ページ1に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page ii
USER’S MANUAL
Part 2
900 MHz Cordless Telephone
with Caller ID/Call Waiting 9345
Please also read
Part 1 — Important
Product Information
AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
ページ2に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page iii © 2001 Advanced American Telephones. All rights reserved. Printed in China. Issue 1AT&T 06/01
ページ3に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page iv CONTENTS BEFORE YOU BEGIN . . . . . . . . . . . . . .1 TELEPHONE MEMORY . . . . . . . . .10 About Caller Identification .......... 1 Store Memory Numbers.............. 10 Edit Numbers Stored INSTALLATION . . . . . . . . . . . . . . . . . . . . . . .2 in Memory ............................... 11 Before You Install .......................... 2 Delete Numbers Stored Table/Desk Installation ................. 3 in Memory ............................... 12 W
ページ4に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page 1 BEFORE YOU BEGIN About Caller Identification (Caller ID) This product has a Caller ID with Call Waiting feature that works with service from your local phone service provider. Caller ID with Call Waiting lets you see who’s calling before you answer the phone, even when you’re on another call. You may need to change your phone service to use this feature. Contact your phone service provider if: • You have both Caller ID and Call Waiting, but as separate se
ページ5に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page 2 INSTALLATION Before You Install 1 Choose a location for the base near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch. 2 Install the handset battery. a) Remove battery compartment cover by pressing on the indentation and sliding downward. b) Align two holes in plug with socket pins, and snap the plug into place. c) Place battery pack in co
ページ6に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page 3 INSTALLATION 3 Attach belt clip to the cordless handset (optional). To attach To remove Table/Desk Installation Standard Modular electrical outlet telephone jack 1 Connect the telephone line cord. 2 Connect the power cord. 3
ページ7に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page 4 INSTALLATION 3 Charge the handset battery. Place the handset in the base. Charge the battery for at least 16 hours the first time. 4 Check for dial tone. After the batteries are charged, pick up the handset and press P; you should hear a dial tone. 5 Set the dial mode. If you have touch tone service, the phone is ready to use as soon as the batteries are charged. If you have dial pulse (rotary) service, you’ll need to change the dial mode. • Press G on t
ページ8に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:33 AM Page 5 INSTALLATION Wall Installation 1 Connect the telephone line cord. 2 Connect the power cord. 3 Mount the base on the wall. Standard electrical outlet a) Align holes on base with mounting studs on wall jack. Modular telephone jack b) Pull base down on mounting studs until it locks into place. 4 Follow Steps 3–5 in Table/Desk Installation. 5
ページ9に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 6 TELEPHONE OPERA HEADLINE LEFT TION HEADLINE L-SUB Answer a Call Press any key exceptO. Flash/ Call Waiting Access special telephone company subscriber services. Handset Volume While on a call, adjust volume of what you hear. Make a Call End a Call Press P, then Press O dial the number — OR — — OR — Place handset Dial the number (use in base. < to backspace and Exit correct digits), then programming. press P to call. Cancel a page. Hold Redial Press P,th
ページ10に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 7 TELEPHONE OPERATION If you subscribe to telephone company voice mail with a visual message waiting signal, light flashes when you have voice mail waiting. Flashes when you have unreviewed call information. On steadily when handset is in use or is charging in base. Page/Handset Locator Press to page the handset for up to 90 seconds. Press again to cancel, or press O on handset. 7
ページ11に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 8 TELEPHONE OPERATION Handset Ringer Style/Battery Save You can select from four different handset ringer styles, or turn the ringer off and extend the battery life. 1 Make sure the handset is off. 2 Press G to enter programming mode. 3 Press > until the screen displays RINGER:. 4 Press s. The screen displays the current setting. 5 Press > to select 1, 2, 3, 4,or OFF. You will hear a sample of each ring. 6 Press s to choose the displayed ringer setting. Te
ページ12に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 9 TELEPHONE OPERATION Operating Range This cordless telephone operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so, this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office. For best performance, keep the base antenna fully upright. If you receive a call while you are out of range, the h
ページ13に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 10 TELEPHONE MEMORY This cordless phone can store 20 telephone numbers with names, each up to 16 digits long. Entries are stored alphabetically. For consistency with Caller ID entries, you may wish to enter last names first. Note: Press O at any time to exit memory. Store Memory Numbers 1 Press G. The screen displays DIRECTORY. 2 Press s. The screen displays ENTER NAME. 3 Using the chart below, enter up to 16 characters for the name you’re storing with the
ページ14に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 11 TELEPHONE MEMORY 4 When you finish entering the name, press s. The screen displays ENTER NUMBER. 5 Enter the telephone number. Use < to backspace and make a correction. Press r to store a pause in the dialing sequence. 6 Press s to store your entry. The screen displays SAVING… and you’ll hear a series of beeps confirming the entry. Note: When memory is full the screen displays MEMORY FULL, an error tone sounds, and you will not be able to store a new nu
ページ15に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 12 TELEPHONE MEMORY Delete Numbers Stored in Memory 1 Press > (DIR). The screen displays DIRECTORY. 2 Press < or > to scroll alphabetically through numbers stored in memory —OR— Press the dial pad key for the first letter of the entry you want to delete. 3 When the screen displays the number you want to delete, press s. Then press < or > until ERASE flashes. DIAL EDIT EERRAASSEE 973-555-0123 5/01 5:40PM OLD28 4 Press s. The screen displays ERASE NO YES a
ページ16に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 13 CALLER ID OPERATION Indicates repeat call Caller’s name Caller’s telephone number Position of call Date of call Time of call in call history About Call History This phone assigns each incoming call a number from 1 to 50. The most recent call will have the highest number. When the memory is full, the oldest call information is deleted to make room for new incoming call information. For each call that comes in, the screen displays the following informatio
ページ17に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 14 CALLER ID OPERATION Delete Records from Call History Delete a Specific Call 1 Locate the record you want to delete from call history. 2 Press s, then press < or > until ERASE flashes. DIAL PGM EERRAASSEE 973-555-0123 5/01 5:40PM OLD28 3 Press s. The screen displays ERASE NO YES ALL and the phone number. The current choice flashes. 4 Press < or > until YES flashes. 5 Press s. You’ll hear a series of beeps confirming the deletion. Delete All Calls 1 Whil
ページ18に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 15 CALLER ID OPERATION Store a Call History Record in Memory 1 Locate the record in call history you want to store in memory. 2 Press s, then press < or > until PGM flashes. DIAL PPGGMM ERASE 973-555-0123 5/01 5:40PM OLD28 The phone number will be displayed in the format it was received. 3 If you wish to change how the number is stored, press #. The screen displays any alternate dialing sequences available for this call (area code + number; 1 + area code
ページ19に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 16 CALLER ID OPERATION Display Screen Messages Screen Displays: When: PRIVATE NAME The other party is blocking name information. PPP The other party is blocking number information. PRIVATE CALLER The other party is blocking name and number information. UNKNOWN NAME Your phone company is unable to receive information about this caller’s name. UUU Your phone company is unable to receive information about this caller’s number. UNKNOWN CALLER Your phone compa
ページ20に含まれる内容の要旨
9345_book_1ATT 6/5/01 11:34 AM Page 17 BATTERIES Charging the Handset Battery Pack This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about five hours. The battery pack needs charging when: • A new battery is installed in the handset. • The phone beeps twice every 16 seconds. • The screen displays LOW BATTERY and the low battery icon. Place the handset in the base so the C
