ページ1に含まれる内容の要旨
OWNER'S MANUAL
5.8 GHz Cordless Telephone
Caller ID with Call Waiting
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
Model : STC595
ページ2に含まれる内容の要旨
Contents Safety Instructions ...................................................................................................3 HANDSET CONTROLS ..........................................................................................5 BASE UNIT Controls ...............................................................................................8 Getting Started .........................................................................................................9 Belt Clip I
ページ3に含まれる内容の要旨
Contents Outgoing Calls .........................................................................................22 Function Settings ..................................................................................................23 A. Setting the Ringer Level ..........................................................................24 B. Changing the Language ..........................................................................24 C. Turning the First Ring ON or OFF ...........
ページ4に含まれる内容の要旨
Safety Instructions IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electric shock and/or injury, always follow these basic safety precautions when using your cordless telephone equipment. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephone. 3. Do not use this telephone near a bathtub, wash bowl, kitchen sink, or laundry tub, in a Wet basement, near a swimming pool, or anywhere else where there is water. 4. Avoid using
ページ5に含まれる内容の要旨
Safety Instructions D. If the telephone does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment may require extensive work by a qualified technician to restore the telephone to normal operation. E. If the telephone has been dropped or the case has been damaged. F. If the telephone exhibits a distinct change in performance. 16. Never install telephone wiring during a lightning st
ページ6に含まれる内容の要旨
HANDSET Controls 5
ページ7に含まれる内容の要旨
HANDSET Controls 1. OGCall (Outgoing call) button ( ): Press and to view the last outgoing call number(see page 22 for detail) 2. Voice Mail/Menu (Manual) Button: (Voice Mail) Press to automatically dial the Voice Mail Post Code in your area to access your Voice Mail message. (Menu)Press to access the special functions operation in STANDBY mode. (For special functions see pages 23~28. ) 3. Scan/Del (Delete) Button: (Scan) Press to change the operating channel when you hear interfere
ページ8に含まれる内容の要旨
15. Option (#) Button: (Option) Press to change the displayed telephone number into 7, 10, or 11 digit DIALING mode during Caller ID callback. 16. Microphone: 17. CHARGE CONTACTS: For charging the BATTERY PACK inside the HANDSET. We recommend cleaning the CHARGE CONTACTS periodically with a damp cloth. 7
ページ9に含まれる内容の要旨
BASE UNIT Controls 1. POWER-IN CONNECTION JACK 2. TELEPHONE LINE CONNECTION JACK 3. BASE UNIT ANTENNA 4. PAGE Button: Press to page the HANDSETS. 5. CHARGE TERMINALS: For charging the HANDSET BATTERY PACK. For best performance, clean the CHARGE TERMINALS periodically with a damp cloth. 6. TONE/PULSE Select Switch 7. IN USE/CHARGE LED Indicator: (IN USE) Lights up to indicate that the HANDSET is in TALK mode. (CHARGE) Lights up when the HANDSET is placed on the BASE UNIT for charg
ページ10に含まれる内容の要旨
Getting Started Connecting Your Phone This section is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this telephone, refer to the Contents on page 1. 1. Carefully remove your cordless telephone from its shipping carton. If there is any visible damage, do not attempt to operate this equipment. Return it to the place of purchase. 2. Check to be sure you have all items that come with
ページ11に含まれる内容の要旨
Getting Started 7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARTMENT. 8. Place the BATTERY PACK inside the BATTERY COMPARTMENT. 9. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position. 10. IMPORTANT: Before initial use, charges the HANDSET for 12 hours. Place the HANDSET on the BASE UNIT or CHARGER UNIT with TELEPHONE KEYPAD face up, and make sure that the CHARGER UNIT LED indicator lights
ページ12に含まれる内容の要旨
Cordless Telephone Operation Preparing for Use Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require recharging of the BATTERY PACK more often. 1. Place the HANDSET on the BASE UNIT/CHARGER UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT/CHARGER UNIT. Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require more frequent charging of the
ページ13に含まれる内容の要旨
Cordless Telephone Operation Placing Calls 1. Press the Talk button, the Call Timer starts to count. 2. Wait until you hear a dial tone and then TA TAL LK K dial the phone number. 3. When you have finished your call, press m miin n s se ec c the Talk button again or place the 01 01 45 45 HANDSET on the BASE UNIT. OR 1. Dial the phone number. 2. Press the Talk button. The number DI DI DIA A AL L L? ? ? displayed will be dialed. 3. When you have finished
ページ14に含まれる内容の要旨
Cordless Telephone Operation HANDSET Volume Control 1. To adjust the HANDSET receiver volume level while having a conversation, press the VO VO VOLU LU LUM M ME E E Vol(Volume) button ( ) button. The LCD Screen will display “VOLUME” m m miiin n n se se sec c c 01 01 01 45 45 45 2. Press the SCROLL UP or DOWN button to select the desired setting of Low, Medium, High or Maximum. VO VO VOLU LU LUM M ME E E 3. After volume setting, press vol (
ページ15に含まれる内容の要旨
Caller ID System Operation Caller ID System This telephone automatically displays an incoming caller’s name and telephone number together with the date and time of the call. It records up to 50 calls and stores the data in Memory. IMPORTANT: You must subscribe to the Caller ID service from your local telephone company to utilize this feature. Viewing Caller Information During Incoming Calls 1. When there is an incoming call, the name and the telephone number of the caller will aut
ページ16に含まれる内容の要旨
Caller ID System Operation Caller ID with Call Waiting When you subscribe to Call Waiting service from your local telephone company, this telephone will display the name and number of the second caller while you are having a phone conversation with the first caller. First When a new call comes in while you are talking, you will Caller hear a notification beep from the HANDSET and the volume is momentarily muted. The new caller’s name and phone number, if available, appears on t
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
Caller ID System Operation Storing Caller ID Records into the DIRECTORY (PHONE BOOK) 1. Press the SCROLL UP or DOWN button to find the record you wish to store into the DIRECTORY (PHONE BOOK). 2. Press and hold the Re/Pa/Save button. 3. The display will show “SAVED.” SA SAVE VED D 4. If you wish to edit the newly stored number, you can edit it in the DIRECTORY (PHONE BOOK), or press Flash/Edit button to edit it (page 20, “Editing a Stored Number”), and press and hold the Re/Pa/S
ページ19に含まれる内容の要旨
Caller ID System Operation Name and Telephone Number DIRECTORY (PHONE BOOK) This DIRECTORY (PHONE BOOK) lets you scroll through the list to find the person you need for one touch dialing. You can store up to 40 names and telephone numbers in the Memory. Viewing the DIRECTORY (PHONE BOOK) 1. Press the Dir/Esc button. 2. Press the TELEPHONE KEYPAD 2 /ABC to 9 /WXYZ button that corresponds to the first letter of a Caller’s name (a triple “beep” will sound if no entries are stored under
ページ20に含まれる内容の要旨
Caller ID System Operation Telephone Keypad Characters The TELEPHONE KEYPAD buttons are used to enter characters when entering names and numbers. Press the appropriate TELEPHONE KEYPAD button to get the following characters. You can store a maximum of 18 characters on the letter icon and a maximum of 22 digits on the number icon. Keypad 1st 2nd 3rd 4th 5th 6th 7th 8th 9th Buttons Press Press Press Press Press Press Press Press Press 1 Space 1 & ‘ ( ) . Space1 2 A B C a b c 2 A B
