ページ1に含まれる内容の要旨
CONTENTS
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Battery Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Included with the DXI665 . . . . . . . . . . . . .
ページ2に含まれる内容の要旨
Programming the DXI665 Handset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Storing a Caller ID memory number in Dial Memory . . . . . . . . . . . . . . . . 36 Entering a Number in Dial Memory. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Calling a Number Stored in Memory. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Editing and Deleting Numbers in Dial Memory . . . . . . . . . . . . . . . . . . . . . 38 Using the DXI665 Base Unit . . . . . . .
ページ3に含まれる内容の要旨
Important Safety Instructions When using your telephone equipment, these basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning, and use a dry cloth, without liquid or aerosol cleaners. 4. Do not use this product near water; for example, near a bath tub, wash bowl, kitch
ページ4に含まれる内容の要旨
12. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: A. When the power supply cord is damaged or frayed. B. If liquid has been spilled into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally when following the operating instructions. (Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in dama
ページ5に含まれる内容の要旨
PRIVACY Note: Cordless telephones are radio devices. Communications between the handset and base of your cordless telephone are accompanied by means of radio waves which are broadcast over the open airways. Because of the inherent physical properties of radio waves, your communications ca be received by radio devices other than your own cordless telephone unit. Consequently, any communications using your cordless telephone nay not be private. SAVE THESE INSTRUCTIONS 5
ページ6に含まれる内容の要旨
Introduction Congratulations on your purchase of the Uniden DXI665 Cordless Telephone. It is designed to exacting standards which provide reliability, long life, and outstanding performance. Features • 25 46/49 MHz Channels • Dual Keypad for added flexibility • Voice Scramble • 30 Number Caller ID Memory • Caller ID* • Pulse/Tone Dialing • Digital Security • Redial and Flash Keys • UltraClear Plus • Ringer/Volume Controls • Random Code™ • 30-Number Memory (20-Handset,10-Base) • AutoTalk™ • 1-way
ページ7に含まれる内容の要旨
Now is the time for all good men to come to the aid of the Now is the time for party. all good Four men score to yeas ago come to the aid of our the fathers party. Four set forth a new score yeas ago nation our fathers conceived set in Liberty forth a new nation and conceived dedicated in to the Liberty and dedicated proposition to that the all men proposition that are created equal. The quick all men are created equal.brown The quick foxbrown jumped fox over the jumped over the garden garde
ページ8に含まれる内容の要旨
Important Electrical Considerations Unplug all electrical appliances when you know an electrical storm is approaching. Lightning can pass through your household wiring and damage any device connected to it. This phone is no exception. Warning: Please do not attempt to unplug any appliance during an electrical storm. Caution: Changes or modifications to this product not expressly approved by Uniden, or operation of this product in any way other than as detailed by this Operating Guide, could void
ページ9に含まれる内容の要旨
Radio Interference Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking noises in the Base Unit. This interference is caused by external sources such as TV, refrigerator, vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises continue and are too distracting, please check around your home to see what appliances may be causing the problem. In addition, we recommend that the Base not be plugged into a ci
ページ10に含まれる内容の要旨
Installation Selecting a Location Before choosing a location for your new phone, there are some important guidelines you should consider: • The location should be close to both a phone jack and continuous power outlet. Note: A continuous power outlet is an AC outlet which does not have a switch to interrupt its power. • Keep the Base Unit and Handset away from sources of electrical noise such as motors or fluorescent lighting. • Be sure there is sufficient space to fully extend the Base Unit ant
ページ11に含まれる内容の要旨
