ページ1に含まれる内容の要旨
s
Hicom cordless E
Gigaset 3000 Comfort
Operating instructions
Warning
Please read the safety
notes on page 2
before putting the
equipment into
service.
ページ2に含まれる内容の要旨
General Safety notes Notes on handset use ● Do not use the handset in environments where there is danger of explosion (for example, a paint shop). ● Research has shown that electronic devices such as medical equipment can be affected by the handset. Local safety regulations must therefore be observed. ● The handset is not suitable for people with hearing aids since radio signal interference produces a very unpleasant humming sound if the volume is turned up too high. ● Do not use handset
ページ3に含まれる内容の要旨
General Operating elements, unit parts 1 12 2 3 13 4 5 6 7 8 14 9 10 11 1 Receiver inset 8 Talk key 2 Display (illuminated) 9 Keypad lock 3 Display keys 10 Recall key 4 Menu key 11 Microphone 5 On-hook key 12 Attachment clip 6 Telephone directory key 13 Ringer loudspeaker 7 Talk key 14 Battery compartment/ lid Fig 1 Operating elements, unit parts 3
ページ4に含まれる内容の要旨
Contents General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Operating elements, unit parts . . . . . . . . . . . . . . . . . . . . . 3 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Notes on these operating instructions. . . . . . . . . . . . . . . . 7 Featur
ページ5に含まれる内容の要旨
Contents Disabling number redial . . . . . . . . . . . . . . . . . . . . . . . . . 34 Entering text. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Overview – key layout . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Entering letters/characters and digits . . . . . . . . . . . . . . . 35 Telephone directory . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Overview – telephone directory menu. . . . . . . . . . . . . . . 37 Storing numbers (directory/network pre
ページ6に含まれる内容の要旨
Contents Consultation during a call . . . . . . . . . . . . . . . . . . . . . . . . 73 Toggle – Switching between two users . . . . . . . . . . . . . . 74 Conference . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Appendix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77 Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77 Approval . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78 Technical d
ページ7に含まれる内容の要旨
Introduction Notes on these operating instructions These operating instructions describe the Gigaset 3000 Comfort handset in connection with Hicom cordless E at Hicom 300/300 E/300 H. All functions that can be performed via your handset are described. You may discover that certain handset functions are not available as required. The reasons for this may be as follows: ● The function is not configured for you and your handset. In this case, please consult your system administrator. ● Your H
ページ8に含まれる内容の要旨
Introduction ● Each handset can log onto and be used by up to 4DECT systems. Features of the Hicom cordless E ● Internal and external calls in the entire Hicom cordless E radio network ● The user can roam throughout the entire radio network and still receive all internal and external calls at one call number (roaming). ● Automatic call transfer from base station to base station when moving in the radio network (handover). ● Automatic callback for internal calls ● Call forwarding to interna
ページ9に含まれる内容の要旨
Introduction General operating instructions ● The devices offer a high level of privacy. No protection can be guaranteed against illegal bugging using other radio receivers. ● When operating the handset, a basic distinction is made between: – telephone/switching functions, e.g. when a call is in progress – local functions, e.g. the display when the handset is on. ● Local functions can also be performed in the charging shell. ● Local functions can be cancelled with the on-hook key Ábefore
ページ10に含まれる内容の要旨
Introduction Radiorange ● Depending on the environment, the range in the open is up to 300 m per base station. ● In buildings, the range extends up to 50 m per base sta- tion (depending on the room and building layout and con- struction). ● If you leave the radio range of the system’s base stations during a call, the quality of the voice connection drops, particularly if you move. For a better voice connection, move back into the base station range. ● The radio connection is lost if you exce
ページ11に含まれる内容の要旨
Preparing the handset Inserting the batteries into the handset Note: ● Please read the safety notes first, see page 2. ● Only use supplied or approved batteries. Do not use normal (non-rechargeable) batteries, see page 13. ● Always change the batteries at the same time and only insert batteries of the same type and produced by the same manufacturer. ● Hold the handset with the dialling keypad facing down- wards, see Fig 2. A battery compartment for 2 batteries is located in the lower part of
