telephone memory volume Turn Handset Ringer on or off Making a Call Redial The last number dialed on this phone (up to 24 digits) is 1 Pres
ページ5に含まれる内容の要旨
TELEPHONE OPERATION Handset Ringer Selection Page You can select from four different handset ringer styles. The Page feature allows you to signal someone at the You can also turn the Ringer off. handset from the base. • Make sure the HANDSET IN USE light is not lit on the 1 Make sure the PHONE light is off. base. 2 Press G, . • Press G on the base. A three-part paging 3 Press 1,2,3 or 4 to select your ringer style. You will tone will sound at the handset. hear a sample of the ringer style. 4 Pre
ページ6に含まれる内容の要旨
BATTERIES Nickel-Cadmium Rechargeable Batteries Charging the Handset Battery Pack must be recycled or disposed of properly. Do This battery should remain charged up to three days with not dispose of in household garbage. If the Ringer turned on and up to 20 days with the Ringer off. burned, it could explode. If punctured, it A fully charged battery provides an average talk time of up could release caustic material which could to five hours. injure the skin or eyes. If swallowed, it may be The ba
ページ7に含まれる内容の要旨
OPERATING RANGE This cordless telephone operates within the maximum If you move out of range during a phone power allowed by the Federal Communications conversation, you might hear noise or interference. Commission (FCC). Even so, this handset and base can To improve reception, move closer to the base. If you communicate over only a certain distance — which can do not return to the range of the base unit, the call may vary with the locations of the base and handset, the be dropped. weather, an
ページ8に含まれる内容の要旨
IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the If you hear “popping” or “clicking” when using suggestions below. If you still have trouble, call the phone: 1 800 222–3111, or visit our website at • Make sure the base antenna is fully upright. www.telephones.att.com. Please retain your receipt as your • You may be out of range. Move closer to the base. proof of purchase. • Household appliances plugged into the same circuit as the base can sometimes cause interference