+ – – + RING VOL PULSE-TONE DC IN 9V TEL LINE OFF-LO-HI Connecting the Telephone Cords Consider these safety guidelines before connecting the telephone cords: CAUTION: • Never install telephone wiring during a lightning storm. • Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected. • Use caution when installing or modifying telephone lines. Applying Power to the Base Unit The DXI665 phone requires an AC outlet, without a switch to interrupt power,
ページ12に含まれる内容の要旨
+ – + – RING VOL PULSE-TONE DC IN 9V TEL LINE OFF-LO-HI Desk or Tabletop Installation 1. Place the Base on a desk or tabletop. 2. Plug one end of the long telephone cord into the TEL LINE jack on the Base RING VOL PULSE-TONE DC IN 9V Unit. TEL LINE OFF-LO-HI 3. Plug the AC Adapter cord into the 9V DC input jack on the Base Unit. RING VOL PULSE-TONE DC IN 9V OFF-LO-HI TEL LINE 4. Place the AC Adapter cord around the strain relief. 5. Plug the other end of the telephone cord into the telephone jac
ページ13に含まれる内容の要旨
6. Plug the AC Adapter into a standard 120V AC wall outlet. Note: Do not use an outlet controlled by a wall switch. Use only the Uniden AC Adapter supplied with this phone. Wall Installation Standard Wall Plate Mounting These phones are designed to be mounted on a standard AT&T or GTE wall plate. 1. Plug the AC Adapter into the Base Unit. RING VOL PULSE-TONE DC IN 9V TEL LINE OFF-LO-HI 2. Place the AC Adapter cord inside the molded channel. Place the telephone cord inside the molded channel on t
ページ14に含まれる内容の要旨
3. Place the Base Unit on the posts of the wall plate and push down until it’s firmly seated. 4. Plug the AC Adapter into a standard 120V AC wall outlet. Note: Do not use an outlet controlled by a wall switch. 5. Plug one end of the short telephone cord into the TEL LINE jack on the Base RING VOL PULSE-TONE DC IN 9V Unit. TEL LINE OFF-LO-HI Note: Charge the Handset for 15-20 hours without interruption before plugging the phone line into your new phone. See page 24, Initial Battery Charging. Dire
ページ15に含まれる内容の要旨
1. Insert two mounting 3/16 IN. 15 ⁄ screws 3 16 inches 3 apart. Allow about ⁄ of 16 an inch between the wall and screw heads for mounting the phone. 3 15/16 IN. 2. Plug one end of the long telephone cord into the TEL LINE jack on the Base Unit. RING VOL PULSE-TONE DC IN 9V TEL LINE OFF-LO-HI 3. Place the cord inside the RING VOL PULSE-TONE DC IN 9V OFF-LO-HI + - TEL LINE molded channel on the bottom of the Base Unit. 4. Plug the AC Adapter into the Base Unit. RING VOL PULSE-TONE DC IN 9V TEL LI
ページ16に含まれる内容の要旨
5. Place the AC Adapter RING VOL PULSE-TONE DC IN 9V OFF-LO-HI + - TEL LINE cord inside the molded channel. 6. Place the Base Unit on the screws and push down until it’s firmly seated. 7. Plug the other end of the telephone line cord into the wall jack. Note: Charge the Handset for 15-20 hours without interruption before plugging the phone line into your new phone. See page 22, Initial Battery Charging. 8. Plug the AC Adapter into a standard 120V AC wall outlet. Note: Do not use an outlet contro
ページ17に含まれる内容の要旨
Setting the Handset Retainer The handset retainer holds the Handset in place if your phone is mounted on a wall. The steps below describe how to remove and replace the retainer so that the tab faces up. 1. Push up on the Handset retainer on the Base Unit, and slide the tab out. 25 CHANNEL 2. Flip the retainer over so the tab faces up. 25 CHANNEL 3. Put the retainer back into its slot on the Base Unit. 25 CHANNEL 4. Push down on the Handset retainer until it snaps into place. 25 CHANNEL 17
ページ18に含まれる内容の要旨
SettingUpYourPhone Extending the Base Unit Antenna Before using your phone, be sure to raise the antenna to the vertical position. volume Installing the Handset Battery Pack 1. Press in on the Battery Cover Release. 18
ページ19に含まれる内容の要旨
2. Slide the battery compartment cover down. 3. Align the plastic connector of the Nickel-Cadmium battery pack with its socket and plug it in. Note: The black lead will be on the left when the plug is properly aligned. 4. Place the battery pack inside the battery compartment, and slide the battery cover back on. ❉ The built-in Memory Backup feature allows up to 3 minutes to disconnect the old battery pack and install a new one without losing any numbers stored in memory. 19
ページ20に含まれる内容の要旨
Cleaning the Battery Contacts To maintain a good charge, it is important to clean all charging contacts on the Handset and Base Unit about once a month. Use a pencil eraser or other contact cleaner. Do not use any liquids or solvents. 25 CHANNEL ULTRACLEAR PLUS speaker abc def 1 2 3 ghi jkl mno 4 5 6 pqrs tuv wxyz 7 8 9 tone oper 0 # mem pause redial flash page/find mute Extend"" APhone Contacts Contacts 20