ページ12に含まれる内容の要旨
Preparing the handset Charging and using the batteries The batteries supplied (NiCd) are not charged. To charge the batteries, insert the handset into the Gigaset 3000L charging shell with the display facing upwards. The battery symbol on the handset display indicates the charging status: Batteries empty. E Batteries 33% charged. 8 Batteries 66% charged. 7 Batteries 100% charged. Note: ● New batteries should be initially charged for a mini- mum period of 16 hours without interruption, irre-
ページ13に含まれる内容の要旨
Preparing the handset Battery life: These times are only achieved after several charging and discharging cycles. Type Standby mode When phone in (hours) use (hours) NiCd, 700 mAh up to 100 up to 10 NiMH, 1100 mAh up to 160 up to 15 NiMH, 1500 mAh up to 220 up to 20 Approved batteries: Nickel cadmium (NiCd) Nickel metal hydrid (NiMH) Sanyo N-3U (700 mAh) Sanyo H-3 U (1500 mAh) GP GP60AAKC (600 mAh) GP GP130 AA HC (1300 mAh) Varta 751RS (700 mAh) GP GP150 AA HC (1500 mAh) Varta VH 1101 (1100 m
ページ14に含まれる内容の要旨
Preparing the handset Fitting the attachment clip You can fit the supplied attachment clip to your handset if required. Place the attachment clip on the back of the handset. There are holes on the sides of the handset approximately level with the display. Press the clip towards the handset until the clip’s side tabs click into place in the handset holes. Fig 3 Fitting the attachment clip 14
ページ15に含まれる内容の要旨
Preparing the handset Activating/deactivating handsets Note: The language set at the factory is English. For informa- tion on changing the language to German or another lan- guage, refer to page 52. ● Off status: Display blank – calls cannot be received. ● On status e.g. -! is displayed. Prerequisite for all telephone functions: normal operating status. Activating the handset: Á Press the on-hook key and hold it down for one second. You will hear the * confirmation beep. Display when the
ページ16に含まれる内容の要旨
Preparing the handset Activating/deactivating the keypad lock This allows you to protect your handset against inadvertent key activation , e.g. when carrying it in your bag. Calls are signalled even if the keypad is locked and can be answered in the same way as when the telephone is on. Prerequisite: handset is activated. Activating the keypad lock: j Press the keypad lock and hold it down for one second. Display in keypad lock status. 9!2 '* &! Deactivating the keypad lock: j Press Key
ページ17に含まれる内容の要旨
Display Explanation The handset features a 4-line display with 16 characters per line. Depending on the situation, the display shows: ● digits, e.g. dialled numbers ● text, e.g. the current base (system) ● symbols, e.g. ringing or battery symbol ● and in the last line the current functions of the two dis- play keys. Display when the handset is on or in message status (example) Receive intensity Charge status (100%) Current base display 7 -! Current functions of the display keys: Network p
ページ18に含まれる内容の要旨
Display Keys The two display keys are located directly under the display. The current functions of the display keys are status-depend- ent and are displayed in the lower display line. Each display key can be used to display one or two functions. In the case of two functions, you must press either on the left or the right side of the corresponding display key. Meaning of the displays keys: M Call up network prefix , Call up Message Waiting Indication + Call up SLC menu [ Number redial ;< Se
ページ19に含まれる内容の要旨
Display Function selection using menus (handset functions) On status \ Main menu \ ?! )#- -!- ; Submenu 6-!A-!, *) 9 >**(4*) *,?! - - - - - - - - ?*.) ?! )#- < ?!,/ ! ?! ., 2 ; RRRRRRRR .*@ '& : )#. #! < !" .'>!-! RRRRRRRR Menu key to open the main menu (handset function). \ Display key to: – jump back to the next menu level up – cancel a function ;< Display keys for scrolling forward/ backward within the individual menus. = Display key for confirmi
ページ20に含まれる内容の要旨
Display Function selection using display keys (when a call is in progress, service menu) When a call is in progress, the display keys ; and < can be used to call up different functions, e.g.: 4A@; ;?A:@ ?@>@;N ?@>@@>;?> For example, youcan use the display keys ; and < to scroll to the next function when a call is in progress. If the required function is displayed, simply press the display key = and follow the instructions. The other user is unaware that you are scrolling with
